Experimental and Numerical Study on the Heat Transfer Characteristics of a Newly-Developed Solar Active Thermal Insulation System

A newly-developed solar active thermal insulation system (SATIS) is introduced with the main objective to accomplish a highly-dependent total solar transmittance on the irradiation angle. SATIS is also designed to obtain the maximum transmittance at a prescribed design irradiation angle and to reduce it remarkably at higher irradiation angles. A purely mineral thermal insulation plaster with micro hollow glass spheres is applied to manufacture the investigated SATIS prototype. Light-conducting elements (LCEs) have been introduced into SATIS and suitable closing elements have been applied. The SATIS prototype has been investigated both experimentally and numerically. It turned out that the contributions of conduction, radiation and convection to the effective thermal conductivity of SATIS, without the closing elements (49 mWmK), amount to 86.2%, 13.2% and 0.6%, respectively. The angle-dependent short-wave radiation exchange within the LCE has been investigated via ray tracing. At the incidence angle of 19% (design angle), 27% of the radiation within the LCE is absorbed by the absorber plate, resulting in measured and computed total solar energy transmittances of 11.2%/11.7%, respectively. For a typical summer irradiation angle of 60%, 98% of the incident radiation is absorbed by the surfaces at the entrance of the LCE. The corresponding total solar energy transmittance amounts to 2.9%.

Design and Verification of a Deep Rock Corer with Retaining the In Situ Temperature

Deep rock is always under high-temperature conditions. However, traditional coring methods generally have no thermal insulation design, which introduces large deviations in the guidance required for resource mining. Thus, a thermal insulation design that utilizes active and passive thermal insulation was proposed for deep rock corers. The rationale behind the active thermal insulation scheme was to maintain the in situ core temperature through electric heating that was controlled by using a proportional-integral-derivative (PID) chip. Graphene heating material could be used as a heating material for active thermal insulation through testing. In regard to the passive thermal insulation scheme, we conducted insulation and microscopic and insulation effectiveness tests for hollow glass microsphere (HGM) composites and SiO2 aerogels. Results showed that the #1 HGM composite (C1) had an excellent thermal insulation performance (3 mm thick C1 can insulate to 82.6°C), high reflectivity (90.02%), and wide applicability. Therefore, C1 could be used as a passive insulation material in deep rock corers. Moreover, a heat transfer model that considered multiple heat dissipation surfaces was established, which can provide theoretical guidance for engineering applications. Finally, a verification test of the integrated active and passive thermal insulation system (graphene heating material and C1) was carried out. Results showed that the insulating effect could be increased by 13.3%; thus, the feasibility of the integrated thermal insulation system was verified. The abovementioned design scheme and test results provide research basis and guidance for the development of thermally insulated deep rock coring equipment.