Comparison of extensometric results measured in the Vyhne Tidal Station (Slovakia) and in the Sopronbánfalva Geodynamic Observatory (Hungary)

Two extensometer stations have been set up at the margin of the Pannonian Basin to monitor tectonic movements as well as Earth tides and related phenomena. Because the Sopronbánfalva Geodynamic Observatory (SGO) in Hungary and the Vyhne Tidal Station (VTS) in Slovakia are located in different geological, topographic, and tectonic environments, the analysis and comparison of the extensometer data measured here provides a useful opportunity to interpret the observed data. The tectonic deformation at the SGO shows an average contraction of: −2.94 μstr y−1 (1 μstr is 10−6 relative deformation) which can be explained by the uplift of the Alps and the anticlockwise motion of the Adria microplate, causing compression in the Eastern Alps. At the VTS an average compression of −14.8 nstr y−1 (1 nstr is 10−9 relative deformation) was measured which can be explained by the NW compression direction in this area. The measured deformations in both observatories show a good agreement with the results of GPS measurements. The deformation at the VTS is characterized by small dilatation anomalies caused by the different topographic, tectonic environment and probably by the high heat flow in the area of the station. At this station the calculated amplitude factors for O1, P1, K1, M2 are 1.01482, 1.21691, 0.83173, 1.09392 and the ocean load corrected values are 1.10817, 1.35717, 0.92809, 1.28812, respectively. At the SGO the calculated amplitude factors for the same tidal components are 0.58776, 0.38967, 0.41548, 1.00564 and the ocean load corrected values are 0.98893, 1.89117, 1.00430, 1.04962, respectively. These results show that the effect of the ocean tide loading is greater at Sopronbánfalva, than at Vyhne. Based on the comparison, we can say that the result of the local strain measurement can be considered realistic.

Simulation and Prediction of the Groundwater Pollution Caused by the Leakage from a Sewage Plant in an Aluminum Factory Under the Action of Ocean Tide Support

In order to predict the impact of wastewater from an aluminum plant treatment station on the groundwater environment under abnormal conditions (i.e., sewage leakage accident). Through the investigation of hydrogeological conditions, and then the permeability coefficient of the aquifer was measured through borehole injection tests. Finally, the groundwater pollution transport halo was obtained by numerical simulation based GMS software. The simulation results showed that the groundwater aquifer will be seriously polluted by COD and fluoride (F-) after the sudden sewage seepage accident. What’s more, the simulation results showed that the pollution concentration is getting higher and higher with time, which is analyzed to be caused by the small permeability of the water-bearing medium in the aquifer and the groundwater flow field was supported by seawater tide.

An Advanced Dynamic Visualization Method of Global Ocean Tide with Multi-core Processor Based on OpenGL

In terms of ocean tide visualization, to meet the requirement of both display range and operational efficiency, an advanced method is proposed, in which the tide height is rapidly computed with global tide model EOT10a, and dynamically displayed by OpenGL. Aiming at the large amounts of calculation of global tide height, the feature of multicore processor is integrated into the method. The experiment shows that, compared to a single-core processor, when using a 6-core processor, the speedup ratio is about 5.4, parallel efficiency reaches 90%, and 880 000 tide heights can be calculated per second. Eventually, the result would be output as a tide height graph by OpenGL. This method could be a useful tool for marine cartography due to the large display range and the high efficiency.

A COMPARISON BETWEEN TIDAL CONSTITUENTS DERIVED FROM SATELLITE ALTIMETRY AND IN-SITU DATA AROUND PENINSULAR MALAYSIA

Satellite altimetry technology has been widely used in exploring Earth’s Ocean activities. Achieving a remarkable accuracy in measuring sea level for ocean tide analysis has led the local researchers to investigate more details on tidal behaviour in the regional area. This study is an attempt to assess the reliability of derived tidal constituents between satellite radar altimetry and in-situ data which is referred to as coastal tide gauges. Three satellite missions denoted as TOPEX class missions namely TOPEX, Jason-1, and Jason-2 were used to derive along-track sea surface height (SSH) time series over 23 years. Besides, four selected coastal tide gauges were used for tidal analysis and validation where the tidal data have at least 19 years of hourly observation. Derivation of tidal constituents from both satellite altimetry and tide gauges were executed by adopting the harmonic analysis method. The comparisons were made by calculating the Root Mean Square Misfit (RMSmisfit) of each tidal constituent between the nearest altimetry point to the tide gauges. After RMSmisfit, Root Sum Square (RSS) values of tidal constituents at each tide gauge were also calculated. The results displayed the RMSmisfit of tidal constituents agreed well with the selected tide gauges which are within 10 cm except for M2 constituents which recorded 10.2 cm. Pelabuhan Kelang tide gauge station showed the highest RSS value followed by Pulau Langkawi which recorded 21.2 cm and 9.8 cm, respectively. In conclusion, overall results can be inferred that the satellite-derived tidal constituents are likely to have good agreement with the selected tide gauge stations. Nevertheless, further analysis should be executed in determining high precision satellite-derived tidal constituents, especially in the complex regional area.

The sensitivity of ocean tide loading displacements to the structure of the upper mantle and crust of Taiwan Island

Ocean tide loading (OTL) displacements are sensitive to the shallow structure of the solid Earth; hence, the high-resolution spatial pattern of OTL displacement can provide knowledge to constrain the shallow Earth structure, especially in coastal areas. In this study, we investigate the sensitivity of the modeled M2 OTL displacement over Taiwan Island to perturbations of three physical quantities, namely, the density, bulk modulus, and shear modulus in the upper mantle and crust. Then, we compare the sensitivity of the modeled M2 OTL displacement to Earth models with the sensitivity to ocean tide models using root mean square (RMS) differences. We compute the displacement Green’s function and OTL displacement relative to the center of mass of the solid Earth (CE) reference frame, analyze the sensitivity to the three physical quantities in the CRUST1.0 model and the Preliminary Reference Earth Model (PREM), and present their spatial patterns. We find that displacement Green’s functions and OTL displacements are more sensitive to the two elastic moduli than the density in the upper mantle and crust. Moreover, their distinctive sensitivity patterns suggest that the three physical quantities might be constrained independently. The specific relationships between the perturbed structural depths and the distance ranges of peak sensitivities from the observation points to the coastline revealed by the shear modulus can mitigate the nonuniqueness problem in inversion. In particular, the horizontal tidal components observed by the Global Positioning System (GPS) can yield better results in inversions than the vertical component owing to the smaller OTL model errors and the higher structural sensitivity (except for the shear modulus in the asthenosphere).