scholarly journals Signature of fault zone deformation in near-surface soil visible in shear wave seismic reflections

2013 ◽  
Vol 40 (6) ◽  
pp. 1074-1078 ◽  
Author(s):  
Ranajit Ghose ◽  
Joao Carvalho ◽  
Afonso Loureiro
Keyword(s):  
Shear Wave ◽  
Fault Zone ◽  
Surface Soil ◽  
Near Surface ◽  
Seismic Reflections ◽  
Zone Deformation

High-frequency borehole seismograms recorded in the San Jacinto Fault zone, Southern California. Part 1. Polarizations

1991 ◽  
Vol 81 (4) ◽  
pp. 1057-1080 ◽  
Author(s):  
Richard C. Aster ◽  
Peter M. Shearer
Keyword(s):  
Shear Wave ◽  
Fault Zone ◽  
Particle Motion ◽  
Southern California ◽  
Shear Waves ◽  
P Wave ◽  
S Wave ◽  
Near Surface ◽  
San Jacinto Fault ◽  
San Jacinto Fault Zone

Abstract Two borehole seismometer arrays (KNW-BH and PFO-BH) have been established in the Southern California Batholith region of the San Jacinto Fault zone by the U.S. Geological Survey. The sites are within 0.4 km of Anza network surface stations and have three-component seismometers deployed at 300 m depth, at 150 m depth, and at the surface. Downhole horizontal seismometers can be oriented to an accuracy of about 5° using regional and near-regional initial P-wave particle motions. Shear waves recorded downhole at the KNW-BH indicate that the strong alignment of initial S-wave particle motions previously observed at the (surface) KNW Anza site (KNW-AZ) is not generated in the near-surface weathered layer. The KNW-BH surface instrument, which sits atop a highly weathered zone, displays a significantly different (≈ 20°) initial S-wave polarization direction from that observed downhole and at KNW-AZ, which is bolted to an outcrop. Although downhole initial shear-wave particle motion directions are consistent with a shear-wave splitting hypothesis, observations of orthogonally polarized slow shear waves are generally elusive, even in seismograms recorded at 300 m. A cross-correlation measure of the apparent relative velocities of Sfast and Sslow horizontally polarized S waves suggests shallow shear-wave anisotropy, consistent with the observed initial S-wave particle motion direction, of 2.3 ± 1.7 per cent between 300 and 150 m and 7.5 ± 3.5 per cent between 150 and 0 m.

scholarly journals Calibrating a new attenuation curve for the Dead Sea region using surface wave dispersion surveys in sites damaged by the 1927 Jericho earthquake

Solid Earth ◽  
2019 ◽  
Vol 10 (2) ◽  
pp. 379-390 ◽  
Author(s):  
Yaniv Darvasi ◽  
Amotz Agnon
Keyword(s):  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Dead Sea ◽  
Attenuation Curve ◽  
Surface Wave Dispersion ◽  
Near Surface ◽  
Moderate Seismicity ◽  
Local Point ◽  
The Dead

Abstract. Instrumental strong motion data are not common around the Dead Sea region. Therefore, calibrating a new attenuation equation is a considerable challenge. However, the Holy Land has a remarkable historical archive, attesting to numerous regional and local earthquakes. Combining the historical record with new seismic measurements will improve the regional equation. On 11 July 1927, a rupture, in the crust in proximity to the northern Dead Sea, generated a moderate 6.2 ML earthquake. Up to 500 people were killed, and extensive destruction was recorded, even as far as 150 km from the focus. We consider local near-surface properties, in particular, the shear-wave velocity, as an amplification factor. Where the shear-wave velocity is low, the seismic intensity far from the focus would likely be greater than expected from a standard attenuation curve. In this work, we used the multichannel analysis of surface waves (MASW) method to estimate seismic wave velocity at anomalous sites in Israel in order to calibrate a new attenuation equation for the Dead Sea region. Our new attenuation equation contains a term which quantifies only lithological effects, while factors such as building quality, foundation depth, topography, earthquake directivity, type of fault, etc. remain out of our scope. Nonetheless, about 60 % of the measured anomalous sites fit expectations; therefore, this new ground-motion prediction equation (GMPE) is statistically better than the old ones. From our local point of view, this is the first time that integration of the 1927 historical data and modern shear-wave velocity profile measurements improved the attenuation equation (sometimes referred to as the attenuation relation) for the Dead Sea region. In the wider context, regions of low-to-moderate seismicity should use macroseismic earthquake data, together with modern measurements, in order to better estimate the peak ground acceleration or the seismic intensities to be caused by future earthquakes. This integration will conceivably lead to a better mitigation of damage from future earthquakes and should improve maps of seismic hazard.

Influence of Acacia Trees on Near‐Surface Soil Hydraulic Properties in Arid Tunisia

2014 ◽  
Vol 27 (8) ◽  
pp. 1805-1812 ◽  
Author(s):  
Maarten De Boever ◽  
Donald Gabriels ◽  
Mohamed Ouessar ◽  
Wim Cornelis
Keyword(s):  
Hydraulic Properties ◽  
Surface Soil ◽  
Soil Hydraulic Properties ◽  
Near Surface ◽  
Soil Hydraulic

Cover crop effects on soil temperature in a clay loam soil in southwestern Ontario

2021 ◽  
pp. 1-10
Author(s):  
X.M. Yang ◽  
W.D. Reynolds ◽  
C.F. Drury ◽  
M.D. Reeb
Keyword(s):  
Soil Temperature ◽  
Cover Crops ◽  
Environmental Performance ◽  
Cover Crop ◽  
Crop Production ◽  
Surface Soil ◽  
Clay Loam ◽  
Near Surface ◽  
Soil Temperatures ◽  
Surface Soil Temperature

Although it is well established that soil temperature has substantial effects on the agri-environmental performance of crop production, little is known of soil temperatures under living cover crops. Consequently, soil temperatures under a crimson clover and white clover mix, hairy vetch, and red clover were measured for a cool, humid Brookston clay loam under a corn–soybean–winter wheat/cover crop rotation. Measurements were collected from August (after cover crop seeding) to the following May (before cover crop termination) at 15, 30, 45, and 60 cm depths during 2018–2019 and 2019–2020. Average soil temperatures (August–May) were not affected by cover crop species at any depth, or by air temperature at 60 cm depth. During winter, soil temperatures at 15, 30, and 45 cm depths were greater under cover crops than under a no cover crop control (CK), with maximum increase occurring at 15 cm on 31 January 2019 (2.5–5.7 °C) and on 23 January 2020 (0.8–1.9 °C). In spring, soil temperatures under standing cover crops were cooler than the CK by 0.1–3.0 °C at 15 cm depth, by 0–2.4 °C at the 30 and 45 cm depths, and by 0–1.8 °C at 60 cm depth. In addition, springtime soil temperature at 15 cm depth decreased by about 0.24 °C for every 1 Mg·ha−1 increase in live cover crop biomass. Relative to bare soil, cover crops increased near-surface soil temperature during winter but decreased near-surface soil temperature during spring. These temperature changes may have both positive and negative effects on the agri-environmental performance of crop production.

Sign in / Sign up

Export Citation Format

Share Document