Hot tensile deformation behavior and microstructure evolution of Mg-1Al-6Y alloy

In this study, the hot tensile test was carried out using the extruded and annealed Mg-1Al-6Y alloy. The effect of temperature and strain rate on the hot tensile deformation behavior of the alloy was systematically studied at different temperatures (200 ℃ ~ 350 ℃) and different strain rates (8×10-5 s-1 ~ 1.6×10-3 s-1). In addition, the effect of temperature on the evolution of microstructure when the strain rate is 1.6×10-3 s-1 was investigated. The results showed that as the temperature increased or the strain rate decreased, the peak stress decreased and the elongation increased. Hot tensile at different temperatures all increased the texture intensity, and the microstructure after deformation showed obvious characteristics of basal fiber texture ([0001]⊥ED). Correspondingly, the weaker [-15-40]//ED texture before deformation transformed into a stronger [01-10]//ED fiber texture. After deformation, the average Schmid factor (SF) of each non-basal slip was significantly increased compared with the average SF before deformation, indicating that abundant non-basal slip was activated during the deformation. When the deformation temperature was 300 °C, dynamic recrystallization (DRX) occurred significantly, and the DRXed grains accounted for 15.9%. DRX was a combination of continuous dynamic recrystallization (CDRX) and discontinuous dynamic recrystallization (DDRX). Furthermore, the calculated activation energy of the alloy was about 98.8 kJ/mol. Comprehensive research showed that the hot tensile deformation mechanism mainly included intragranular slip, grain boundary slip (GBS) and DRX.

Hot Tensile Deformation Behavior of Mg-4Li-1Al-0.5Y Alloy

The microstructure evolution and deformation mechanism of the as-extruded-annealed Mg-4Li-1Al-0.5Y alloy (denoted as LAY410) were investigated during the hot tensile deformation at the temperatures between 150°C and 300°C with strains from 8 × 10−5 s−1 to 1.6 × 10−3 s−1. The results show that when the strain rate decreases and/or the deformation temperature increases, the peak stress of the alloy gradually decreases, and the elongations to fracture gradually increases. The true stress–strain curves show typical dynamic recrystallization (DRX) softening characteristics. It is observed that the microstructure in the magnesium (Mg) alloy deformed at 150°C is mainly composed of the deformed grains and a few recrystallized grains. The microstructures in the Mg alloy deformed at 200°C consisted of substructures and a slightly increasing number of dynamic recrystallized grains. When the deformation temperature reaches 250°C, the number of recrystallized grains increases significantly, and the microstructures are dominated by recrystallized grains. Moreover, through theoretical calculation and result analysis, the activation energy was about 99.3 kJ/mol, and the hot tensile deformation mechanism was the alternate coordinated deformation mechanism among grain boundary slip (GBS), intragranular slip, and DRX.