Effects of 405 ± 5-nm LED Illumination on Environmental Stress Tolerance of Salmonella Typhimurium in Sliced Beef

Salmonella Typhimurium is a widely distributed foodborne pathogen and is tolerant of various environmental conditions. It can cause intestinal fever, gastroenteritis and bacteremia. The aim of this research was to explore the effect of illumination with 405 nm light-emitting diodes (LEDs) on the resistance of S. Typhimurium to environmental stress. Beef slices contaminated with S. Typhimurium were illuminated by 405 nm LEDs (18.9 ± 1.4 mW/cm2) for 8 h at 4 °C; controls were incubated in darkness at 7 °C. Then, the illuminated or non-illuminated (control) cells were exposed to thermal stress (50, 55, 60 or 65 °C); oxidative stress (0.01% H2O2 [v/v]); acid stress (simulated gastric fluid [SGF] at pH 2 or 3); or bile salts (1%, 2%, or 3% [w/v]). S. Typhimurium treated by 405 nm LED irradiation showed decreased resistance to thermal stress, osmotic pressure, oxidation, SGF and bile salts. The transcription of eight environmental tolerance-related genes were downregulated by the illumination. Our findings suggest the potential of applying 405 nm LED-illumination technology in the control of pathogens in food processing, production and storage, and in decreasing infection and disease related to S. Typhimurium.

Separation and Stabilization of Arsenic from Lead Slime by the Combination of Acid Leaching and Forming Scorodite

In this paper, a scheme is proposed for the treatment of arsenic-containing lead slime by the combination of acid pressure oxidation leaching and forming scorodite. On the basis of thermodynamic calculations, the effects of six factors including acid concentration, oxygen partial pressure (pO2), liquid to solid ratio (L/S), agitating speed, leaching time and temperature for the removal of arsenic were studied in an acid pressure oxidation leaching process, then the optimum leaching conditions were established: L/S of 10 mL/g, leaching time of 2.5 h, pO2 of 2.0 MPa, leaching temperature of 170 °C, acid concentration of 100 g/L and stirring speed of 300 r/min. Under the optimal conditions, the leaching rate of arsenic from lead slime reached 99.10% and the arsenic content of the leaching residue was about 0.80%. After a decontamination procedure, the total arsenic concentration in the acid solution obtained from leaching experiments was 37.18 g/L, and the initial pH was 0.50. Finally, as high as 98.5% of arsenic extracted from the lead slime was stabilized in the form of scorodite (FeAsO4·2H2O) by the precipitation process under the following conditions: initial pH value of 1.0, Fe(II)/As molar ratio of 1.3, pO2 of 2.5 MPa, temperature of 160 °C and precipitation time of 2.0 h.

Flotation of Carbonaceous Matter from a Double Refractory Gold Ore: The Effect of MIBC on Flotation Performance and Kinetics

The use of alkaline pressure oxidation to pretreat refractory gold ore often results in insufficient gold recovery (<60%) in downstream thiosulfate leaching. To improve gold recovery, flotation was considered for the separation of carbonaceous matter (C-matter). In this study, the effect of MIBC on C-matter flotation was investigated to understand the role of the frother in bubble and froth formation and on flotation kinetics. MIBC dosages between 30 and 150 g/t were used in combination with 500 g/t of kerosene as a collector. The results showed that the recovery and selectivity of C-matter were improved with increasing MIBC dosages. Improved selectivity at higher MIBC dosages was attributed to faster C-matter recovery as bubble size decreased to the critical coalescence concentration (CCC) and to changes to the foam structure. Analysis of flotation kinetics showed that the flotation rate increased as the MIBC dosage increased due to the decreasing bubble size and the reduced induction time caused by the interaction between the collector and the frother. The results of this study explain the role of MIBC in C-matter flotation and can be used as a design basis for scavenger-cleaner flotation testing. Overall, the results show the potential for flotation as a means to improve gold recovery in thiosulfate leaching through the removal of C-matter.