Surface energy balance model of transpiration from variable canopy cover and evaporation from residue-covered or bare-soil systems

2009 ◽  
Vol 28 (1) ◽  
pp. 51-64 ◽  
Author(s):  
Luis Octavio Lagos ◽  
Derrel L. Martin ◽  
Shashi B. Verma ◽  
Andrew Suyker ◽  
Suat Irmak
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Canopy Cover ◽  
Bare Soil ◽  
Energy Balance Model ◽  
Balance Model ◽  
Soil Systems

scholarly journals Surface energy balance model of transpiration from variable canopy cover and evaporation from residue-covered or bare soil systems: model evaluation

2011 ◽  
Vol 31 (2) ◽  
pp. 135-150 ◽  
Author(s):  
Luis Octavio Lagos ◽  
Derrel L. Martin ◽  
Shashi B. Verma ◽  
Suat Irmak ◽  
Ayse Irmak ◽  
...  
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Model Evaluation ◽  
Surface Energy Balance ◽  
Canopy Cover ◽  
Bare Soil ◽  
Energy Balance Model ◽  
Balance Model ◽  
Systems Model ◽  
Soil Systems

scholarly journals Evaluation of the Simple Urban Energy Balance Model Using Selected Data from 1-yr Flux Observations at Two Cities

2009 ◽  
Vol 48 (4) ◽  
pp. 693-715 ◽  
Author(s):  
Toru Kawai ◽  
Mohammad Kholid Ridwan ◽  
Manabu Kanda
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Sensible Heat Flux ◽  
Energy Balance Model ◽  
Balance Model ◽  
Wave Radiation ◽  
Urban Energy Balance ◽  
Two Cities ◽  
Urban Energy

Abstract The authors’ objective was to apply the Simple Urban Energy Balance Model for Mesoscale Simulation (SUMM) to cities. Data were selected from 1-yr flux observations conducted at three sites in two cities: one site in Kugahara, Japan (Ku), and two sites in Basel, Switzerland (U1 and U2). A simple vegetation scheme was implemented in SUMM to apply the model to vegetated cities, and the surface energy balance and radiative temperature TR were evaluated. SUMM generally reproduced seasonal and diurnal trends of surface energy balance and TR at Ku and U2, whereas relatively large errors were obtained for the daytime results of sensible heat flux QH and heat storage ΔQS at U1. Overall, daytime underestimations of QH and overestimations of ΔQS and TR were common. These errors were partly induced by the poor parameterization of the natural logarithm of the ratio of roughness length for momentum to heat (κB−1); that is, the observed κB−1 values at vegetated cities were smaller than the simulated values. The authors proposed a new equation for predicting this coefficient. This equation accounts for the existence of vegetation and improves the common errors described above. With the modified formula for κB−1, simulated net all-wave radiation and TR agreed well with observed values, regardless of site and season. However, at U1, simulated QH and ΔQS were still overestimated and underestimated, respectively, relative to observed values.

scholarly journals A Modified Surface Energy Balance to Estimate Crop Transpiration and Soil Evaporation in Micro-Irrigated Orchards

Water ◽  
2019 ◽  
Vol 11 (9) ◽  
pp. 1747 ◽  
Author(s):  
Camilo Souto ◽  
Octavio Lagos ◽  
Eduardo Holzapfel ◽  
Mahesh Lal Maskey ◽  
Lynn Wunderlich ◽  
...  
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Irrigation Management ◽  
Soil Evaporation ◽  
Heat Fluxes ◽  
Energy Balance Model ◽  
Balance Model ◽  
Coefficient Of Determination ◽  
Surface Renewal

A surface energy balance model was conceived to estimate crop transpiration and soil evaporation in orchards and vineyards where the floor is partially wetted by micro-irrigation systems. The proposed surface energy balance model for partial wetting (SEB-PW) builds upon previous multiple-layer modelling approaches to estimate the latent, sensible, and soil heat fluxes, while partitioning the total evapotranspiration ( E T ) into dry and wet soil evaporation ( λ E s o i l ) and crop transpiration ( T ). The model estimates the energy balance and flux resistances for the evaporation from dry and wet soil areas below the canopy, evaporation from dry and wet soil areas between plant rows, crop transpiration, and total crop E T . This article describes the model development, sensitivity analysis and a preliminary model evaluation. The evaluation shows that simulated hourly E T values have a good correlation with field measurements conducted with the surface renewal method and micro-lysimeter measurements in a micro-irrigated winegrape vineyard of Northern California for a range of fractional crop canopy cover conditions. Evaluation showed that hourly L E estimates had root mean square error ( R M S E ) of 58.6 W m−2, mean absolute error ( M A E ) of 35.6 W m−2, Nash-Sutcliffe coefficient ( C N S ) of 0.85, and index of agreement ( d a ) of 0.94. Daily soil evaporation ( E s ) estimations had R M S E of 0.30 mm d−1, M A E of 0.24 mm d−1, C N S of 0.87, and d a of 0.94. E s estimation had a coefficient of determination ( r 2 ) of 0.95, when compared with the micro-lysimeter measurements, which showed that E s can reach values from 28% to 46% of the total E T after an irrigation event. The proposed SEB-PW model can be used to estimate the effect and significance of soil evaporation from wet and dry soil areas on the total E T , and to inform water balance studies for optimizing irrigation management. Further evaluation is needed to test the model in other partially wetted orchards and to test the model performance during all growing seasons and for different environmental conditions.

A sensitivity analysis of a surface energy balance model to LAI (Leaf Area Index)

2008 ◽  
Author(s):  
A. Maltese ◽  
M. Cannarozzo ◽  
F. Capodici ◽  
G. La Loggia ◽  
T. Santangelo
Keyword(s):  
Sensitivity Analysis ◽  
Energy Balance ◽  
Surface Energy ◽  
Leaf Area Index ◽  
Leaf Area ◽  
Surface Energy Balance ◽  
Energy Balance Model ◽  
Balance Model ◽  
Area Index
Sign in / Sign up

Export Citation Format

Share Document