Growth of transformed roots in a nutrient mist bioreactor: reactor performance and evaluation

1992 ◽  
Vol 37 (4) ◽  
Author(s):  
AlexanderA. Dilorio ◽  
RonaldD. Cheetham ◽  
PamelaJ. Weathers
1989 ◽  
Vol 34 (7) ◽  
pp. 711-711
Author(s):  
No authorship indicated

2013 ◽  
pp. 1000-1004
Author(s):  
M.A. Paya-Marin ◽  
J. B. P. Lim ◽  
B. Sen Gupta ◽  
R.M. Lawson

1998 ◽  
Vol 38 (4-5) ◽  
pp. 29-35 ◽  
Author(s):  
C. J. Banks ◽  
P. N. Humphreys

The stability and operational performance of single stage digestion with and without liquor recycle and two stage digestion were assessed using a mixture of paper and wood as the digestion substrate. Attempts to maintain stable digestion in both single stage reactors were unsuccessful due to the inherently low natural buffering capacity exhibited; this resulted in a rapid souring of the reactor due to unbuffered volatile fatty acid (VFA) accumulation. The use of lime to control pH was unsatisfactory due to interference with the carbonate/bicarbonate equilibrium resulting in wide oscillations in the control parameter. The two stage system overcame the pH stability problems allowing stable operation for a period of 200 days without any requirement for pH control; this was attributed to the rapid flushing of VFA from the first stage reactor into the second stage, where efficient conversion to methane was established. Reactor performance was judged to be satisfactory with the breakdown of 53% of influent volatile solids. It was concluded that the reactor configuration of the two stage system offers the potential for the treatment of cellulosic wastes with a sub-optimal carbon to nitrogen ratio for conventional digestion.


1997 ◽  
Vol 36 (6-7) ◽  
pp. 107-115 ◽  
Author(s):  
Gregory J. Wilson ◽  
Amid P. Khodadoust ◽  
Makram T. Suidan ◽  
Richard C. Brenner

An integrated reactor system has been developed to remediate pentachlorophenol (PCP) containing wastes using sequential anaerobic and aerobic biodegradation. Anaerobically, PCP was degraded to predominately equimolar concentrations (>99%) of monochlorophenol (MCP) in two GAC fluidized bed reactors at Empty Bed Contact Times (EBCTs) ranging from 18.6 to 1.15 hours. However, at lower EBCTs, MCP concentrations decreased to less than 10% of the influent PCP concentration suggesting mineralization. The optimal EBCT was determined to be 2.3 hours based on PCP conversion to MCPs and stable reactor operation. Decreasing the EBCT fourfold did not inhibit degradation of PCP and its intermediates, thus allowing removal of PCP at much lower detention time and resulting in a significant cost advantage. Analytical grade PCP was fed via syringe pumps into two fluidized bed reactors at influent concentrations of 100 mg/l and 200 mg/l, respectively. Acting as the primary substrate, ethanol was also fed into the reactors at concentrations of 697 and 1388 mg/l. Effluent PCP and chlorinated phenolic compounds were analyzed weekly to evaluate reactor performance. Biodegradation pathways were also identified. 3-chlorophenol (CP) was the predominant MCP and varied simultaneously with 3,5-dichlorophenol (DCP) concentrations. Likewise, 4-CP concentrations varied simultaneously with 3,4-DCP concentrations. A second stage aerobic GAC fluidized bed reactor was added after the anaerobic reactor to completely mineralize the remaining MCP and phenols. Data show no presence of phenol and MCP in the effluent or on the GAC. Overall, the chemical oxygen demand (COD) fed to the system was reduced from 75 g/d in the influent to less than 1.5 g/d in the effluent.


2020 ◽  
Vol 26 (24) ◽  
pp. 2817-2842
Author(s):  
Ewa Skała ◽  
Joanna Makowczyńska ◽  
Joanna Wieczfinska ◽  
Tomasz Kowalczyk ◽  
Przemysław Sitarek

Background: For a long time, the researchers have been looking for new efficient methods to enhance production and obtain valuable plant secondary metabolites, which would contribute to the protection of the natural environment through the preservation of various plant species, often rare and endangered. These possibilities offer plant in vitro cultures which can be performed under strictly-controlled conditions, regardless of the season or climate and environmental factors. Biotechnological methods are promising strategies for obtaining the valuable plant secondary metabolites with various classes of chemical compounds including caffeoylquinic acids (CQAs) and their derivatives. CQAs have been found in many plant species which are components in the daily diet and exhibit a wide spectrum of biological activities, including antioxidant, immunomodulatory, antihypertensive, analgesic, anti-inflammatory, hepato- and neuroprotective, anti-hyperglycemic, anticancer, antiviral and antimicrobial activities. They have also been found to offer protection against Alzheimer’s disease, and play a role in weight reduction and lipid metabolism control, as well as modulating the activity of glucose-6-phosphatase involved in glucose metabolism. Methods: This work presents the review of the recent advances in use in vitro cultures of various plant species for the alternative system to the production of CQAs and their derivatives. Production of the secondary metabolites in in vitro culture is usually performed with cell suspension or organ cultures, such as shoots and adventitious or transformed roots. To achieve high production of valuable secondary metabolites in in vitro cultures, the optimization of the culture condition is necessary with respect to both biomass accumulation and metabolite content. The optimization of the culture conditions can be achieved by choosing the type of medium, growth regulators or growth conditions, selection of high-productivity lines or culture period, supplementation of the culture medium with precursors or elicitor treatments. Cultivation for large-scale in bioreactors and genetic engineering: Agrobacterium rhizogenes transformation and expression improvement of transcriptional factor or genes involved in the secondary metabolite production pathway are also efficient strategies for enhancement of the valuable secondary metabolites. Results: Many studies have been reported to obtain highly productive plant in vitro cultures with respect to CQAs. Among these valuable secondary metabolites, the most abundant compound accumulated in in vitro cultures was 5-CQA (chlorogenic acid). Highly productive cultures with respect to this phenolic acid were Leonurus sibiricus AtPAP1 transgenic roots, Lonicera macranthoides and Eucomia ulmoides cell suspension cultures which accumulated above 20 mg g-1 DW 5-CQA. It is known that di- and triCQAs are less common in plants than monoCQAs, but it was also possible to obtain them by biotechnological methods. Conclusion: The results indicate that the various in vitro cultures of different plant species can be a profitable approach for the production of CQAs. In particular, an efficient production of these valuable compounds is possible by Lonicera macranthoides and Eucomia ulmoides cell suspension cultures, Leonurus sibiricus transformed roots and AtPAP1 transgenic roots, Echinacea angustifolia adventitious shoots, Rhaponticum carthamoides transformed plants, Lavandula viridis shoots, Sausera involucrata cell suspension and Cichorium intybus transformed roots.


1998 ◽  
Vol 63 (11) ◽  
pp. 1938-1944 ◽  
Author(s):  
Vratislav Tukač ◽  
Jiří Vokál ◽  
Jiří Hanika

Catalytic activity of CuO-supported catalyst in phenol oxidation, and the influence of reaction conditions, viz. temperature (125-170 °C), oxygen partial pressure (1-7 MPa) and liquid feed (30-760 ml h-1), in the continuous operation using 17.9 mm i.d. trickle-bed reactor is presented. The hydrodynamic impact on the three-phase trickle-bed reactor performance in an environmental application of catalytic wet oxidation was also investigated. The results of trickle-bed operation were strongly influenced by wetting efficiency. An insufficient catalyst wetting can be to compensated by filling the catalyst bed voids by fine glass spheres. In the case of the gas transfer limited reaction, a better wetting of the catalyst can lead to worse reactor performance due to lower reaction rates.


Author(s):  
Congjing Ren ◽  
Yao Yang ◽  
Zhengliang Huang ◽  
Jingyuan Sun ◽  
Yongrong Yang ◽  
...  

2021 ◽  
Vol 21 (1) ◽  
Author(s):  
Md. Toufiq Hassan Shawon ◽  
Shah Ali Akbar Ashrafi ◽  
Abul Kalam Azad ◽  
Sonja M. Firth ◽  
Hafizur Chowdhury ◽  
...  

Abstract Background In Bangladesh, a poorly functioning national system of registering deaths and determining their causes leaves the country without important information on which to inform health programming, particularly for the 85% of deaths that occur in the community. In 2017, an improved death registration system and automated verbal autopsy (VA) were introduced to 13 upazilas to assess the utility of VA as a routine source of policy-relevant information and to identify leading causes of deaths (COD) in rural Bangladesh. Methods Data from 22,535 VAs, collected in 12 upazilas between October 2017 and August 2019, were assigned a COD using the SmartVA Analyze 2.0 computer algorithm. The plausibility of the VA results was assessed using a series of demographic and epidemiological checks in the Verbal Autopsy Interpretation, Performance and Evaluation Resource (VIPER) software tool. Results Completeness of community death reporting was 65%. The vast majority (85%) of adult deaths were due to non-communicable diseases, with ischemic heart disease, stroke and chronic respiratory disease comprising about 60% alone. Leading COD were broadly consistent with Global Burden of Disease study estimates. Conclusions Routine VA collection using automated methods is feasible, can produce plausible results and provides critical information on community COD in Bangladesh. Routine VA and VIPER have potential application to countries with weak death registration systems.


Sign in / Sign up

Export Citation Format

Share Document