scholarly journals Jones type fifth metatarsal fracture fixation in athletes: A review and current concept

2021 ◽  
Vol 12 (9) ◽  
pp. 640-650
Author(s):  
Mohammad Albloushi ◽  
Amer Alshanqiti ◽  
Mohammad Qasem ◽  
Andreas Abitbol ◽  
Thomas Gregory
2019 ◽  
Vol 13 (Supl 1) ◽  
pp. S30
Author(s):  
Kelly Cristina Stéfani ◽  
Leonardo Vinicius De Matos Moraes ◽  
James T. McMurtrie ◽  
Haley M. McKissack ◽  
Jianguang Peng ◽  
...  

Introduction: Proximal fifth metatarsal fracture fixation is usually treated conservatively, but when chosen for surgical treatment, percutaneous fixation with screws is the most used. This study aims to evaluate the presence of injury of the structures at risk and to measure the distance of these structures to the entry point.  Methods: Eleven fresh-frozen below-the-knee specimens underwent standard operative fixation for a Jones fracture via the “High and inside” percutaneous technique. A guide wire was placed through the medullary canal and confirmed on fluoroscopy. The cannulated drill with a drill sleeve was then placed over the wire and advanced to the diaphysis. The guide wire was left, and the skin and subcutaneous tissues were carefully removed from the lateral midfoot to fully expose the structures at risk. The guidewire was then removed, and then the solid screw was placed. Neurovascular and tendinous structures were assessed for any injury. The distance of the wire in the base of the fifth metatarsal and these structures was measured and documented, including the branches of the sural nerve, cuboid, fourth metatarsal, peroneus longus, and peroneus brevis tendons.  Results: The structure with the shortest average distance from the pin was the peroneus brevis, measuring 0.91 mm (±1.22 mm S.D.), followed by the cuboid articular surface, sural nerve, peroneus longus, and base of the fourth metatarsal, respectively. The pin had damaged the peroneus brevis in 5 of 11 cadavers. The average distance from the tendon insertion point was 7.2 mm. The furthest measured distance was 10 mm, while the closest was 3 mm. The screw head contacted the articular surface of the cuboid in 3 of 11 cadavers. There were no instances of pin contact with or damage to the peroneus longus, sural nerve, or fourth metatarsal head.  Conclusion: We conclude that percutaneous fixation of fractures of the base of the fifth metatarsus presents a risk of partial lesion of the peroneus brevis tendon and lateral aspect of the cuboid. Therefore, specific care with these structures should be taken during the procedure.


2008 ◽  
Vol 21 (02) ◽  
pp. 140-146
Author(s):  
M. R. Edwards ◽  
S. P. James ◽  
W. S. Dernell ◽  
R. J. Scott ◽  
A. M. Bachand ◽  
...  

SummaryThe biomechanical characteristics of 1.2 mm diameter allogeneic cortical bone pins harvested from the canine tibia were evaluated and compared to 1.1 mm diameter stainless steel pins and 1.3 mm diameter polydioxanone (PDS) pins using impact testing and four-point bending. The biomechanical performance of allogeneic cortical bone pins using impact testing was uniform with no significant differences between sites, side, and gender. In four-point bending, cortical bone pins harvested from the left tibia (204.8 ± 77.4 N/mm) were significantly stiffer than the right tibia (123.7 ± 54.4 N/mm, P=0.0001). The site of bone pin harvest also had a significant effect on stiffness, but this was dependent on interactions with gender and side. Site C in male dogs had the highest mean stiffness in the left tibia (224.4 ± 40.4 N/mm), but lowest stiffness in the right tibia (84.9 ± 24.2 N/mm). Site A in female dogs had the highest mean stiffness in the left tibia (344.9 ± 117.4 N/mm), but lowest stiffness in the right tibia (60.8 ± 3.7 N/mm). The raw and adjusted bending properties of 1.2 mm cortical bone pins were significantly better than 1.3 mm PDS pins, but significantly worse than 1.1 mm stainless steel pins (P<0.0001). In conclusion, cortical bone pins may be suitable as an implant for fracture fixation based on initial biomechanical comparison to stainless steel and PDS pins used in clinical practice.


Acarina ◽  
2020 ◽  
Vol 28 (1) ◽  
pp. 55-64
Author(s):  
Omid Joharchi ◽  
Elizabeth Hugo-Coetzee ◽  
Sergey G. Ermilov ◽  
Alexander A. Khaustov

Hypoaspisella spiculifer comb. n. is redescribed on the basis of adult females, collected from soil in South Africa. Hypoaspisella spiculifer fits well with the current concept of the genus Hypoaspisella Bernhard. The chelicerae of this species are similar to those of free-living mites, suggesting that it may be a predator of small soil invertebrates.


Sign in / Sign up

Export Citation Format

Share Document