scholarly journals Comparison of primary and secondary particle formation from natural gas engine exhaust and of their volatility characteristics

2017 ◽  
Vol 17 (14) ◽  
pp. 8739-8755 ◽  
Author(s):  
Jenni Alanen ◽  
Pauli Simonen ◽  
Sanna Saarikoski ◽  
Hilkka Timonen ◽  
Oskari Kangasniemi ◽  
...  

Abstract. Natural gas usage in the traffic and energy production sectors is a growing trend worldwide; thus, an assessment of its effects on air quality, human health and climate is required. Engine exhaust is a source of primary particulate emissions and secondary aerosol precursors, which both contribute to air quality and can cause adverse health effects. Technologies, such as cleaner engines or fuels, that produce less primary and secondary aerosols could potentially significantly decrease atmospheric particle concentrations and their adverse effects. In this study, we used a potential aerosol mass (PAM) chamber to investigate the secondary aerosol formation potential of natural gas engine exhaust. The PAM chamber was used with a constant UV-light voltage, which resulted in relatively long equivalent atmospheric ages of 11 days at most. The studied retro-fitted natural gas engine exhaust was observed to form secondary aerosol. The mass of the total aged particles, i.e., particle mass measured downstream of the PAM chamber, was 6–268 times as high as the mass of the emitted primary exhaust particles. The secondary organic aerosol (SOA) formation potential was measured to be 9–20 mg kgfuel−1. The total aged particles mainly consisted of organic matter, nitrate, sulfate and ammonium, with the fractions depending on exhaust after-treatment and the engine parameters used. Also, the volatility, composition and concentration of the total aged particles were found to depend on the engine operating mode, catalyst temperature and catalyst type. For example, a high catalyst temperature promoted the formation of sulfate particles, whereas a low catalyst temperature promoted nitrate formation. However, in particular, the concentration of nitrate needed a long time to stabilize – more than half an hour – which complicated the conclusions but also indicates the sensitivity of nitrate measurements on experimental parameters such as emission source and system temperatures. Sulfate was measured to have the highest evaporation temperature, and nitrate had the lowest. The evaporation temperature of ammonium depended on the fractions of nitrate and sulfate in the particles. The average volatility of the total aged particles was measured to be lower than that of primary particles, indicating better stability of the aged natural gas engine-emitted aerosol in the atmosphere. According to the results of this study, the exhaust of a natural gas engine equipped with a catalyst forms secondary aerosol when the atmospheric ages in a PAM chamber are several days long. The secondary aerosol matter has different physical characteristics from those of primary particulate emissions.

2017 ◽  
Author(s):  
Jenni Alanen ◽  
Pauli Simonen ◽  
Sanna Saarikoski ◽  
Hilkka Timonen ◽  
Oskari Kangasniemi ◽  
...  

Abstract. Natural gas usage in traffic and energy production sector is a growing trend worldwide, thus an assessment of its effects on air quality, human health and climate is required. Engine exhaust is a source of primary particulate emissions and secondary aerosol precursors that both contribute to air quality and can cause adverse health effects. Technologies, such as cleaner engines or fuels, that produce less primary and secondary aerosol could potentially significantly decrease the atmospheric particle concentrations and their adverse effects. In this study, we used a potential aerosol mass (PAM) chamber to investigate the secondary aerosol formation potential of natural gas engine exhaust. The PAM chamber was used with a constant UV-light voltage that resulted in an equivalent atmospheric age of 11 days at a maximum. The studied passenger car engine, retrofitted to run with natural gas, was observed to have a low or moderate secondary particle formation potential, although the simulated atmospheric ages were relatively long. The secondary organic aerosol (SOA) formation potential was measured to be 8–18 mg kgfuel−1. However, the mass of total aged particles, i.e. particle mass measured downstream the PAM chamber, was 6–184 times as high as the mass of the emitted primary exhaust particles. The total aged particles consisted mainly of nitrate, organic matter, sulfate and ammonium, the fractions depending on exhaust after-treatment and used engine parameters. Also the volatility, composition and concentration of the total aged particles were found to depend on the engine operating mode, catalyst temperature and catalyst type. For example, a high catalyst temperature promoted the formation of sulfate particles, whereas a low catalyst temperature promoted nitrate formation. However, especially the concentration of nitrate needed a long time, more than half an hour, to stabilize, which complicated the conclusions but also indicates the sensitivity of nitrate measurements on experimental parameters such as emission source and system temperatures. Sulfate was measured to have the highest evaporation temperature and nitrate the lowest. The evaporation temperature of ammonium depended on the fractions of nitrate and sulfate in the particles. The average volatility of the total aged particles was measured to be lower than that of primary particles, indicating better stability of the aged natural gas engine emitted aerosol in the atmosphere. According to the results of this study, the shift from traditional liquid fuels to natural gas can have a decreasing effect on total particle pollution in the atmosphere; in addition to the very low primary particle emissions, also the secondary organic aerosol formation potential of natural gas exhaust is lower or on the same level as the SOA formation potential measured on liquid fuels in previous studies.


1996 ◽  
Author(s):  
Robert L. McCormick ◽  
Anthony W. Newlin ◽  
Deborah Mowery ◽  
Michael S. Graboski ◽  
T. R. Ohno

Fuel ◽  
2016 ◽  
Vol 166 ◽  
pp. 574-580 ◽  
Author(s):  
Tadveer Singh Hora ◽  
Pravesh Chandra Shukla ◽  
Avinash Kumar Agarwal

2016 ◽  
Author(s):  
George Karavalakis ◽  
Yu Jiang ◽  
Jiacheng Yang ◽  
Maryam Hajbabaei ◽  
Kent Johnson ◽  
...  

Author(s):  
Kris Quillen ◽  
Maren Bennett ◽  
John Volckens ◽  
Rudolf H. Stanglmaier

Regulatory agencies are becoming increasingly concerned with particulate emissions as the health and environmental effects are becoming better understood. While much research has been performed on diesel engines, little is known about particulate matter (PM) emissions from natural gas internal combustion engines. In this project, tests were conducted on a Waukesha VGF F18 natural gas engine running at full load. PM10 combustion emissions were collected on Teflon and quartz filters and a scanning mobility particle sizer (SMPS) was used to determine the particle size distribution. Tests were performed at 4, 5, 6, and 7% exhaust oxygen (O2) levels. Overall, it was found that a large number of small particles were emitted from this engine. The total mass based PM emissions were found to be 0.0148 gm/bkW-hr, which is slightly greater than the tier-4 nonroad diesel particulate emissions standard. Particle distributions revealed that the geometric mean diameter (GMD) of the natural gas particles was approximately 30 nm and did not change with air to fuel ratio. Particulate concentrations were found to decrease at leaner engine operating conditions. Results showed a strong correlation between the NOx and particle concentrations, while an inverse correlation between CO and particle concentrations was revealed.


Sign in / Sign up

Export Citation Format

Share Document