scholarly journals Groundwater Quality Determination from hand-dug wells in Ososo Town, Akoko-Edo North Local Government Area Edo State

2021 ◽  
Vol 40 (3) ◽  
pp. 540-549
Author(s):  
E.G. Maju-Oyovwikowhe ◽  
W.O. Emofurieta

Groundwater is water beneath the surface of the earth. The primary source is precipitation from rain, snow, and hail. Groundwater commonly occurs as water that fills pore spaces between mineral or rock grains in sediments and sedimentary rocks. This study is to evaluate the physiochemical characteristics and selected heavy metal levels of Water from Hand Dug Wells in Ososo in Akoko Edo Local Government Area of Edo State, Nigeria. A total of twenty (20) water samples were collected in very clean containers from twenty (20) hand dug wells in Ososo town, and taken to the laboratory immediately for physical, chemical and heavy metal analysis using standard laboratory techniques. The physical analysis results from the study show that depth to ground water is very shallow. Ph was below 7.5. Conductivity varies from 167.8-2120.00/cm. The temperatures were uniform. The ground water is odorless and tasteless. The amounts of total suspended soil (TSS) in all the samples vary from 10–20 ppm. The total dissolved solid content (TDS) concentration for all the samples varies from 132–1320.00 ppm. Total hardness is soft to moderately hard. Total alkalinity values vary between 3.0 to 18.0 ppm. The phenolphthalein value for the sample tested was zero. Chemical analysis results for the cations shows that Calcium (Ca) is one of the most abundant cations in the entire well water samples with concentration varying from 6.4 – 40.0 mg/L. Magnesium (Mg) concentration vary from 2.0 -9.5 ppm. Dissolved Sodium (Na) content values vary from 17.9- 92.5 mg/L. Chemical analysis results for the anions shows that the concentration of sulphate (SO4) ions varies from 93–125 mg/L. The bicarbonate (CO3) concentration in all samples varies from 25.7–90 mg/L. The dissolved nitrites and nitrates concentrations varies from 5.7 – 9.1. Heavy metals analysis shows the concentrations of copper (CU) in the samples range from 0.1 – 0.5 mg/l. The result of the analysis indicates high values of lead (Pb) in nine samples, but lead was not detected in wells 6 and 7. The values for other wells ranged between 0.1-0.2 mg/l. The values for the concentration of chromium (Cr)range from 0.4 -0.89 mg/l. The values of barium (Ba) range from 0.05- 0.3 mg/l. Result from the heavy mineral analysis for Cadmium (Cd) gave an approximate value of 0.2 and below detectable limit in the other wells. The values of Zinc (Zn) range from 0.8 – 11.4 mg/l. The values of Nickel (Ni) range from 0.1–0.5 mg/l.The hand-dug wells in the study area contain free Carbon IV Oxide and the alkalinity of the well water is entirely due to Bicarbonate ions. Sodium, chloride, bicarbonates, calcium, iron, potassium and magnesium are the most abundant. All the dissolved anions in the well water sample are generally below the recommended maximum limits by WHO. Samples also showed high bacteria load which primarily originated from effluent discharge from pit toilets and waste dumps and can constitute health risk on ingestion. Highly populated areas have groundwater with high concentration of dissolved ions and the converse for areas of low population. From the results of the analysis, conclusion is drawn to the fact that, the groundwater chemistry in the study area has been influenced greatly by human activities than the bedrock geology of the area. It is therefore recommended that well location should be at least, 30 m away from any source of contamination such as soak- ways, adequate treatment must be given to well water such as chlorination, boiling to destroy any bacteria and filtration to remove all unwanted/undesirable constituents that may be present, and a policy on land use planning and urban development to guard against indiscriminate setting of wells within the centre of the village should be established. This study has been able to enhance sustainable water development, since the health of inhabitants in a community depends to a large extent on the quality of groundwater supply.

Author(s):  
Priscilla Alexander ◽  
Janyo Noseh Dahiru ◽  
W. Hassan Garba

The quality of water from surface and ground water sources in Hong Local Government Area of Adamawa State was studied to determine their suitability or otherwise for drinking and domestic purposes. Nine (9) samples, three (3) each from streams, dug wells and boreholes were randomly collected, during the dry season, in the months of October and November, 2016. The samples were analysed, and the values compared with WHO and NAFDAC standards to ascertain their compliance. The results of the analysis revealed that the physico-chemical parameters studied and concentrations of heavy metals determined, falls within the maximum permissible limits of WHO and NAFDAC standards for drinking water. However, the water samples were predominantly alkaline (pH 6.30 ± 0.10 to 7.00 ± 0.10), (6.70 ± 0.20 to 7.30 ± 0.20), and (7.60 ±0.20 to 8.20 ± 0.10), for boreholes, dug wells and streams respectively. The heavy metals concentrations were determined using Atomic Absorption Spectrophotometric method. The suitability of water for domestic and drinking purposes indicates that water samples were within the standards prescribed for potable waters.


2020 ◽  
Vol 3 (3a) ◽  
pp. 38-45
Author(s):  
JK Makpo ◽  
SM Ameh ◽  
A Asarya ◽  
YP Gambo

This work assessed the presence of heavy metals in water contaminated with petroleum products in Keffi Local Government Area. Two water sampling station were selected based on the stratified method of sampling of Antau River. Station A is located along Federal Government College Keffi popularly known as Antau Bridge where Agricultural and mechanical activities, with sales of petroleum product take place. Station B was located at Dadin Kowa known as Gada Manu where human activities such as bathing and washing takes place which served as control. The distance between stations is 1km. The procedural plan of this study was monthly sampling of water from both Stations. Materials such as funnel, sampling container, distilled water, conical flask, filter paper, 50ml polypropylene centrifuge tube, cooler were used. Heavy metal concentration was determined using X – ray Fluorescent Spectroscopy (XRF) at the Center for Energy Research and Training (CERT), Ahmadu Bello University Zaria. The water parameters of the four samples were determined using the Extech instrument. The result on Physico – chemical parameters revealed the values obtained from contaminated water samples to be pH (7.31), Dissolved Oxygen (1.14), Electrical Conductivity (8.22), Total Dissolved Solid (4.13), Temperature (27.45) and Salinity (0.091) while the controlled Station at point B were pH (7.43), DO (7.35), EC (3.14), TDS (1.54), Temperature (26.75), Salinity (0.o94) respectively. From the result obtained, the heavy metal contaminated samples had the following values: Mg (29.31±), Al (218.69±), Si (230.12±), S (1153.65±), Cl (54.25±), Ca (106.56±), Ti (23.66±), Cr (3.15±), Fe (15.92±), Cd (7.54±). For the control sample at point B, the following values were obtained: Mg (27.49±), Al (223.71±), Si (243.21±), S (94.84±), Cl (23.52±), Ca (28.44±), Ti (32.99±), Fe (16.63±), Cd (7.67±) respectively. The P-value was 0.8105 (p>0.05) for the water quality parameters while for the concentration of heavy metal P-value was 0.2054 (p>0.05). This implies that there was no significant difference between the concentrations of elements. However, the concentration values of heavy metals in the contaminated water at Station A and control water samples at Station B were higher than the World Health Organization values (Standard) for drinking water


2021 ◽  
Vol 1 (4) ◽  
pp. 377-381
Author(s):  
Gajbhiye RG ◽  
Mahakale RG ◽  
Raut RD ◽  
Dhakre MN

Ground water is one of the most useful water sources found in earth. The importance of the chemical analysis underlies the fact that the chemistry of ground water can directly be rated with the source of water, climate and geology of the region. Contamination of such water is responsible for creating health hazards. In this paper chemical analysis of the ground water has been carried out for Hinganghat in Wardha district. The water sample collected from different location in Hinganghat, Wardha (India). The ground water samples were analyzed for the following chemical parameters; pH, Electrical Conductivity (EC), Total Alkalinity (TA), Total Hardness (TH), Chloride, Nitrate, Sulphate, Dissolved Oxygen (DO) and Total Dissolved Solid (TDS). The results Obtained shown that it is free from anomalies and suitable for human and cattle consumption as well as irrigation purpose in Hinganghat, Wardha districts, Maharashtra, India.


2017 ◽  
Vol 37 (1) ◽  
pp. 9-24
Author(s):  
F. N. Gyawu-Asante ◽  
S. Aikins ◽  
R. B. Voegborlo

A study of the water sources from Bibiani and its environs was conducted between November, 2009 and April, 2010 to determine whether contamination (of water sources) from (these parameters) physical, chemical and trace metal in Bibiani is as a result of mining or geochemicaland biochemical processes within the environment. This was done by collecting water samples from two streams, two rivers, three boreholes (BHs) and three hand dug wells (HDWs). These were analysed in the laboratory. Levels of Arsenic (As), Iron (Fe), Manganese (Mn), pH, TotalDissolved Solids (TDS), Electrical Conductivity (EC), Temperature, Alkalinity, Hardness, Phosphate (P) and Cyanide (CN) in water sources were determined. Mining related contaminants detected in water samples were As, CN, Mn and Fe. It was observed that surface water pH values were generally higher than that of groundwater samples. As concentrations in surface water samples were higher compared to that of groundwater samples. Also, CN concentration in ground water samples was higher than that of surface water. Ground water contained higher concentration of Mn than surface water; the opposite can be said of Fe concentration in surfacewater which was higher than that of ground water. The study also observed that pH, TDS, EC, total alkalinity, total hardness , Arsenic and total cyanide levels in the HDW and BH samples showed 100% compliance with the WHO and EPA limits while Mn and Fe levels indicated traces of non – compliance. Compared to WHO / EPA guidelines, few water sources had one or moretrace metal (Fe, As and Mn) levels outside acceptable limits for drinking. However, most of the levels were safe for human consumption.Keywords: Surface, gold mining, quality, degradation, Bibiani


Author(s):  
Y. Denkok ◽  
O. Adesina ◽  
I. Gurumtet ◽  
S. W. Kopdora

Aim: The present study investigated the concentrations and human health risk of certain metallic elements like cadmium (Cd), chromium (Cr) and Lead (Pb), Zinc (Zn), magnesium (Mg), calcium (Ca) and copper (Cu) in ground water, wells, mining ponds and industrial effluent in Jos South Local Government Area of Plateau state, Nigeria. Study Design: The work is descriptive. Place and Duration of Studies: Department of Biochemistry, University of Jos: October 2020-December 2020. Methodology: Water samples were obtained from our study areas and carefully filtered using Whatman filter paper into a 250ml conical flask to obtain a clear filtrate. The pH of the filtrate was determined using pH meter 3510. Heavy metal determination was done by atomic absorption spectrophotometry (AAS) after digestion of water samples with 5% nitric acid (HNO3). Results: Results obtained indicated that  mining ponds, ground water, industrial effluents as well as  factory-based sachet water, all contained Pb(1.320 to 1.440 mg/l),Cr(-0.0046 to 0.318 mg/l), Cd(1.320 to 1.440 mg/l), Zn(-0.0.106 to 0.5327 mg/l), Cu(0.4359 to 0.7838 mg/l), Mg(5.789 to 22.830 mg/l), Ca(15.241 to 19.706 mg/l) at a concentration that is significantly (P= 0.05) higher compared to the WHO allowable concentrations for drinking water which could be  attributed to inadequate scientific method used in the processing of water and also chemical materials used for bagging and bottling the water for market supply. Conclusion: Metallic contaminants are inevitable components of water from our study area and packaging materials for supply of bottle water are themselves a major risk factor and alternative source of metallic contaminant leaching into factory based sachet water.


Sign in / Sign up

Export Citation Format

Share Document