An x-Ray diffraction method of assessing local stress levels in coarse-grained sintered materials

1978 ◽  
Vol 17 (2) ◽  
pp. 137-140 ◽  
Author(s):  
I. I. Deryavko ◽  
A. G. Lanin ◽  
M. L. Taubin
Keyword(s):  
Diffraction Method ◽  
Local Stress ◽  
Coarse Grained ◽  
X Ray Diffraction ◽  
X Ray ◽  
Stress Levels ◽  
Sintered Materials

In Situ Three-Dimensional Orientation Mapping in Plastically-Deformed Polycrystalline Iron by Three-Dimensional X-Ray Diffraction

2014 ◽  
Vol 777 ◽  
pp. 118-123 ◽  
Author(s):  
Yujiro Hayashi ◽  
Yoshiharu Hirose ◽  
Daigo Setoyama
Keyword(s):  
Three Dimensional ◽  
Diffraction Method ◽  
Inverse Pole Figure ◽  
Coarse Grained ◽  
Uniaxial Tensile ◽  
X Ray Diffraction ◽  
Polycrystalline Iron ◽  
X Ray ◽  
Orientation Mapping

In situ three-dimensional crystallographic orientation mapping in plastically-deformed polycrystalline iron is demonstrated using a modified three-dimensional x-ray diffraction method. This voxel-by-voxel measurement method enables the observation of intragranular orientation distribution. The experiment is performed using coarse-grained ferrite with a mean grain size of ~ 60 μm and an incident x-ray beam with a beam size of 20 μm × 20 μm. Grains averagely rotate approximately toward the <110> preferred orientation of body-centered cubic uniaxial tensile texture. Intragranular orientation distributions are spread as the tensile strain increases to 10.7 %. Furthermore, intragranular multidirectional rotations are observed in grains near the <100> and <111> corners in the inverse pole figure.

scholarly journals Growth of sillenite Bi12FeO20 single crystals: structural, thermal, optical, photocatalytic features and first principle calculations

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Durga Sankar Vavilapalli ◽  
Ambrose A. Melvin ◽  
F. Bellarmine ◽  
Ramanjaneyulu Mannam ◽  
Srihari Velaga ◽  
...  
Keyword(s):  
Single Crystal ◽  
Single Crystals ◽  
Photoelectron Spectroscopy ◽  
Diffraction Method ◽  
Lattice Parameter ◽  
First Principle ◽  
X Ray Diffraction ◽  
X Ray ◽  
First Principle Calculations ◽  
Photodegradation Efficiency

AbstractIdeal sillenite type Bi12FeO20 (BFO) micron sized single crystals have been successfully grown via inexpensive hydrothermal method. The refined single crystal X-ray diffraction data reveals cubic Bi12FeO20 structure with single crystal parameters. Occurrence of rare Fe4+ state is identified via X-ray photoelectron spectroscopy (XPS) and X-ray absorption spectroscopy (XAS). The lattice parameter (a) and corresponding molar volume (Vm) of Bi12FeO20 have been measured in the temperature range of 30–700 °C by the X-ray diffraction method. The thermal expansion coefficient (α) 3.93 × 10–5 K−1 was calculated from the measured values of the parameters. Electronic structure and density of states are investigated by first principle calculations. Photoelectrochemical measurements on single crystals with bandgap of 2 eV reveal significant photo response. The photoactivity of as grown crystals were further investigated by degrading organic effluents such as Methylene blue (MB) and Congo red (CR) under natural sunlight. BFO showed photodegradation efficiency about 74.23% and 32.10% for degrading MB and CR respectively. Interesting morphology and microstructure of pointed spearhead like BFO crystals provide a new insight in designing and synthesizing multifunctional single crystals.

scholarly journals Study of Corrosion Resistance and Degradation Mechanisms in LiTiO2-Li2TiO3 Ceramic

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 753
Author(s):  
Dmitriy Shlimas ◽  
Artem L. Kozlovskiy ◽  
Maxim Zdorovets
Keyword(s):  
Degradation Mechanism ◽  
Diffraction Method ◽  
Large Mass ◽  
Time Frame ◽  
X Ray Diffraction ◽  
Acidic Media ◽  
X Ray ◽  
Mass Losses ◽  
The Stability ◽  
Thermal Sintering

The interest in lithium-containing ceramics is due to their huge potential as blanket materials for thermonuclear reactors for the accumulation of tritium. However, an important factor in their use is the preservation of the stability of their strength and structural properties when under the influence of external factors that determine the time frame of their operation. This paper presents the results of a study that investigated the influence of the LiTiO2 phase on the increasing resistance to degradation and corrosion of Li2TiO3 ceramic when exposed to aggressive acidic media. Using the X-ray diffraction method, it was found that an increase in the concentration of LiClO4·3H2O during synthesis leads to the formation of a cubic LiTiO2 phase in the structure as a result of thermal sintering of the samples. During corrosion tests, it was found that the presence of the LiTiO2 phase leads to a decrease in the degradation rate in acidic media by 20–70%, depending on the concentration of the phase. At the same time, and in contrast to the samples of Li2TiO3 ceramics, for which the mechanisms of degradation during a long stay in aggressive media are accompanied by large mass losses, for the samples containing the LiTiO2 phase, the main degradation mechanism is pitting corrosion with the formation of pitting inclusions.

Study of the quality of GaAs thin film on Si substrate by X-ray diffraction method

1990 ◽  
Vol 7 (7) ◽  
pp. 308-311
Author(s):  
Li Chaorong ◽  
Mai Zhenhong ◽  
Cui Shufan ◽  
Zhou Junming ◽  
Yutian Wang
Keyword(s):  
Thin Film ◽  
Diffraction Method ◽  
X Ray Diffraction ◽  
Si Substrate ◽  
X Ray

Direct Determination of Stress Levels in Sputtered Films by means of X-Ray Diffraction Topographic Method

1987 ◽  
Vol 26 (Part 1, No. 1) ◽  
pp. 157-161 ◽  
Author(s):  
Osamu Nittono ◽  
Yoshihiro Sadamoto ◽  
Sheng Kai Gong
Keyword(s):  
Direct Determination ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sputtered Films ◽  
Stress Levels
Sign in / Sign up

Export Citation Format

Share Document