Seismic Tomography of the Lithosphere with Body Waves

2003 ◽  
pp. 717-737
Author(s):  
Clifford H. Thurber
Keyword(s):  
Seismic Tomography ◽  
Body Waves

Seismic cone penetration test and seismic tomography in permafrost

2004 ◽  
Vol 41 (5) ◽  
pp. 796-813 ◽  
Author(s):  
Anne-Marie LeBlanc ◽  
Richard Fortier ◽  
Michel Allard ◽  
Calin Cosma ◽  
Sylvie Buteau
Keyword(s):  
Seismic Tomography ◽  
Dynamic Properties ◽  
Cone Penetration Test ◽  
The Body ◽  
Body Waves ◽  
Reconstruction Technique ◽  
Seismic Velocities ◽  
Penetration Test ◽  
Cone Penetration ◽  
Seismic Cone Penetration Test

Two high-resolution multi-offset vertical seismic profile (VSP) surveys were carried out in a permafrost mound near Umiujaq in northern Quebec, Canada, while performing seismic cone penetration tests (SCPT) to study the cryostratigraphy and assess the body waves velocities and the dynamic properties of warm permafrost. Penetrometer-mounted triaxial accelerometers were used as the VSP receivers, and a swept impact seismic technique (SIST) source generating both compressional and shear waves was moved near the surface following a cross configuration of 40 seismic shot-point locations surrounding each of the two SCPTs. The inversion of travel times based on a simultaneous iterative reconstruction technique (SIRT) provided tomographic images of the distribution of seismic velocities in permafrost. The Young's and shear moduli at low strains were then calculated from the seismic velocities and the permafrost density measured on core samples. The combination of multi-offset VSP survey, SCPT, SIST, and SIRT for tomographic imaging led to new insights in the dynamic properties of permafrost at temperatures close to 0 °C. The P- and S-wave velocities in permafrost vary from 2400 to 3200 m/s and from 900 to 1750 m/s, respectively, for a temperature range between –0.2 and –2.0 °C. The Young's modulus varies from 2.15 to 13.65 GPa, and the shear modulus varies from 1.00 to 4.75 GPa over the same range of temperature.Key words: permafrost, seismic cone penetration test, vertical seismic profiling, seismic tomography, dynamic properties.

Seismic Tomography of the Lithosphere with Body Waves

2003 ◽  
Vol 160 (3) ◽  
pp. 717-737 ◽  
Author(s):  
C. H. Thurber
Keyword(s):  
Seismic Tomography ◽  
Body Waves

Nonlinear traveltime inversion scheme for crosshole seismic tomography in tilted transversely isotropic media

Geophysics ◽  
2008 ◽  
Vol 73 (4) ◽  
pp. D17-D33 ◽  
Author(s):  
Bing Zhou ◽  
Stewart Greenhalgh ◽  
Alan Green
Keyword(s):  
Seismic Tomography ◽  
Velocity Structure ◽  
Body Wave ◽  
Transversely Isotropic ◽  
The Body ◽  
Body Waves ◽  
Inversion Method ◽  
Perturbation Equation ◽  
Transversely Isotropic Media ◽  
Isotropic Media

Crosshole seismic tomography often is applied to image the velocity structure of an interwell medium. If the rocks are anisotropic, the tomographic technique must be adapted to the complex situation; otherwise, it leads to a false interpretation. We propose a nonlinear kinematic inversion method for crosshole seismic tomography in composite transversely isotropic media with known dipping symmetry axes. This method is based on a new version of the first-order traveltime perturbation equation. It directly uses the derivative of the phase velocity rather than the eigenvectors of the body-wave modes to overcome the singularity problem for application to the two quasi-shear waves. We applied an iterative nonlinear solver incorporating our kinematic ray-tracing scheme and directly compute the Jacobian matrix in an arbitrary reference medium. This reconstructs the five elastic moduli or Thomsen parameters from the first-arrival traveltimes of the three seismic body waves (qP, qSV, qSH) in strongly and weakly anisotropic media. We conducted three synthetic experiments that involve determining anisotropic parameters for a homogeneous rock, reconstructing a fault embedded in a strongly anisotropic background, and imaging a complicated four-layer model containing a small channel and a buried dipping interface. We compared results of our nonlinear inversion method with isotropic tomography and the traditional linear anisotropic inversion scheme, which showed the capability and superiority of the new scheme for crosshole tomographic imaging.

scholarly journals Slithering CSF: Cerebrospinal Fluid Dynamics in the Stationary and Moving Viper Boa, Candoia aspera

Biology ◽  
2021 ◽  
Vol 10 (7) ◽  
pp. 672
Author(s):  
Bruce A. Young ◽  
Skye Greer ◽  
Michael Cramberg
Keyword(s):  
Cerebrospinal Fluid ◽  
Cardiac Cycle ◽  
Low Frequency ◽  
Mean Amplitude ◽  
The Body ◽  
Body Waves ◽  
Lower Amplitude ◽  
Lateral Undulation ◽  
Recovery From Anesthesia ◽  
The Relationship

In the viper boa (Candoia aspera), the cerebrospinal fluid (CSF) shows two stable overlapping patterns of pulsations: low-frequency (0.08 Hz) pulses with a mean amplitude of 4.1 mmHg that correspond to the ventilatory cycle, and higher-frequency (0.66 Hz) pulses with a mean amplitude of 1.2 mmHg that correspond to the cardiac cycle. Manual oscillations of anesthetized C. aspera induced propagating sinusoidal body waves. These waves resulted in a different pattern of CSF pulsations with frequencies corresponding to the displacement frequency of the body and with amplitudes greater than those of the cardiac or ventilatory cycles. After recovery from anesthesia, the snakes moved independently using lateral undulation and concertina locomotion. The episodes of lateral undulation produced similar influences on the CSF pressure as were observed during the manual oscillations, though the induced CSF pulsations were of lower amplitude during lateral undulation. No impact on the CSF was found while C. aspera was performing concertina locomotion. The relationship between the propagation of the body and the CSF pulsations suggests that the body movements produce an impulse on the spinal CSF.

scholarly journals Geophysical and analytical determination of overstressed zones in exploited coal seam: a case study

2021 ◽  
Author(s):  
Dariusz Chlebowski ◽  
Zbigniew Burtan
Keyword(s):  
Coal Seam ◽  
Wave Velocity ◽  
Seismic Tomography ◽  
Analytical Modeling ◽  
Coal Mines ◽  
Vertical Stress ◽  
P Wave ◽  
Rockburst Hazard ◽  
State Of Stress ◽  
P Wave Velocity

AbstractA variety of geophysical methods and analytical modeling are applied to determine the rockburst hazard in Polish coal mines. In particularly unfavorable local conditions, seismic profiling, active/passive seismic tomography, as well as analytical state of stress calculating methods are recommended. They are helpful in verifying the reliability of rockburst hazard forecasts. In the article, the combined analysis of the state of stress determined by active seismic tomography and analytical modeling was conducted taking into account the relationship between the location of stress concentration zones and the level of rockburst hazard. A longwall panel in the coal seam 501 at a depth of ca.700 m in one of the hard coal mines operating in the Upper Silesian Coal Basin was a subject of the analysis. The seismic tomography was applied for the reconstruction of P-wave velocity fields. The analytical modeling was used to calculate the vertical stress states basing on classical solutions offered by rock mechanics. The variability of the P-wave velocity field and location of seismic anomaly in the coal seam in relation to the calculated vertical stress field arising in the mined coal seam served to assess of rockburst hazard. The applied methods partially proved their adequacy in practical applications, providing valuable information on the design and performance of mining operations.

scholarly journals Studying the Depth Structure of the Kyrgyz Tien Shan by Using the Seismic Tomography and Magnetotelluric Sounding Methods

Geosciences ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 122
Author(s):  
Irina Medved ◽  
Elena Bataleva ◽  
Michael Buslov
Keyword(s):  
Seismic Tomography ◽  
High Velocity ◽  
Fault Zones ◽  
Magnetotelluric Sounding ◽  
Tien Shan ◽  
High Resistivity ◽  
Low Velocity ◽  
Low Resistivity ◽  
Velocity Models ◽  
Fluid Saturation

This paper presents new results of detailed seismic tomography (ST) on the deep structure beneath the Middle Tien Shan to a depth of 60 km. For a better understanding of the detected heterogeneities, the obtained velocity models were compared with the results of magnetotelluric sounding (MTS) along the Kekemeren and Naryn profiles, running parallel to the 74 and 76 meridians, respectively. We found that in the study region the velocity characteristics and geoelectric properties correlate with each other. The high-velocity high-resistivity anomalies correspond to the parts of the Tarim and Kazakhstan-Junggar plates submerged under the Tien Shan. We revealed that the structure of the Middle Tien Shan crust is conditioned by the presence of the Central Tien Shan microcontinent. It manifests itself as two anomalies lying one below the other: the lower low-velocity low-resistivity anomaly, and the upper high-velocity high-resistivity anomaly. The fault zones, limiting the Central Tien Shan microcontinent, appear as low-velocity low-resistivity anomalies. The obtained features indicate the fluid saturation of the fault zones. According to the revealed features of the Central Tien Shan geological structure, it is assumed that the lower-crustal low-velocity layer can play a significant role in the delamination of the mantle part of the submerged plates.

Sign in / Sign up

Export Citation Format

Share Document