scholarly journals Regression Methods for Detecting Anomalies in Flue Gas Desulphurization Installations in Coal-Fired Power Plants Based on Sensor Data

Author(s):  
Marek Moleda ◽  
Alina Momot ◽  
Dariusz Mrozek
Complexity ◽  
2020 ◽  
Vol 2020 ◽  
pp. 1-17
Author(s):  
Xiaoli Li ◽  
Quanbo Liu ◽  
Kang Wang ◽  
Fuqiang Wang ◽  
Guimei Cui ◽  
...  

Sulphur dioxide, as one of the most common air pollutant gases, brings considerable numbers of hazards on human health and environment. For the purpose of reducing the detrimental effect it brings, it is of urgent necessity to control emissions of flue gas in power plants, since a substantial proportion of sulphur dioxide in the atmosphere stems from flue gas generated in the whole process of electricity generation. However, the complexity and nondeterminism of the environment increase the occurrences of anomalies in practical flue gas desulphurization system. Anomalies in industrial desulphurization system would induce severe consequences and pose challenges for high-performance control with classical control strategies. In this article, based on process data sampled from 1000 MW unit flue gas desulphurization system in a coal-fired power plant, a multimodel control strategy with multilayer parallel dynamic neural network (MPDNN) is utilized to address the control problem in the context of different anomalies. In addition, simulation results indicate the applicability and effectiveness of the proposed control method by comparing with different cases.


2020 ◽  
Vol 08 (11) ◽  
pp. 1-11
Author(s):  
Gang Tian ◽  
Hongyan Long ◽  
Yu Liu ◽  
Chen Zhang ◽  
Fan Zhang ◽  
...  

2019 ◽  
Vol 70 (6) ◽  
pp. 1908-1910
Author(s):  
Irina Pincovschi ◽  
Cristina Modrogan

Understanding the absorption behaviour of sulphur dioxide in aqueous electrolyte solutions is of major interest for the design of flue gas desulphurization processes, as for example wet flue gas desulphurization of coal fired power plants or municipal solid waste incineration plants. In the present paper the influence of the water salinity on SO2 absorption is studied. The SO2 absortion was performed in equilibrium condition. The variation of marine solubility from 10 g/L to 40 g/L determines the variation of SO2 concentration in water from 2.6 mol/L to about 3.2 mol/L. In consequence, the variation of water salinity in these limits can detemine a quite big difference of water pollution.


TAPPI Journal ◽  
2014 ◽  
Vol 13 (8) ◽  
pp. 65-78 ◽  
Author(s):  
W.B.A. (SANDY) SHARP ◽  
W.J. JIM FREDERICK ◽  
JAMES R. KEISER ◽  
DOUGLAS L. SINGBEIL

The efficiencies of biomass-fueled power plants are much lower than those of coal-fueled plants because they restrict their exit steam temperatures to inhibit fireside corrosion of superheater tubes. However, restricting the temperature of a given mass of steam produced by a biomass boiler decreases the amount of power that can be generated from this steam in the turbine generator. This paper examines the relationship between the temperature of superheated steam produced by a boiler and the quantity of power that it can generate. The thermodynamic basis for this relationship is presented, and the value of the additional power that could be generated by operating with higher superheated steam temperatures is estimated. Calculations are presented for five plants that produce both steam and power. Two are powered by black liquor recovery boilers and three by wood-fired boilers. Steam generation parameters for these plants were supplied by industrial partners. Calculations using thermodynamics-based plant simulation software show that the value of the increased power that could be generated in these units by increasing superheated steam temperatures 100°C above current operating conditions ranges between US$2,410,000 and US$11,180,000 per year. The costs and benefits of achieving higher superheated steam conditions in an individual boiler depend on local plant conditions and the price of power. However, the magnitude of the increased power that can be generated by increasing superheated steam temperatures is so great that it appears to justify the cost of corrosion-mitigation methods such as installing corrosion-resistant materials costing far more than current superheater alloys; redesigning biomassfueled boilers to remove the superheater from the flue gas path; or adding chemicals to remove corrosive constituents from the flue gas. The most economic pathways to higher steam temperatures will very likely involve combinations of these methods. Particularly attractive approaches include installing more corrosion-resistant alloys in the hottest superheater locations, and relocating the superheater from the flue gas path to an externally-fired location or to the loop seal of a circulating fluidized bed boiler.


Sign in / Sign up

Export Citation Format

Share Document