Flexible Asymmetric Supercapacitors with Extremely Slow Self‐Discharge Rate Enabled by a Bilayer Heterostructure Polymer Electrolyte

2021 ◽  
pp. 2108794
Author(s):  
Jun Wan ◽  
Tian Lv ◽  
Yanan Liu ◽  
Xue Wang ◽  
Yunlong Yang ◽  
...  
Keyword(s):  
Polymer Electrolyte ◽  
Discharge Rate ◽  
Asymmetric Supercapacitors

Effect of High Salt Concentration on Ion Clustering and Transport in Polymer Solid Electrolytes: a Molecular Dynamics Study of PEO-LiTFSI

2018 ◽  
Author(s):  
Nicola Molinari ◽  
Jonathan P. Mailoa ◽  
Boris Kozinsky
Keyword(s):  
Polymer Electrolyte ◽  
Salt Concentration ◽  
Rational Design ◽  
Material System ◽  
Ion Dynamics ◽  
High Concentration ◽  
Anion Clusters ◽  
Poly Ethylene Oxide ◽  
Poly Ethylene

<div> <div> <div> <p>The model and analysis methods developed in this work are generally applicable to any polymer electrolyte/cation-anion combination, but we focus on the currently most prominent polymer electrolyte material system: poly(ethylene) oxide/Li- bis(trifluoromethane) sulfonamide (PEO + LiTFSI). The obtained results are surprising and challenge the conventional understanding of ionic transport in polymer electrolytes: the investigation of a technologically relevant salt concentration range (1 - 4 M) revealed the central role of the anion in coordinating and hindering Li ion movement. Our results provide insights into correlated ion dynamics, at the same time enabling rational design of better PEO-based electrolytes. In particular, we report the following novel observations. 1. Strong binding of the Li cation with the polymer competes with significant correlation of the cation with the salt anion. 2. The appearance of cation-anion clusters, especially at high concentration. 3. The asymmetry in the composition (and therefore charge) of such clusters; specifically, we find the tendency for clusters to have a higher number of anions than cations.</p> </div> </div> </div>

Effect of High Salt Concentration on Ion Clustering and Transport in Polymer Solid Electrolytes: a Molecular Dynamics Study of PEO-LiTFSI

2018 ◽  
Author(s):  
Nicola Molinari ◽  
Jonathan P. Mailoa ◽  
Boris Kozinsky
Keyword(s):  
Polymer Electrolyte ◽  
Salt Concentration ◽  
Rational Design ◽  
Material System ◽  
Ion Dynamics ◽  
High Concentration ◽  
Anion Clusters ◽  
Poly Ethylene Oxide ◽  
Poly Ethylene

<div> <div> <div> <p>The model and analysis methods developed in this work are generally applicable to any polymer electrolyte/cation-anion combination, but we focus on the currently most prominent polymer electrolyte material system: poly(ethylene) oxide/Li- bis(trifluoromethane) sulfonamide (PEO + LiTFSI). The obtained results are surprising and challenge the conventional understanding of ionic transport in polymer electrolytes: the investigation of a technologically relevant salt concentration range (1 - 4 M) revealed the central role of the anion in coordinating and hindering Li ion movement. Our results provide insights into correlated ion dynamics, at the same time enabling rational design of better PEO-based electrolytes. In particular, we report the following novel observations. 1. Strong binding of the Li cation with the polymer competes with significant correlation of the cation with the salt anion. 2. The appearance of cation-anion clusters, especially at high concentration. 3. The asymmetry in the composition (and therefore charge) of such clusters; specifically, we find the tendency for clusters to have a higher number of anions than cations.</p> </div> </div> </div>

Ambient Temperature Solid Polymer Electrolyte Devices

1990 ◽  
Author(s):  
P. S. Prasad ◽  
M. Z. Munshi ◽  
B. B. Owens ◽  
W. H. Smyri
Keyword(s):  
Ambient Temperature ◽  
Polymer Electrolyte ◽  
Solid Polymer Electrolyte ◽  
Solid Polymer

A New Life for the St. Croix River

1988 ◽  
Vol 23 (4) ◽  
pp. 568-577
Author(s):  
Harold S. Bailey
Keyword(s):  
Water Quality ◽  
Dissolved Oxygen ◽  
Discharge Rate ◽  
Paper Mill ◽  
Regulated River ◽  
Secondary Treatment ◽  
Pulp And Paper Mill ◽  
Oxygen Regime ◽  
Oxygen Concentrations

Abstract The water quality of the upper 110 kilometres of the St. Croix River is considered to be pristine. A major industrial discharge renders the lower 14 kilometres of the river a water quality limited segment. Prior to 1970 the Georgia-Pacific Pulp and Paper Mill at Woodland, Maine, discharged untreated effluent directly into the river causing dissolved oxygen concentrations to drop well below 5 mg/L, the objective chosen in the interest of restoring endemic fish populations. Since 1972, the Mill has installed primary and secondary treatment, regulated river discharge rate and effluent composition which has greatly improved the summer dissolved oxygen regime. By 1980, dissolved oxygen concentrations were generally above 5.0 mg/L and restocking the river with Atlantic Salmon (Salmo salar) was initiated.

Development of small polymer electrolyte fuel cell stacks

1996 ◽  
Author(s):  
V A Paganin ◽  
E A Ticianelli ◽  
E R Gonzalez
Keyword(s):  
Fuel Cell ◽  
Polymer Electrolyte ◽  
Polymer Electrolyte Fuel Cell

Conductivity, Dielectric and Modulus study of NH4PF6 based Zwitterionic polymer electrolyte

2020 ◽  
Vol 13 ◽  
Author(s):  
Manindra Kumar ◽  
Neelabh Srivastava
Keyword(s):  
Polymer Electrolyte ◽  
Power Law ◽  
Loss Tangent ◽  
Electric Modulus ◽  
Relaxation Behavior ◽  
Conductivity Data ◽  
Frequency Range ◽  
Zwitterionic Polymer ◽  
Power Law Equation ◽  
Jonscher’S Power Law

Background and Objective: Zwitterionic polymer electrolyte has been successfully synthesized using NH4PF6 salt. The conductivity of the synthesized polymer membrane is found to be of the order of 10-3Scm-1. Dielectric and Modulus properties of the polymer electrolyte have also been studied which showed well relaxation peaks with both temperature and salt concentrations. Result: This is well depicted with the loss tangent curve. Debye type relaxation behavior has observed from the electric modulus. Conclusion: Frequency dependent conductivity data (fitted with Jonscher's power law equation) confirmed the presence of NCL/SLPL type behavior in the studied frequency range.

Frequency Modulation of Motor Unit Discharge Has Task-Dependent Effects on Fluctuations in Motor Output

2005 ◽  
Vol 94 (4) ◽  
pp. 2878-2887 ◽  
Author(s):  
Carol J. Mottram ◽  
Evangelos A. Christou ◽  
François G. Meyer ◽  
Roger M. Enoka
Keyword(s):  
Motor Unit ◽  
Frequency Modulation ◽  
Discharge Rate ◽  
Motor Output ◽  
Unit Discharge ◽  
Rate Of Increase ◽  
Output Force ◽  
Position Task ◽  
Motor Unit Discharge ◽  
Target Force

The rate of change in the fluctuations in motor output differs during the performance of fatiguing contractions that involve different types of loads. The purpose of this study was to examine the contribution of frequency modulation of motor unit discharge to the fluctuations in the motor output during sustained contractions with the force and position tasks. In separate tests with the upper arm vertical and the elbow flexed to 1.57 rad, the seated subjects maintained either a constant upward force at the wrist (force task) or a constant elbow angle (position task). The force and position tasks were performed in random order at a target force equal to 3.6 ± 2.1% (mean ± SD) of the maximal voluntary contraction (MVC) force above the recruitment threshold of an isolated motor unit from the biceps brachii. Each subject maintained the two tasks for an identical duration (161 ± 93 s) at a mean target force of 22.4 ± 13.6% MVC. As expected, the rate of increase in the fluctuations in motor output (force task: SD for detrended force; position task: SD for vertical acceleration) was greater for the position task than the force task ( P < 0.001). The amplitude of the coefficient of variation (CV) and the power spectra for motor unit discharge were similar between tasks ( P > 0.1) and did not change with time ( P > 0.1), and could not explain the different rates of increase in motor output fluctuations for the two tasks. Nonetheless, frequency modulation of motor unit discharge differed during the two tasks and predicted ( P < 0.001) both the CV for discharge rate (force task: 1–3, 12–13, and 14–15 Hz; position task: 0–1, and 1–2 Hz) and the fluctuations in motor output (force task: 5–6, 9–10, 12–13, and 14–15 Hz; position task: 6–7, 14–15, 17–19, 20–21, and 23–24 Hz). Frequency modulation of motor unit discharge rate differed for the force and position tasks and influenced the ability to sustain steady contractions.

Sign in / Sign up

Export Citation Format

Share Document