Assessment of Physicochemical and Bacteriological Quality of Different Surface Water Samples of Tangail District, Bangladesh

A study was carried out with 25 pond water samples of Bhola Sadar Upazila to assess the quality of surface water for irrigation, aquaculture, drinking and livestock consumption. Chemical analyses of different parameters were done to assess the quality of water. All of the water samples showed slightly acidic in nature. Sixteen surface water samples were not suitable for drinking and aquaculture in respect of pH (pH <6.5). Electrical conductivity (EC) categorized the waters as low salinity (C1) to medium salinity (C2) class for irrigation. With respect to total dissolved solids surface waters were within highest desirable limit for drinking and irrigation and suitable for livestock consumption and aquaculture. Calcium and Magnesium content rated the samples as maximum permissible and highest desirable limit for drinking. All the samples were suitable for drinking in case of Na and K, 21 samples were not suitable for aquaculture due to higher (>5.0 mg L-1) K content. Six samples were unsuitable for livestock due to higher (Cl >30mgL- 1) Cl values. SSP rated 9 samples as good, 1 as excellent, 6 as doubtful and 9 as permissible for irrigation. With respect to RSC 21 samples were suitable, 3 were marginal and 1 was unsuitable for irrigation. Hardness classified 14 samples within moderately hard, 10 within soft and only one as hard limit for irrigation and 1 sample (No. 16) was unsuitable for livestock consumption. P, B, Cu and As concentration categorized all the samples suitable for irrigation, aquaculture, drinking and livestock consumption.DOI: http://dx.doi.org/10.3329/jesnr.v6i1.22053 J. Environ. Sci. & Natural Resources, 6(1): 131-140 2013

Download Full-text

Analysis of Indus Delta Groundwater and Surface water Suitability for Domestic and Irrigation Purposes

Civil Engineering Journal ◽

10.28991/cej-2019-03091356 ◽

2019 ◽

Vol 5 (7) ◽

pp. 1599-1608 ◽

Cited By ~ 16

Author(s):

Ghulam Shabir Solangi ◽

Altaf Ali Siyal ◽

Pirah Siyal

Keyword(s):

Surface Water ◽

Surface Waters ◽

Water Samples ◽

Total Dissolved Solids ◽

Quality Parameters ◽

Gis Mapping ◽

Quality Of Water ◽

Indus Delta ◽

Surface Water Samples

The present study was conducted to analyze the suitability of groundwater and surface water of the Indus Delta, Pakistan for domestic and irrigation purposes based on the concentrations of arsenic (As), total dissolved solids (TDS), and chloride (Cl). Around 180 georeferenced groundwater and 50 surface water samples randomly collected were analyzed and mapped spatially using ArcGIS 10.5 software. The results were compared with their respective WHO and FAO guidelines. The analysis revealed that as in groundwater and surface water samples ranged up to 200, and 25 µg/L respectively. Similarly, the TDS in the groundwater and surface water ranged from 203 to 17, 664 mg/L and 378 to 38,272 mg/L respectively. The Cl in groundwater and surface water varied between 131 and 6,275 mg/L and 440 to 17,406 mg/L respectively. Overall, about 18%, 87% and 94% of the groundwater, and 10%, 92% and 56% of the surface waters possessed higher concentrations of As, TDS, and Cl, respectively. The higher levels of Cl in the samples are attributed to subsurface seawater intrusion in the delta. Analysis results and GIS mapping of water quality parameters revealed that in most of the delta, the quality of water was not suitable for drinking and agricultural purposes, thus should be properly treated before its use.

Download Full-text

Occurrence of 1,4-dioxane and MTBE in drinking water sources in Japan

Water Science & Technology Water Supply ◽

10.2166/ws.2006.049 ◽

2006 ◽

Vol 6 (2) ◽

pp. 47-53 ◽

Cited By ~ 5

Author(s):

D. Simazaki ◽

M. Asami ◽

T. Nishimura ◽

S. Kunikane ◽

T. Aizawa ◽

...

Keyword(s):

Drinking Water ◽

Surface Water ◽

Water Samples ◽

Quality Standards ◽

Raw Water ◽

Water Quality Standards ◽

Butyl Ether ◽

Water Treatment Plants ◽

Standard Value ◽

Surface Water Samples

Nationwide surveys of 1,4-dioxane and methyl-t-butyl ether (MTBE) levels in raw water used for the drinking water supply were conducted at 91 water treatment plants in Japan in 2001 and 2002, prior to the revision of the drinking water quality standards. 1,4-dioxane was widely and continuously detected in raw water samples and its occurrence was more frequent and its concentrations higher in groundwater than in surface water. However, its maximum concentration in raw water was much lower than its new standard value (50 μg/L), which was determined as a level of 10−5 excessive cancer risk to humans. Trace levels of MTBE were also detected in several surface water samples.

Download Full-text

Enumeration of Cryptosporidium oocysts from surface water concentrates by laser-scanning cytometry

Water Science & Technology ◽

10.2166/wst.2000.0133 ◽

2000 ◽

Vol 41 (7) ◽

pp. 197-202 ◽

Cited By ~ 6

Author(s):

F. Zanelli ◽

B. Compagnon ◽

J. C. Joret ◽

M. R. de Roubin

Keyword(s):

Surface Water ◽

Water Samples ◽

Laser Scanning ◽

Immunomagnetic Separation ◽

Entire Surface ◽

Cryptosporidium Oocysts ◽

Different Types ◽

Laser Scanning Cytometry ◽

Direct Microscopic Observation

The utilization of the ChemScan® RDI was tested for different types of water concentrates. Concentrates were prepared by cartridge filtration or flocculation, and analysed either without purification, or after Immunomagnetic separation (IMS) or flotation on percoll-sucrose gradients. Theenumeration of the oocysts was subsequently performed using the ChemScan® RDI Cryptosporidium application. Enumeration by direct microscopic observation of the entire surface of the membrane was carried out as a control, and recoveries were calculated as a ratio between the ChemScan® RDI result and the result obtained with direct microscopic enumeration. The Chemscan enumeration technique proved reliable, with recoveries yielding close to 100% in most cases (average 125%, range from 86 to 467%) for all the concentration/purification techniques tested. The quality of the antibodies was shown to be critical, with antibodies from some suppliers yielding recoveries a low as 10% in some cases. This difficulty could, however, be overcome by the utilization of the antibody provided by Chemunex. These data conclusively prove that laser scanning cytometry, which greatly facilitates the microscopic enumeration of Cryptosporidium oocysts from water samples and decreases the time of observation by four to six times, can be successfully applied to water concentrates prepared from a variety of concentration/purification techniques.

Download Full-text

Development of Surface Molecularly Imprinted Polymers as Dispersive Solid Phase Extraction Coupled with HPLC Method for the Removal and Detection of Griseofulvin in Surface Water

International Journal of Environmental Research and Public Health ◽

10.3390/ijerph17010134 ◽

2019 ◽

Vol 17 (1) ◽

pp. 134 ◽

Cited By ~ 1

Author(s):

Kamran Bashir ◽

Zhimin Luo ◽

Guoning Chen ◽

Hua Shu ◽

Xia Cui ◽

...

Keyword(s):

Surface Water ◽

Solid Phase Extraction ◽

Molecularly Imprinted Polymers ◽

Water Samples ◽

Solid Phase ◽

Phase Extraction ◽

Dispersive Solid Phase Extraction ◽

Molecularly Imprinted ◽

Imprinted Polymers ◽

Surface Water Samples

Griseofulvin (GSF) is clinically employed to treat fungal infections in humans and animals. GSF was detected in surface waters as a pharmaceutical pollutant. GSF detection as an anthropogenic pollutant is considered as a possible source of drug resistance and risk factor in ecosystem. To address this concern, a new extraction and enrichment method was developed. GSF-surface molecularly imprinted polymers (GSF-SMIPs) were prepared and applied as solid phase extraction (SPE) sorbent. A dispersive solid phase extraction (DSPE) method was designed and combined with HPLC for the analysis of GSF in surface water samples. The performance of GSF-SMIPs was assessed for its potential to remove GSF from water samples. The factors affecting the removal efficiency such as sample pH and ionic strength were investigated and optimized. The DSPE conditions such as the amount of GSF-SMIPs, the extraction time, the type and volume of desorption solvents were also optimized. The established method is linear over the range of 0.1–100 µg/mL. The limits of detection and quantification were 0.01 and 0.03 µg/mL respectively. Good recoveries (91.6–98.8%) were achieved after DSPE. The intra-day and inter-day relative standard deviations were 0.8 and 4.3% respectively. The SMIPs demonstrated good removal efficiency (91.6%) as compared to powder activated carbon (67.7%). Moreover, the SMIPs can be reused 10 times for water samples. This is an additional advantage over single-use activated carbon and other commercial sorbents. This study provides a specific and sensitive method for the selective extraction and detection of GSF in surface water samples.

Download Full-text