Numerical Homogenization of Heterogeneous Anisotropic Linear Elastic Materials

Author(s):  
S. Margenov ◽  
S. Stoykov ◽  
Y. Vutov
1988 ◽  
Vol 55 (4) ◽  
pp. 814-817 ◽  
Author(s):  
Peter M. Anderson

Conditions are discussed for which the contact zone at the tip of a two-dimensional interface crack between anisotropic elastic materials is small. For such “small scale contact” conditions combined with small scale yielding conditions, a stress concentration vector uniquely characterizes the near tip field, and may be used as a crack growth parameter. Representative calculations for an interface crack on a representative Cu grain boundary show small contact conditions to prevail, except possibly under large shearing loads.


Author(s):  
Aanchal Yadav ◽  
R. U. Patil ◽  
S. K. Singh ◽  
R. K. Godara ◽  
Gagandeep Bhardwaj

2011 ◽  
Vol 16 (8) ◽  
pp. 833-871 ◽  
Author(s):  
Joseph McMahon ◽  
Alain Goriely ◽  
Michael Tabor

Morphoelasticity is the theory of growing elastic materials. The theory is based on the multiplicative decomposition of the deformation gradient and provides a formulation of the deformation and stresses induced by growth. Following a companion paper, a general theory of growing non-linear elastic Kirchhoff plate is described. First, a complete geometric description of incompatibility with simple examples is given. Second, the stability of growing Kirchhoff plates is analyzed.


2007 ◽  
Vol 567-568 ◽  
pp. 225-228 ◽  
Author(s):  
Luboš Náhlík ◽  
Lucie Šestáková ◽  
Pavel Hutař

The objective of the paper is to investigate the direction of a further crack propagation from the interface between two elastic materials. The angle of crack propagation changes when the crack passes the interface. The suggested procedure makes it possible to estimate an angle of propagation under which the crack will propagate into the second material. The assumptions of linear elastic fracture mechanics and elastic behavior of the body with interfaces are considered. The finite element method was used for numerical calculations. The results obtained might contribute to a better understanding of the failure of materials with interfaces (e.g. layered composites, materials with protective coatings) and to a more reliable estimation of the service life of such structures.


Sign in / Sign up

Export Citation Format

Share Document