A case study of 5th generation district heating and cooling based on foundation pile heat exchangers (Vejle, Denmark)

Author(s):  
Søren Erbs Poulsen ◽  
Maria Alberdi-Pagola ◽  
Karl Woldum Tordrup ◽  
Davide Cerra ◽  
Theis Raaschou Andersen

<p>We present the findings of a recently concluded research project, investigating the possibilities for collective heating and cooling supply of a planned, relatively small residential area (Rosborg Ø) in Ny Rosborg, Vejle, Denmark with ground source heat pumps utilising foundation pile heat exchangers (a.k.a. energy piles, EP). Individual EP foundations connect to a distribution network of uninsulated geothermal pipes, buried at shallow depth (cold district heating, CDH) from which connected consumers can supply heating with heat pumps as well as passive or active cooling.</p><p>To this end, the project has developed a geothermal screening procedure based on a combined analysis of geophysical data, borehole information, pile testing and laboratory measurements of soil thermal properties. A prototype computational temperature model of CDH networks has been developed for estimating the performance of EP based heating and cooling supply of Rosborg Ø. Finally, the project has developed a complete business (case) model for EP based CDH with a well-defined cost structure in which total fixed and variable costs can be quantified in specific projects.</p><p>The mapping of the geothermal potential demonstrates that CDH most likely can fully supply the estimated energy demand of the planned buildings in Rosborg Ø. However, recalculation of the scenario is necessary once additional information on the planned buildings become available. This conclusion is further supported by operational data from the EP foundation at the nearby Rosborg Gymnasium, demonstrating excess heating and cooling possibilities (beyond the demand of the building itself). Further analyses of the data from the Gymnasium estimates the average energy efficiency ratio to 24.8 for the passive cooling during July and early August 2018, roughly ten times higher than that of traditional Air Conditioning (AC). Moreover, the Gymnasium is able to supply its cooling needs passively 97% of the time where cooling is required, implying that the variable cost of cooling with EPs is exceptionally low.</p><p>The initial investment required for EP based CDH is higher, however, the variable costs of heating and cooling are greatly reduced relative to those of traditional District Heating (DH) and AC. Consequently, the estimated payback period for collective EP based CDH supply of Rosborg Ø is ca. 4.5 years. The relatively short payback period is due to a drastic reduction (of 80%) of the combined variable costs of heating and cooling with EPs, relative to traditional DH and AC. The contributing factors to the short payback period are the relatively low costs of electricity, the high COP of the heat pump, a relatively high, annual fixed tariff imposed by traditional DH and finally the exceptionally low costs of passive cooling/seasonal heat storage. As such, the project demonstrates a truly renewable, economically competitive heat pump technology to supply collective building heating and cooling/seasonal heat storage for the future energy supply in Denmark.</p>

Energies ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2347
Author(s):  
Elżbieta Hałaj ◽  
Jarosław Kotyza ◽  
Marek Hajto ◽  
Grzegorz Pełka ◽  
Wojciech Luboń ◽  
...  

Krakow has an extensive district heating network, which is approximately 900 km long. It is the second largest city in terms of the number of inhabitants in Poland, resulting in a high demand for energy—for both heating and cooling. The district heating of the city is based on coal. The paper presents the conception of using the available renewable sources to integrate them into the city’s heating system, increasing the flexibility of the system and its decentralization. An innovative solution of the use of hybrid, modular heat pumps with power dependent on the needs of customers in a given location and combining them with geothermal waters and photovoltaics is presented. The potential of deep geothermal waters is based on two reservoirs built of carbonate rocks, namely Devonian and Upper Jurassic, which mainly consist of dolomite and limestone. The theoretical potential of water intake equal to the nominal heating capacity of a geothermal installation is estimated at 3.3 and 2.0 MW, respectively. Shallow geothermal energy potential varies within the city, reflecting the complex geological structure of the city. Apart from typical borehole heat exchangers (BHEs), the shallower water levels may represent a significant potential source for both heating and cooling by means of water heat pumps. For the heating network, it has been proposed to use modular heat pumps with hybrid sources, which will allow for the flexible development of the network in places previously unavailable or unprofitable. In the case of balancing production and demand, a photovoltaic installation can be an effective and sufficient source of electricity that will cover the annual electricity demand generated by the heat pump installation, when it is used for both heating and cooling. The alternating demand of facilities for heating and cooling energy, caused by changes in the seasons, suggests potential for using seasonal cold and heat storage.


2017 ◽  
Vol 12 (4) ◽  
pp. 21-34
Author(s):  
Friedrich Sick ◽  
Ralph Füger

A successful energy transition depends on storage options in order to ensure power supply stability under a fluctuating generation of a growing share of renewable energies (RE). Battery storage is expensive and raw material intensive and therefore not suitable as a sole solution. Surplus electricity may easily be converted to heat, which can be stored inexpensively for a short term. With such simple Power-to-Heat or P2H solutions, lack of electric power cannot be offset by conventional heat storage. However, if a building or an urban quarter is heated by means of cogeneration, so-called Combined Heat and Power (CHP), or heat pumps (HP), the operation can be adjusted in such a way, that the building itself, i.e. its massive structure, serves as heat storage. Electricity generation and consumption is adjusted to the requirements of the grid (reactive power control). For the supply of a Berlin quarter, built in the 1950s and equipped with a district heating network and a CHP plant, the feasibility of the concept could be proved using dynamic building simulation as the analysis tool. Sixteen percent of the total heating consumption may useably be stored and extracted from the building structure. In absolute numbers: 73 MWh/a heat can be buffered corresponding to 34 MWh/a balancing electricity. For each square meter of living area, 3.7 kWh electrical balancing energy can be buffered in the building's thermal storage capacity. Nothing else is required than a re-programming of heating and possibly cooling controls. No capital investment is needed. Well insulated and more massive structures could show a proportion of 27% of such shifted heat.


Author(s):  
D. Cerra ◽  
M. Alberdi-Pagola ◽  
T.R. Andersen ◽  
K.W. Tordrup ◽  
S.E. Poulsen

We assess the feasibility of a collective district heating and cooling network based on a foundation pile heat exchanger in a new urban area in Vejle, Denmark. A thermogeological model for the area is developed based on geophysical investigations and borehole information. In tandem with a building energy demand model, the subsurface thermal properties serve as the input for a newly developed computational temperature model for collective heating and cooling with energy piles. The purpose of the model is to estimate the long-term performance and maximum liveable area that the energy piles are able to support. We consider two case studies where residential and office buildings dominate the building mass. We find that three to four floors can be supplied with heating and cooling from the energy piles, depending on the use and design of the buildings.


2021 ◽  
pp. 103438
Author(s):  
Francesco Calise ◽  
Francesco Liberato Cappiello ◽  
Massimo Dentice d'Accadia ◽  
Fontina Petrakopoulou ◽  
Maria Vicidomini

2019 ◽  
Vol 9 (15) ◽  
pp. 3194 ◽  
Author(s):  
Urbanucci ◽  
Testi ◽  
Bruno

District heating and cooling networks based on trigeneration systems and renewable energy technologies are widely acknowledged as an energy efficient and environmentally benign solution. These energy systems generally include back-up units, namely fossil-fuel boilers and electric chillers, to enhance system flexibility and cover peak energy demand. On the other hand, 4th generation district heating networks are characterized by low-temperature water distribution to improve energy and exergy efficiencies. Moreover, reversible heat pumps are a versatile technology, capable of providing both heating and cooling, alternately. In this paper, the integration of reversible heat pumps as single back-up units in hybrid renewable trigeneration systems serving low-energy micro-district heating and cooling networks is investigated. A detailed modeling of the system is provided, considering part-load and ambient condition effects on the performance of the units. Size and annual operation of the proposed system are optimized in a case study, namely a large office building located in Pisa (Italy), by means of a genetic algorithm-based procedure. A comparison with the conventional trigeneration system is performed in terms of economic and environmental perspectives. Results show that the integration of reversible heat pumps is an economically viable solution capable of reducing by 7% the equivalent annual cost, increasing the installed power of renewables up to 23%, and lowering by 11% carbon dioxide emissions, compared to the energy system with conventional back-up units.


Energies ◽  
2019 ◽  
Vol 12 (3) ◽  
pp. 364 ◽  
Author(s):  
Marcello Aprile ◽  
Rossano Scoccia ◽  
Alice Dénarié ◽  
Pál Kiss ◽  
Marcell Dombrovszky ◽  
...  

District heating and cooling (DHC), when combined with waste or renewable energy sources, is an environmentally sound alternative to individual heating and cooling systems in buildings. In this work, the theoretical energy and economic performances of a DHC network complemented by compression heat pump and sewage heat exchanger are assessed through dynamic, year-round energy simulations. The proposed system comprises also a water storage and a PV plant. The study stems from the operational experience on a DHC network in Budapest, in which a new sewage heat recovery system is in place and provided the experimental base for assessing main operational parameters of the sewage heat exchanger, like effectiveness, parasitic energy consumption and impact of cleaning. The energy and economic potential is explored for a commercial district in Italy. It is found that the overall seasonal COP and EER are 3.10 and 3.64, while the seasonal COP and EER of the heat pump alone achieve 3.74 and 4.03, respectively. The economic feasibility is investigated by means of the levelized cost of heating and cooling (LCOHC). With an overall LCOHC between 79.1 and 89.9 €/MWh, the proposed system can be an attractive solution with respect to individual heat pumps.


2019 ◽  
Vol 139 ◽  
pp. 904-914 ◽  
Author(s):  
Poul Alberg Østergaard ◽  
Jan Jantzen ◽  
Hannah Mareike Marczinkowski ◽  
Michael Kristensen

Entropy ◽  
2020 ◽  
Vol 23 (1) ◽  
pp. 47
Author(s):  
Primož Poredoš ◽  
Boris Vidrih ◽  
Alojz Poredoš

The main research objective of this paper was to compare exergy performance of three different heat pump (HP)-based systems and one natural gas (NG)-based system for the production of heating and cooling energy in a single-house dwelling. The study considered systems based on: 1. A NG and auxiliary cooling unit; 2. Solely HP, 3. HP with additional seasonal heat storage (SHS) and a solar thermal collector (STC); 4. HP with SHS, a STC and a grey water (GW) recovery unit. The assessment of exergy efficiencies for each case was based on the transient systems simulation program TRNSYS, which was used for the simulation of energy use for space heating and cooling of the building, sanitary hot water production, and the thermal response of the seasonal heat storage and solar thermal system. The results show that an enormous waste of exergy is observed by the system based on an NG boiler (with annual overall exergy efficiency of 0.11) in comparison to the most efficient systems, based on HP water–water with a seasonal heat storage and solar thermal collector with the efficiency of 0.47. The same system with an added GW unit exhibits lower water temperatures, resulting in the exergy efficiency of 0.43. The other three systems, based on air–, water–, and ground–water HPs, show significantly lower annual source water temperatures (10.9, 11.0, 11.0, respectively) compared to systems with SHS and SHS + GW, with temperatures of 28.8 and 19.3 K, respectively.


Sign in / Sign up

Export Citation Format

Share Document