scholarly journals Static and Dynamic Safety Evaluation of A Heightened Arch Dam Including Massed Foundation Effects

2020 ◽  
Vol 4 (4) ◽  
pp. 37-48
Author(s):  
H. Mirzabozorg ◽  
M. Ghaemian ◽  
S. M. Aghajanzadeh ◽  
◽  
◽  
...  
2014 ◽  
Vol 578-579 ◽  
pp. 964-967
Author(s):  
Zhi Qiang Wang ◽  
Wen Biao Liu

The brittle failure finite element method is widely used in arch dam safety evaluation, but it also has some problems, the concrete strength criterion is different, the dam failure range is different. This article first introduces brittle failure constitutive relation and three strength criterions, then takes a high arch dam as an example to compute, obtains some conclusions that the relative failure range of foundation plane corresponds to blaxial strength criterion is slightly bigger than the result of uniaxial strength criterion, is almost the same as the result of triaxial strength criterion. Because the influence of the third principal stress is compressed stress to the dam crack is taken into account under multiaxial strength criterion, therefore using multiaxial strength criterion is more reasonable.


2010 ◽  
Vol 29-32 ◽  
pp. 1476-1480
Author(s):  
Zhi Guo Niu ◽  
Jun Lu ◽  
Ri You

To reasonably evaluate the seismic behavior of high arch dams, a damage plasticity model is adopted to simulate the dynamic nonlinear behavior of dam concrete for a hydropower station. Combining with the viscous-spring boundary and compressibility reservoir model, the maximum principal stress on upstream and downstream surfaces is obtained. The results show that the effects of material nonlinearity damage on the dynamic response of the arch dam are significant under earthquake load.


2015 ◽  
Vol 09 (03) ◽  
pp. 1550009 ◽  
Author(s):  
Xinhua Xue ◽  
Xingguo Yang ◽  
Wohua Zhang

The accuracy of the risk evaluation associated with existing dams as well as the efficient design of future dams is highly dependent on a proper understanding of their behavior due to earthquakes. This paper presents a 3D anisotropic damage model for arch dam under strong earthquakes. The modified effective Mohr–Coulomb criterion is adopted as the failure criteria of the dynamic damage evolution of concrete. From the simulation of the dynamic damage process, some process fields of the dynamic displacement, the dynamic stress, dynamic damage distribution and other necessary information for the safety evaluation are obtained. These results show that the seismic behavior of concrete dams can be satisfactorily predicted. This will provide a reasonable theoretical support on the safety evaluation of the capability for concrete arch dams against earthquake loading.


2014 ◽  
Vol 610 ◽  
pp. 3-6
Author(s):  
Zhi Qiang Wang ◽  
Ke Hong Zheng

The nonlinear finite element can precisely simulate practical work condition of arch dam, but also has some problems in the safety evaluation of high arch dam, mainly in different mesh size, different strength criteria and constitutive relations of dam corresponding to different results. This article first proposes determining method for reasonable mesh size describes three strength criterions of uniaxial, biaxial, triaxial, gives two constitutive relations of dam cracking, damage. Take a high arch dam as an example, has done some research on the above question, obtain some beneficial conclusions.


2007 ◽  
Vol 348-349 ◽  
pp. 597-600 ◽  
Author(s):  
Zai Tie Chen ◽  
Qing Wen Ren

In order to overcome the weakness in traditional high arch dam safety evaluation without considering the randomness, failure mode and risk analysis, it is proposed to apply three indexes namely failure probability, economic loss and life loss to high arch dam safety evaluation. On the basis of the analysis of accidents and on-site measured data, expert discussion as well as analytical analogy and by means of Fault Tree Analysis, a probe is made into the four major failure modes and the causes of high arch dam failure, namely destabilization collapse, shear-slipping collapse, excess cracking and man-caused destruction. Based on the calculating of the probability of high arch dam shearing-slipping failure, the computational method and procedures are established by means of Second Moment Method for the calculation of the occurrence probability of the major failure modes of high arch dam. A study is made of the degree of correlation between the major failure modes and of the method for calculating the high arch dam failure probability under multi-failure-modes.


2008 ◽  
Vol 385-387 ◽  
pp. 269-272 ◽  
Author(s):  
Zai Tie Chen

Risk analysis can overcome the weakness of conventional safety evaluation of high-arch dams where the random nature of the load and resistance effect are ignored and the failure mode and failure disaster loss are not taken into account. On the basis of statistical analysis of the data of the failure arch dams and faulty and perilous arch dams in the world, it is deduced that the failure of high arch dam is mainly caused by super elevation floods, highly intense earthquakes, mountain landslides, abnormal temperature variation, explosion load, etc. Five major failure modes for high arch dams are suggested, namely dam abutment rock instability, fundamental plane instability, entire entity instability, excess cracking and extreme dam overflow. Based on the study of the failure mechanism of the major failure modes, a state function is established to calculate the failure probability of the major failure modes. An approach is developed to obtain the statistical quantity and the regularities of distribution of the load and resistance random variables.


2012 ◽  
Vol 430-432 ◽  
pp. 1818-1821
Author(s):  
Yu Xia ◽  
Ying Ye Yu ◽  
Zhong Qing Zhang ◽  
Xiao Lian Zhao

Arch dam’s failure is a super nonlinear irreversible process. The failure process of it is quite important for safety evaluation. It analyses overload of the highest RCC arch dam of the world with explicit FEM and shows the process of dam’s failure from normal operation, local deformation to overall failure by water specific gravity overcharge method. It gives a more direct and precisely safety factor. This method is also can be used in other structures.


Sign in / Sign up

Export Citation Format

Share Document