scholarly journals Mechanism of silicate elution by hydrogen sulfide from bottom sediment in a brackish lake

Limnology ◽  
2019 ◽  
Vol 21 (2) ◽  
pp. 197-205
Author(s):  
Ja Yeong Park ◽  
Shogo Sugahara ◽  
Michiko Egawa ◽  
Yasushi Seike
Keyword(s):  
Hydrogen Sulfide ◽  
Sodium Sulfide ◽  
Ferric Hydroxide ◽  
Sulfide Concentration ◽  
Silicate Concentration ◽  
Brackish Lake ◽  
Microbiological Processes ◽  
Lake Nakaumi ◽  
Reducing Environment ◽  
Dissolved Silicate

AbstractHighly concentrated dissolved silicate was detected in pore water from anoxic-reducing sediment in Lake Nakaumi, a brackish lake. Silicate concentration also simultaneously increased with total hydrogen sulfide concentration during the summer. Generally, dissolved silicate is readily adsorbed onto ferric hydroxide and precipitates in an oxidative environment. In this study, we focused on the behavior of ferric hydroxide adsorbing silicate in sediment and determined that hydrogen sulfide was the main cause of dissolved silicate elution from ferric hydroxide adsorbing silicate because the hydrogen sulfide produced via microbiological processes in the anoxic-reducing environment was reducible for other metal oxides. According to laboratory experiments, silicate was released from ferric hydroxide by reacting with sodium sulfide, causing increasing elution of dissolved silicate from anoxic-reducing sediments with increasing concentration of sodium sulfide in the solutions. This result shows that hydrogen sulfide is very crucial for silicate release under a reducing environment. Therefore, in Lake Nakaumi, silicate would be released from the bottom after ferric hydroxide adsorbing silicate reacted with hydrogen sulfide in a summer reductive environment.

scholarly journals Hydrogen sulfide and organic carbon at the sediment–water interface in coastal brackish Lake Nakaumi, SW Japan

2012 ◽  
Vol 68 (7) ◽  
pp. 1999-2006 ◽  
Author(s):  
Saburo Sakai ◽  
Masaru Nakaya ◽  
Yoshikazu Sampei ◽  
David L. Dettman ◽  
Katsumi Takayasu
Keyword(s):  
Hydrogen Sulfide ◽  
Organic Carbon ◽  
Water Interface ◽  
Brackish Lake ◽  
Lake Nakaumi ◽  
Sw Japan

scholarly journals PSIX-9 Impacts of bunk management on feedlot performance, carcass characteristics, hydrogen sulfide concentration and blood oxygen saturation in steers fed 25 or 50% modified distillers grains plus solubles

2020 ◽  
Vol 98 (Supplement_4) ◽  
pp. 422-422
Author(s):  
Rebecca L Moore ◽  
Cierrah J Kassetas ◽  
Leslie A LeKatz ◽  
Bryan W Neville
Keyword(s):  
Hydrogen Sulfide ◽  
Oxygen Saturation ◽  
Management Strategy ◽  
Distillers Grains ◽  
Feed Ratio ◽  
Sulfide Concentration ◽  
Blood Oxygen ◽  
Blood Oxygen Saturation ◽  
Feedlot Performance ◽  
Arterial Blood

Abstract One hundred and twenty-six yearling angus steers (initial body weight 445.87 ± 7.13 kg) were utilized in a 2 x 2 factorial design to evaluate the impacts of bunk management and modified distillers grains plus solubles (mDGS) inclusion on feedlot performance, hydrogen sulfide concentrations and blood oxygen saturation. Treatments included bunk management strategy either control bunk management (CON; clean bunks at the time of next day’s feeding) or long bunk management (LONG; feed remaining at time of next day’s feeding), and two inclusion rates of mDGS either 25% or 50% (DM Basis). On d 0, 7, 14, 21, 28 and 35 rumen gas samples were collected via rumenocentesis, and arterial blood samples were collected on two steers from each pen. No differences (P ≥ 0.09) were observed for dry matter intake, average daily gain and gain-to-feed ratio for bunk management or mDGS inclusion. Hot carcass weight, ribeye area, marbling score and quality grade were not affected (P ≥ 0.48) by either bunk management or mDGS inclusion. Back fat was greater (P = 0.04) for CON steers compared to LONG (1.30 vs 1.12 ± 0.05cm, respectively), but was not affected (P = 0.59) by mDGS inclusion. Steers on CON had greater (P = 0.03) yield grades compared to LONG (3.21 vs 2.96 ± 0.11, respectively). Bunk management strategy did not impact hydrogen sulfide concentrations or blood oxygen saturation (P = 0.82). Hydrogen sulfide concentrations increased (P < 0.001) with increasing mDGS inclusion. Blood oxygen saturation was influenced by day of sampling (P = 0.01). Blood oxygen saturation was not affected (P = 0.07) by mDGS inclusion. The fact that ruminal hydrogen sulfide concentrations increased while blood oxygen saturation remained similar raises questions about the quantity of hydrogen sulfide and metabolic fate of excess hydrogen sulfide in the blood of ruminant animals.

Roots as a site of hydrogen sulfide uptake in the hydrocarbon seep vestimentiferan Lamellibrachia sp

1999 ◽  
Vol 202 (17) ◽  
pp. 2245-2257 ◽  
Author(s):  
D. Julian ◽  
F. Gaill ◽  
E. Wood ◽  
A.J. Arp ◽  
C.R. Fisher
Keyword(s):  
Hydrogen Sulfide ◽  
Total Mass ◽  
Sea Water ◽  
Tube Wall ◽  
Structural Characteristics ◽  
Sulfide Oxidation ◽  
Sulfide Concentration ◽  
Hydrocarbon Seep ◽  
Respiratory Organ ◽  
Root Tube

Vestimentiferan tubeworms have no mouth or gut, and the majority of their nutritional requirements are provided by endosymbiotic bacteria that utilize hydrogen sulfide oxidation to fix CO(2) into organic molecules. It has been assumed that all vestimentiferans obtain the sulfide, O(2) and CO(2) needed by the bacteria across the plume (gill) surface, but some live in locations where very little sulfide is available in the sea water surrounding the plume. We propose that at least some of these vestimentiferans can grow a posterior extension of their body and tube down into the sea-floor sediment, and that they can use this extension, which we call the ‘root’, to take up sulfide directly from the interstitial water. In this study of the vestimentiferan Lamellibrachia sp., found at hydrocarbon seeps in the Gulf of Mexico at depths of approximately 700 m, we measured seawater and interstitial sulfide concentrations in the hydrocarbon seep habitat, determined the structural characteristics of the root tube using transmission electron microscopy, characterized the biochemical composition of the tube wall, and measured the sulfide permeability of the root tube. We found that, while the sulfide concentration is less than 1 (μ)mol l(−)(1) in the sea water surrounding the gills, it can be over 1.5 mmol l(−)(1) at a depth of 10–25 cm in sediment beneath tubeworm bushes. The root tube is composed primarily of giant (β)-chitin crystallites (12–30 % of total mass) embedded in a protein matrix (50 % of total mass). Root tubes have a mean diameter of 1.4 mm, a mean wall thickness of 70 (μ)m and can be over 20 cm long. The tubeworm itself typically extends its body to the distal tip of the root tube. The root tube wall was quite permeable to sulfide, having a permeability coefficient at 20 degrees C of 0. 41×10(−)(3)cm s(−)(1), with root tube being 2.5 times more permeable to sulfide than trunk tube of the same diameter. The characteristics of the root suggest that it reaches down to the higher sulfide levels present in the deeper sediment and that it functions to increase the surface area available for sulfide uptake in a manner analogous to a respiratory organ.

scholarly journals Effect of abiotic factors on sulfidogenic activity of bacteria Desulfuromonas sp.

2020 ◽  
Vol 11 (2) ◽  
pp. 170-174
Author(s):  
O. M. Сhaіka ◽  
T. B. Peretyatko
Keyword(s):  
Hydrogen Sulfide ◽  
Cell Density ◽  
Elemental Sulfur ◽  
Abiotic Factors ◽  
Electron Acceptors ◽  
Stress Factors ◽  
Sulfide Concentration ◽  
Sulfur Concentration ◽  
Reducing Bacteria ◽  
Hydrogen Sulfide Concentration

Sulfur-reducing bacteria are promising agents for the development of new methods of wastewater treatment with the removal of ions of heavy metals and organic compounds. Study of the effect of various environmental factors on the growth and sulfidogenic activity of sulfur-reducing bacteria allows one to investigate the adaptability of these microorganisms to stress factors. The paper deals with the effect of рН, different concentrations of elemental sulfur, hydrogen sulfide and presence of various electron acceptors on the growth and sulfidogenic activity of bacteria Desulfuromonas sp. YSDS-3. The calculation of C/S ratio for sulfur-reducing bacteria Desulfuromonas sp. YSDS-3 was made, with the comparison with similar parameters of sulfate-reducing bacteria. In the medium with elemental sulfur, concentration of hydrogen sulfide increased with the concentration of elemental sulfur. Bacteria Desulfuromonas sp. YSDS-3 accumulated their biomass in the most effective way at the concentration of elemental sulfur of 10–100 mM. In the medium with polysulfide form of sulfur at the neutral pH, bacteria produced hydrogen sulfide and accumulated biomass the best. Hydrogen sulfide at the concentration of 3 mM did not inhibit the bacterial growth, but further increase in the hydrogen sulfide concentration inhibited the growth of bacteria. The bacteria did not grow at the hydrogen sulfide concentration of 25 mM and above. As the concentration of elemental sulfur and cell density increases, sulfidogenic activity of the bacteria grows. Presence of two electron acceptors (S and K2Cr2O7, S and MnO2, S and Fe (III)) did not affect the accumulation of biomass of the bacteria Desulfuromonas sp. YSDS-3. However, under such conditions the bacteria accumulated 1.5–2.5 times less hydrogen sulfide than in the test medium. After 12–24 h of cultivation, different concentrations of elemental sulfur had a significant effect on the sulfidogenic activity. However, during 3–16 days of cultivation, the percentage of effect of elemental sulfur concentration decreased to 31%, while the percentage of effect of cell density increased threefold. Presence in the medium of the electron acceptors (Cr (VI), MnO2, Fe (III)) alternative to elemental sulfur led to a significant decrease in the content of hydrogen sulfide produced by sulfur-reducing bacteria.

Spot Test for Lead in Paint (Continued)

PEDIATRICS ◽  
1971 ◽  
Vol 48 (2) ◽  
pp. 330-330
Author(s):  
James W. Sayre
Keyword(s):  
Hydrogen Sulfide ◽  
Sodium Sulfide ◽  
Spot Test ◽  
Sodium Sulfide Solution ◽  
The Stability ◽  
Sulfide Solution

Questions asked by several people about our sodium sulfide testing of paint for lead1 make us feel we might wisely add several words of caution about the stability of the prepared solution. Sodium sulfide solutions deteriorate fairly rapidly with age, especially on exposure to air. For this reason, it is suggested that people using the procedure check the odor of the sodium sulfide solution tlley are using, to make sure the odor of hydrogen sulfide is detectable.

Sign in / Sign up

Export Citation Format

Share Document