Electrochemical Properties of a Lithium-Impregnated Metal Foam Anode (LIMFA Fecral) for Molten Salt Thermal Batteries

Although numerous cathode materials with excellent properties have been developed for use in molten salt thermal batteries, similar progress is yet to be made with anode materials. Herein, a high-performance lithium-impregnated metal foam anode (LIMFA) is fabricated by impregnating molten lithium into a gold-coated iron–chrome–aluminum (FeCrAl) foam at 400°C. A test cell employing the LIMFA FeCrAl anode exhibited a specific capacity of 2,627 As·g−1. For comparison, a cell with a conventional Li(Si) anode was also discharged, demonstrating a specific capacity of 982 As·g−1. This significant improvement in performance can be attributed to the large amount (18 wt.%) of lithium incorporated into the FeCrAl foam and the ability of the FeCrAl foam to absorb and immobilize molten lithium without adopting a cup system. For thermal batteries without a cup, the LIMFA FeCrAl provides the highest-reported specific capacity and a flat discharge voltage curve of molten lithium. After cell discharge, the FeCrAl foam exhibited no lithium leakage, surface damage, or structural collapse. Given these advantageous properties, in addition to its high specific capacity, LIMFA FeCrAl is expected to aid the development of thermal batteries with enhanced performance.

Calcium metaborate induced thin walled carbon nanotube syntheses from CO2 by molten carbonate electrolysis

An electrosynthesis is presented to transform the greenhouse gas CO2 into an unusually thin walled, smaller diameter morphology of Carbon Nanotubes (CNTs). The transformation occurs at high yield and coulombic efficiency of the 4-electron CO2 reduction in a molten carbonate electrolyte. The electrosynthesis is driven by an unexpected synergy between calcium and metaborate. In a pure molten lithium carbonate electrolyte, thicker walled CNTs (100–160 nm diameter) are synthesized during a 4 h CO2 electrolysis at 0.1 A cm−2. At this low current density, CO2 without pre-concentration is directly absorbed by the air (direct air capture) to renew and sustain the carbonate electrolyte. The addition of 2 wt% Li2O to the electrolyte produces thinner, highly uniform (50–80 nm diameter) walled CNTs, consisting of ~ 75 concentric, cylindrical graphene walls. The product is produced at high yield (the cathode product consists of > 98% CNTs). It had previously been demonstrated that the addition of 5–10 wt% lithium metaborate to the lithium carbonate electrolyte boron dopes the CNTs increasing their electrical conductivity tenfold, and that the addition of calcium carbonate to a molten lithium carbonate supports the electrosynthesis of thinner walled CNTs, but at low yield (only ~ 15% of the product are CNTs). Here it is shown that the same electrolysis conditions, but with the addition of 7.7 wt% calcium metaborate to lithium carbonate, produces unusually thin walled CNTs uniform (22–42 nm diameter) CNTs consisting of ~ 25 concentric, cylindrical graphene walls at a high yield of > 90% CNTs.