Morphological and porosity changes in primary enamel surface after an in vitro demineralization model

Author(s):  
Arlete González‐Sotelo ◽  
Rosalía Contreras‐Bulnes ◽  
Laura Emma Rodríguez‐Vilchis ◽  
María Angeles Moyaho‐Bernal ◽  
Efraín Rubio‐Rosas ◽  
...  
2018 ◽  
Vol 69 (7) ◽  
pp. 1714-1717
Author(s):  
Roxana Ionela Vasluianu ◽  
Norina Consuela Forna ◽  
Elena Raluca Baciu ◽  
Mirela Zaltariov ◽  
Lavinia Vasiliu ◽  
...  

The anti-erosion effect of fluoride on the enamel surface was investigated by ATR-FTIR, SEM and EDX techniques. Four extracted teeth (two incisors and two premolars) were initially bleached with carabamide peroxide and etched with ortho-phosphoric acid then fluoride treatment was applied. Significant differences in enamel composition and morphology were observed providing the effect of fluoride application in remineralization of teeth. Infrared spectroscopy was employed to probe the changes in enamel structure. Scanning electron microscopy/energy dispersive X-ray spectroscopy analysis revealed higher content in F of teeth enamel. Morphology changes revealed a re-mineralization of enamel surface after the treatment with fluoride gel.


2015 ◽  
Vol 24 (5) ◽  
pp. 451-457 ◽  
Author(s):  
Radomir Barac ◽  
Jovanka Gasic ◽  
Natasa Trutic ◽  
Slavica Sunaric ◽  
Jelena Popovic ◽  
...  

2016 ◽  
Vol 10 (1) ◽  
pp. 69-78 ◽  
Author(s):  
Horieh Moosavi ◽  
Fatemeh Darvishzadeh

Objectives: This study investigated the effects of post bleaching treatments to prevent restaining and the change of enamel surface microhardness after dental bleaching in vitro. Methods: Sixty intact human incisor teeth were stained in tea solution and randomly assigned into four groups (n=15). Then samples were bleached for two weeks (8 hours daily) by 15% carbamide peroxide. Tooth color was determined both with a spectrophotometer and visually before bleaching (T1) and immediately after bleaching (T2). Next, it was applied in group 1 fluoride (Naf 2%) gel for 2 minutes, and in group 2 a fractional CO2 laser (10 mJ, 200 Hz, 10 s), and in group 3, nanohydroxyapatite gel for 2 minutes. The bleached teeth in group 4 remained untreated (control group). Then teeth placed in tea solution again. Color examinations were repeated after various post bleaching treatments (T3) and restaining with tea (T4) and color change values recorded. The microhardness was measured at the enamel surface of samples. Data was analyzed using ANOVA, Tukey HSD test and Dunnett T3 (α = 0.05). Results: Directly after bleaching (ΔE T3-T2), the treatment with nanohydroxyapatite showed significantly the least color lapse in colorimetric evaluation. In experimental groups, the color change between T3 and T4 stages (ΔE T4-T3) was significantly lower than control group (P < 0.05). Different methods of enamel treatment caused a significant increase in surface microhardness compared to control group (P < 0.05). Significance: Application of fluoride, fractional CO2 laser and nanohydroxyapatite as post bleaching treatments are suggested for prevention of stain absorption and increasing the hardening of bleached enamel.


PeerJ ◽  
2016 ◽  
Vol 4 ◽  
pp. e2458 ◽  
Author(s):  
Bruna Raquel Zancopé ◽  
Vanessa B. Dainezi ◽  
Marinês Nobre-dos-Santos ◽  
Sillas Duarte ◽  
Vanessa Pardi ◽  
...  

BackgroundA carbon dioxide (CO2) laser has been used to morphologically and chemically modify the dental enamel surface as well as to make it more resistant to demineralization. Despite a variety of experiments demonstrating the inhibitory effect of a CO2laser in reduce enamel demineralization, little is known about the effect of surface irradiated on bacterial growth. Thus, this in vitro study was preformed to evaluate the biofilm formation on enamel previously irradiated with a CO2laser (λ = 10.6 µM).MethodsFor this in vitro study, 96 specimens of bovine enamel were employed, which were divided into two groups (n = 48): 1) Control-non-irradiated surface and 2) Irradiated enamel surface. Biofilms were grown on the enamel specimens by one, three and five days under intermittent cariogenic condition in the irradiated and non-irradiated surface. In each assessment time, the biofilm were evaluated by dry weigh, counting the number of viable colonies and, in fifth day, were evaluated by polysaccharides analysis, quantitative real time Polymerase Chain Reaction (PCR) as well as by contact angle. In addition, the morphology of biofilms was characterized by fluorescence microscopy and field emission scanning electron microscopy (FESEM). Initially, the assumptions of equal variances and normal distribution of errors were conferred and the results are analyzed statistically by t-test and Mann Whitney test.ResultsThe mean of log CFU/mL obtained for the one-day biofilm evaluation showed that there is statistical difference between the experimental groups. When biofilms were exposed to the CO2laser, CFU/mL and CFU/dry weight in three day was reduced significantly compared with control group. The difference in the genes expression (Glucosyltransferases (gtfB) and Glucan-binding protein (gbpB)) and polysaccharides was not statically significant. Contact angle was increased relative to control when the surface was irradiated with the CO2laser. Similar morphology was also visible with both treatments; however, the irradiated group revealed evidence of melting and fusion in the specimens.ConclusionIn conclusion, CO2laser irradiation modifies the energy surface and disrupts the initial biofilm formation.


Sign in / Sign up

Export Citation Format

Share Document