Rotating hydromagnetic free shear layer flow for very large magnetic interaction parameter

1977 ◽  
Vol 85 (4) ◽  
pp. 218-229
Author(s):  
Somaraju Vempaty
1990 ◽  
Vol 68 (3) ◽  
pp. 284-292 ◽  
Author(s):  
Y. N. Joshi ◽  
A. J. J. Raassen ◽  
A. A. Van der Valk

The spectra of thallium, lead, and bismuth were photographed in the region 600–2000 Å using sliding spark and triggered spark sources. The (5d10 + 5d96s)–5d96p transitions in Tl IV, Pb V, and Bi VI were investigated. Earlier level values were revised and new lines were classified. Hyperfine structure splittings were observed for many lines in Tl IV and Bi VI. Least squares fitted calculations were done for each spectra. The deviations between the calculated and observed level values showed that parametric descriptions using only the spin-orbit magnetic interaction parameter to describe magnetic effects is not sufficient in the 5d-shell spectra.


1998 ◽  
Vol 358 ◽  
pp. 299-333 ◽  
Author(s):  
OLEG ZIKANOV ◽  
ANDRE THESS

The transformation of initially isotropic turbulent flow of electrically conducting incompressible viscous fluid under the influence of an imposed homogeneous magnetic field is investigated using direct numerical simulation. Under the assumption of large kinetic and small magnetic Reynolds numbers (magnetic Prandtl number Pm[Lt ]1) the quasi-static approximation is applied for the computation of the magnetic field fluctuations. The flow is assumed to be homogeneous and contained in a three-dimensional cubic box with periodic boundary conditions. Large-scale forcing is applied to maintain a statistically steady level of the flow energy. It is found that the pathway traversed by the flow transformation depends decisively on the magnetic interaction parameter (Stuart number). If the magnetic interaction number is small the flow remains three-dimensional and turbulent and no detectable deviation from isotropy is observed. In the case of a strong magnetic field (large magnetic interaction parameter) a rapid transformation to a purely two-dimensional steady state is obtained in agreement with earlier analytical and numerical results for decaying MHD turbulence. At intermediate values of the magnetic interaction parameter the system exhibits intermittent behaviour, characterized by organized quasi-two-dimensional evolution lasting several eddy-turnover times, which is interrupted by strong three-dimensional turbulent bursts. This result implies that the conventional picture of steady angular energy transfer in MHD turbulence must be refined. The spatial structure of the steady two-dimensional final flow obtained in the case of large magnetic interaction parameter is examined. It is found that due to the type of forcing and boundary conditions applied, this state always occurs in the form of a square periodic lattice of alternating vortices occupying the largest possible scale. The stability of this flow to three-dimensional perturbations is analysed using the energy stability method.


Author(s):  
Dhanalakshmi Challa ◽  
Joe Klewicki

Experiments are conducted to explore the structural mechanisms involved in the post-separation evolution of a wall-bounded to a free-shear turbulent flow. At the upstream, both the boundary layers are turbulent. Experiments were conducted in a two-stream shear-layer tunnel, under a zero axial pressure gradient shear-wake configuration. A velocity ratio near 2 was explored. Profile data were collected with a single wire probe at various locations downstream of the blunt separation lip. With this set of measurements, mean profile, axial intensity and measures of profile evolution indicate that the predominant shift from turbulent boundary layer to free shear-layer like behavior occurs between the downstream locations x/θ = 13.7 & 27.4, where θ is the upstream momentum deficit thickness on the low-speed stream. The shear wake width is observed to be nominally constant with the downstream position. Axial velocity spectra show that the transition from boundary layer flow to shear flow occurs earlier in high-speed stream when compared to low speed stream. Strouhal number, Sto, of initial vortex rollup based on initial momentum thickness was found to be 0.034, which is in very good agreement with the existing literature. Other measures are in good agreement with linear stability considerations found in the literature.


2017 ◽  
Vol 33 (3) ◽  
pp. 375-386
Author(s):  
S. P. Anjali Devi ◽  
T. Elakkiya Priya

AbstractIn recent days, nanofluids have derived the attention of researchers, scientists and engineers due to their abundant applications in Engineering and technology and specific applications such as Electronics cooling, vehicle cooling, medical applications including cancer therapy and so on. Motivated by these applications of nanofluids, this work is mainly concerned with the convective heat transfer of nanofluids. MHD slip flow of nanofluids with heat absorption over a rotating disk subjected to suction has been analyzed. Two types of nanofluids such as copper-water nanofluid and silver-water nanofluid are considered for the present study. The system of axisymmetric nonlinear partial differential equations governing the hydromagnetic steady flow and heat transfer are reduced to nonlinear ordinary differential equations by introducing suitable similarity transformations. The resulting non-linear ordinary differential equations are solved numerically by most efficient Nachtsheim-Swigert shooting iteration technique for satisfaction of asymptotic boundary conditions along with Runge – Kutta Fehlberg Method. The flow field is affected by the presence of physical parameters, such as magnetic interaction parameter, suction parameter, slip parameter and solid volume fraction, whereas the temperature field is addionally affected by magnetic interaction parameter, suction parameter, internal heat absorption parameter and solid volume fraction. With the amplifying effect in magnetic interaction parameter, suction parameter, slip parameter and solid volume fraction, the radial and tangential velocities decline. Axial velocity gets decelerated for increasing magnetic interaction parameter and slip parameter whereas it gets accelerated for growing effect of suction parameter and solid volume fraction. The temperature of the fluid within the boundary layer enhances with the increasing effect of magnetic interaction parameter and solid volume fraction while it reduces for increasing values of the suction parameter and internal heat absorption parameter. Also the values of radial and tangential skin friction coefficients and Nusselt number are obtained numerically and are tabulated.


1961 ◽  
Vol 11 (1) ◽  
pp. 121-132 ◽  
Author(s):  
G. W. Sutton ◽  
A. W. Carlson

The flow of an inviscid, incompressible electrical conducting fluid in a channel of constant rectangular cross-section is considered, when the flow enters a region which contains a magnetic field transverse to the flow and electrodes on opposite sides of the channel. This geometry is typical of a d.c. induction pump or magnetohydrodynamic generator. The conducting fluid external to the magnetic field acts as a shunt and produces a non-uniform electric potential field and hence a non-uniform Lorenz force on the fluid, and causes the fluid velocity profile to be distorted. These effects are calculated theoretically for small magnetic Reynolds number and small magnetic interaction parameter. It is found that the velocity at the centre-line of the channel is retarded and at the walls the velocity is accelerated. The fractional change of velocity at the wall is equal to approximately 0·44 times a modified magnetic interaction parameter.


Sign in / Sign up

Export Citation Format

Share Document