Effect of Direct Powder Forging Process on the Mechanical Properties and Microstructural of Ti-6Al-4V ELI

The study of powder metallurgy processing methods for titanium represents a promising avenue that can respond to a growing demand. This work reports the feasibility of direct powder forging (DPF) as a method to process large spherical Ti-6Al-4V powder into wrought products with noteworthy properties and physical characteristics. Direct powder forging is a thermomechanical process that imparts uniaxial loading to an enclosed and uncompacted powder to produce parts of various sizes and shapes. Stainless steel canisters were filled with prealloyed Ti-6Al-4V powder and consolidated through a multi-step open-die forging and rolling process into wrought DPF bars. After DPF, annealing was performed in the upper α+β phase. The results show that full consolidation was achieved and higher mechanical properties than the Ti-6Al-4V grade F-23 requirements in annealed conditions were obtained. The results also show that direct powder forging of spherical titanium powder could produce wrought mill products and exhibit some potential for further investigation for industrial applications.

Sintering High Green Density Direct Powder Rolled Titanium Strips, in Argon Atmosphere

Presently, the majority of titanium powder metallurgy components produced are sintered under high vacuum due to the associated benefits of the vacuum atmosphere. However, high-vacuum sintering is a batch process, which limits daily production. A higher daily part production is achievable via a continuous sintering process, which uses argon gas to shield the part from air contamination. To date, there has been limited work published on argon gas sintering of titanium in short durations. This study investigated the properties of thin high green density titanium strips, which were sintered at the temperatures of 1100 °C, 1200 °C and 1300 °C for a duration of 30 min, 60 min and 90 min in argon. The strips were produced by rolling of −45 µm near ASTM (American Society for Testing and Materials) grade 3 hydride–dehydride commercially pure titanium powder. The density, hardness, tensile properties and microstructure of the sintered strips were assessed. It was found that near-full densities, between 96 and 99%, are attainable after 30–90 min of sintering. The optimum sintering temperature range was found to be 1100–1200 °C, as this produced the highest elongation of 4–5.5%. Sintering at 1300 °C resulted in lower elongation due to higher contaminant pick-up.