A simple but accurate ultraviolet limb-scan spherically-layered radiative-transfer-model based on single-scattering physics

2007 ◽  
Vol 24 (4) ◽  
pp. 619-630 ◽  
Author(s):  
Xia Guo ◽  
Daren Lü ◽  
Yao Lü
Keyword(s):  
Radiative Transfer ◽  
Single Scattering ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Model Based

scholarly journals Fast Hyper-Spectral Radiative Transfer Model Based on the Double Cluster Low-Streams Regression Method

2021 ◽  
Vol 13 (3) ◽  
pp. 434
Author(s):  
Ana del Águila ◽  
Dmitry S. Efremenko
Keyword(s):  
Radiative Transfer ◽  
Single Scattering ◽  
Atmospheric Composition ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Absorption Bands ◽  
Acceleration Techniques ◽  
Scattering Approximation ◽  
Fine Resolution ◽  
Single Scattering Approximation

Fast radiative transfer models (RTMs) are required to process a great amount of satellite-based atmospheric composition data. Specifically designed acceleration techniques can be incorporated in RTMs to simulate the reflected radiances with a fine spectral resolution, avoiding time-consuming computations on a fine resolution grid. In particular, in the cluster low-streams regression (CLSR) method, the computations on a fine resolution grid are performed by using the fast two-stream RTM, and then the spectra are corrected by using regression models between the two-stream and multi-stream RTMs. The performance enhancement due to such a scheme can be of about two orders of magnitude. In this paper, we consider a modification of the CLSR method (which is referred to as the double CLSR method), in which the single-scattering approximation is used for the computations on a fine resolution grid, while the two-stream spectra are computed by using the regression model between the two-stream RTM and the single-scattering approximation. Once the two-stream spectra are known, the CLSR method is applied the second time to restore the multi-stream spectra. Through a numerical analysis, it is shown that the double CLSR method yields an acceleration factor of about three orders of magnitude as compared to the reference multi-stream fine-resolution computations. The error of such an approach is below 0.05%. In addition, it is analysed how the CLSR method can be adopted for efficient computations for atmospheric scenarios containing aerosols. In particular, it is discussed how the precomputed data for clear sky conditions can be reused for computing the aerosol spectra in the framework of the CLSR method. The simulations are performed for the Hartley–Huggins, O2 A-, water vapour and CO2 weak absorption bands and five aerosol models from the optical properties of aerosols and clouds (OPAC) database.

Consistent retrieval of cloud/aerosol single scattering properties and surface reflectance

2021 ◽  
Author(s):  
Marta Luffarelli ◽  
Yves Govaerts
Keyword(s):  
Radiative Transfer ◽  
Optical Thickness ◽  
Solution Space ◽  
Single Scattering ◽  
Aerosol Optical Thickness ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Surface Reflectance ◽  
Earth System ◽  
System Components

<p>The CISAR (Combined Inversion of Surface and AeRosols) algorithm is exploited in the framework of the ESA Aerosol Climate Change Initiatiave (CCI) project, aiming at providing a set of atmospheric (cloud and aerosol) and surface reflectance products derived from S3A/SLSTR observations using the same radiative transfer physics and assumptions. CISAR is an advance algorithm developed by Rayference originally designed for the retrieval of aerosol single scattering properties and surface reflectance from both geostationary and polar orbiting satellite observations.  It is based on the inversion of a fast radiative transfer model (FASTRE). The retrieval mechanism allows a continuous variation of the aerosol and cloud single scattering properties in the solution space.</p><p> </p><p>Traditionally, different approaches are exploited to retrieve the different Earth system components, which could lead to inconsistent data sets. The simultaneous retrieval of different atmospheric and surface variables over any type of surface (including bright surfaces and water bodies) with the same forward model and inversion scheme ensures the consistency among the retrieved Earth system components. Additionally, pixels located in the transition zone between pure clouds and pure aerosols are often discarded from both cloud and aerosol algorithms. This “twilight zone” can cover up to 30% of the globe. A consistent retrieval of both cloud and aerosol single scattering properties with the same algorithm could help filling this gap.</p><p> </p><p>The CISAR algorithm aims at overcoming the need of an external cloud mask, discriminating internally between aerosol and cloud properties. This approach helps reducing the overestimation of aerosol optical thickness in cloud contaminated pixels. The surface reflectance product is delivered both for cloud-free and cloudy observations.  </p><p> </p><p>Global maps obtained from the processing of S3A/SLSTR observations will be shown. The SLSTR/CISAR products over events such as, for instance, the Australian fire in the last months of 2019, will be discussed in terms of aerosol optical thickness, aerosol-cloud discrimination and fine/coarse mode fraction.</p>

scholarly journals Using a Parameterization of a Radiative Transfer Model to Build High-Resolution Maps of Typical Clear-Sky UV Index in Catalonia, Spain

2005 ◽  
Vol 44 (6) ◽  
pp. 789-803 ◽  
Author(s):  
Jordi Badosa ◽  
Josep-Abel González ◽  
Josep Calbó ◽  
Michiel van Weele ◽  
Richard L. McKenzie
Keyword(s):  
High Resolution ◽  
Radiative Transfer ◽  
Zenith Angle ◽  
Solar Zenith Angle ◽  
Absolute Error ◽  
Single Scattering ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Uv Index ◽  
Wide Range

Abstract To perform a climatic analysis of the annual UV index (UVI) variations in Catalonia, Spain (northeast of the Iberian Peninsula), a new simple parameterization scheme is presented based on a multilayer radiative transfer model. The parameterization performs fast UVI calculations for a wide range of cloudless and snow-free situations and can be applied anywhere. The following parameters are considered: solar zenith angle, total ozone column, altitude, aerosol optical depth, and single-scattering albedo. A sensitivity analysis is presented to justify this choice with special attention to aerosol information. Comparisons with the base model show good agreement, most of all for the most common cases, giving an absolute error within ±0.2 in the UVI for a wide range of cases considered. Two tests are done to show the performance of the parameterization against UVI measurements. One uses data from a high-quality spectroradiometer from Lauder, New Zealand [45.04°S, 169.684°E, 370 m above mean sea level (MSL)], where there is a low presence of aerosols. The other uses data from a Robertson–Berger-type meter from Girona, Spain (41.97°N, 2.82°E, 100 m MSL), where there is more aerosol load and where it has been possible to study the effect of aerosol information on the model versus measurement comparison. The parameterization is applied to a climatic analysis of the annual UVI variation in Catalonia, showing the contributions of solar zenith angle, ozone, and aerosols. High-resolution seasonal maps of typical UV index values in Catalonia are presented.

scholarly journals Comparison of UV-RSS spectral measurements and TUV model runs for clear skies for the May 2003 ARM aerosol intensive observation period

2007 ◽  
Vol 7 (6) ◽  
pp. 17401-17427
Author(s):  
J. J. Michalsky ◽  
P. W. Kiedron
Keyword(s):  
Radiative Transfer ◽  
Single Scattering ◽  
Single Scattering Albedo ◽  
Spectral Irradiance ◽  
Radiative Transfer Model ◽  
Visible Range ◽  
Transfer Model ◽  
Intensive Observation ◽  
Aerosol Properties ◽  
Observation Period

Abstract. The first successful deployment of the fully-operational ultraviolet rotating shadow-band spectroradiometer occurred during the May 2003 U.S. Department of Energy's Atmospheric Radiation Measurement program's Aerosol Intensive Observation Period. The aerosol properties in the visible range were characterized using redundant measurements with several instruments to determine the column aerosol optical depth, the single scattering albedo, and the asymmetry parameter needed as input for radiative transfer calculations of the downwelling direct normal and diffuse horizontal solar irradiance in clear-sky conditions. The Tropospheric Ultraviolet and Visible (TUV) radiative transfer model developed by Madronich and his colleagues at the U.S. National Center for Atmospheric Research was used for the calculations of the spectral irradiance between 300–360 nm. Since there are few ultraviolet measurements of aerosol properties, most of the input aerosol data for the radiative transfer model are based on the assumption that UV input parameters can be extrapolated from the visible portion of the spectrum. Disagreements between available extraterrestrial spectra, which are discussed briefly, suggested that instead of comparing irradiances that measured and modeled spectral transmittances between 300–360 nm should be compared for the seven cases studied. These cases included low to moderate aerosol loads and low to high solar-zenith angles. A procedure for retrieving single scattering albedo in the ultraviolet based on the comparisons of direct and diffuse transmittance is outlined.

scholarly journals Star formation In Bright-Rimmed Clouds: a comparison of wind-driven triggering with millimeter observations

2006 ◽  
Vol 2 (S237) ◽  
pp. 409-409
Author(s):  
Christopher H. De Vries ◽  
G. Narayanan ◽  
R. L. Snell
Keyword(s):  
Star Formation ◽  
Radiative Transfer ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Hydrodynamic Models ◽  
Molecular Line ◽  
Model Based ◽  
Accurate Comparison ◽  
Cloud Cores ◽  
Shock Fronts

Bright-rimmed clouds (BRCs) are logical laboratories in which to study triggered star formation, however it is difficult in any single cloud to definitively show that star formation was triggered. In this study we compare the hydrodynamic models produced by Vanhala & Cameron (1998) that treat the problems of star-formation triggered by wind-driven implosion to millimeter and submillimeter molecular line observations of BRCs with embedded IRAS sources. These latter sources are derived from a catalog by Sugitani, Fukui, & Ogura (1991) In order to make an accurate comparison we implement a radiative transfer model based on the Sobolev or LVG approximation, and generate molecular line maps which can be directly compared to our observations. We observed several millimeter and submillimeter transitions of CO, C 18O, HCO+, and H13CO+ using the FCRAO, SMT, CSO, and SMA observatories (De Vries, Narayanan, & Snell 2002). We compare these observations with 3 hydrodynamic models of wind-driven shock fronts interacting with pre-existing, but unbound cloud cores. In two cases these model cores are triggered to collapse under the influence of the external wind.

scholarly journals Aerosol single scattering albedo retrieved from measurements of surface UV irradiance and a radiative transfer model

2003 ◽  
Vol 108 (D9) ◽  
pp. n/a-n/a ◽  
Author(s):  
J. L. Petters ◽  
V. K. Saxena ◽  
J. R. Slusser ◽  
B. N. Wenny ◽  
Sasha Madronich
Keyword(s):  
Radiative Transfer ◽  
Single Scattering ◽  
Single Scattering Albedo ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Uv Irradiance
Sign in / Sign up

Export Citation Format

Share Document