Optimal conditions of Al and Fe extraction from laterite soil using D-optimal design

2012 ◽  
Vol 32 (4) ◽  
pp. 453-463
Author(s):  
Abbas F. M. Alkarkhi ◽  
Yusri Yusup ◽  
Tjoon Tow Teng
Keyword(s):  
Optimal Design ◽  
Optimal Conditions ◽  
Laterite Soil

scholarly journals ADSORPTIVE REMOVAL OF RHODAMINE B USING SURFACTANT MODIFIED LATERITE SOIL

2018 ◽  
Vol 56 (6) ◽  
pp. 706
Author(s):  
Tien Duc Pham ◽  
Thu Thao Pham
Keyword(s):  
Ionic Strength ◽  
Removal Efficiency ◽  
Rhodamine B ◽  
Sodium Dodecyl ◽  
Optimal Conditions ◽  
Optimum Conditions ◽  
Adsorption Model ◽  
Laterite Soil ◽  
Adsorptive Removal ◽  
Nacl Concentration

Adsorption of the cationic dye, Rhodamine B (RhB) onto surfactant modified laterite (SML) was studied in this work. The removal efficiency of RhB using laterite increased significantly after surface modification by pre-adsorption of anionic surfactant sodium dodecyl sulfate (SDS). Some effective of parameters such as pH, adsorbent amount and ionic strength were also investigated. The optimal conditions for RhB removal using SML were found to be pH 4, adsorbent amount 0.1 g and ionic strength 0.1 mM NaCl. Under optimum conditions, RhB removal efficiency increased from 25.77% to 94.85% using SML compared without SDS modification. After 5 regenerations of SML, the removal efficiency of RhB was still higher than 90%.  Adsorption of RhB onto SML decreased with increasing NaCl concentration from 0.1 to 200 mM, demonstrating that adsorption of RhB onto SML mainly induced by electrostatic attraction. The two-step adsorption model can fit the experimental results of RhB adsorption isotherms onto SML at different NaCl concentrations. Our results indicate that SML is a novel adsorbent to remove ionic dye from aqueous solution.

Amorphous silica coating on α-alumina particles

1995 ◽  
Vol 53 ◽  
pp. 210-211
Author(s):  
J. W. Mellowes ◽  
C. M. Chun ◽  
I. A. Aksay
Keyword(s):  
Amorphous Silica ◽  
Heterogeneous Nucleation ◽  
Homogeneous Nucleation ◽  
Silica Coating ◽  
Full Density ◽  
Optimal Conditions ◽  
Fine Grained ◽  
Alumina Particles ◽  
Complete Mullitization ◽  
Powder Compacts

Mullite (3Al2O32SiO2) can be fabricated by transient viscous sintering using composite particles which consist of inner cores of a-alumina and outer coatings of amorphous silica. Powder compacts prepared with these particles are sintered to almost full density at relatively low temperatures (~1300°C) and converted to dense, fine-grained mullite at higher temperatures (>1500°C) by reaction between the alumina core and the silica coating. In order to achieve complete mullitization, optimal conditions for coating alumina particles with amorphous silica must be achieved. Formation of amorphous silica can occur in solution (homogeneous nucleation) or on the surface of alumina (heterogeneous nucleation) depending on the degree of supersaturation of the solvent in which the particles are immersed. Successful coating of silica on alumina occurs when heterogeneous nucleation is promoted and homogeneous nucleation is suppressed. Therefore, one key to successful coating is an understanding of the factors such as pH and concentration that control silica nucleation in aqueous solutions. In the current work, we use TEM to determine the optimal conditions of this processing.

Immunocytochemical methodology for the localization of neuronal antigens at the ultrastructural level

1990 ◽  
Vol 48 (3) ◽  
pp. 876-877
Author(s):  
Jorge Pecci Saavedra ◽  
Mark Connaughton ◽  
Juan José López ◽  
Alicia Brusco
Keyword(s):  
Spinal Cord ◽  
Substantia Nigra ◽  
Polyclonal Antibodies ◽  
Ultrastructural Level ◽  
Point Of View ◽  
Nerve Tissue ◽  
Tissue Fixation ◽  
Optimal Conditions ◽  
Interpeduncular Nucleus ◽  
Technical Point

The use of antibodies as labels for the localization of specific molecules in the nervous systan has been extensively applied in recent years. Both monoand polyclonal antibodies or antisera have been employed. The knowledge of the organization of neuronal connectivities, gliovascular relationships, glioneuronal relationships and other features of nerve tissue has greatly increased.A number of areas of the nervous systan have been analyzed in our laboratory, including the nuclei of the raphe system, the reticular formation, interpeduncular nucleus, substantia nigra, caudate nucleus, putamen, pallidum, spinal cord, pineal gland and others.From a technical point of view, a number of variables needed to be taken into account in order to obtain reliable and reproducible results. The design of the optimal conditions of tissue fixation, embedding, sectioning, dilution of antibodies, and adaptation of Sternberger PAP technique were sane of the parameters taken into account to optimize the results. It is critical that each step of the technique be defined for each particular case.

Stability of antioxidant vitamins in whole human blood during overnight storage at 4°C and frozen storage up to 6 months

2018 ◽  
Vol 88 (3-4) ◽  
pp. 151-157 ◽  
Author(s):  
Scott W. Leonard ◽  
Gerd Bobe ◽  
Maret G. Traber
Keyword(s):  
Ascorbic Acid ◽  
Whole Blood ◽  
Healthy Subjects ◽  
Frozen Storage ◽  
Blood Collection ◽  
Plasma Samples ◽  
Optimal Conditions ◽  
Plasma Ascorbic Acid ◽  
Blood Samples ◽  
Sample Handling

Abstract. To determine optimal conditions for blood collection during clinical trials, where sample handling logistics might preclude prompt separation of erythrocytes from plasma, healthy subjects (n=8, 6 M/2F) were recruited and non-fasting blood samples were collected into tubes containing different anticoagulants (ethylenediaminetetra-acetic acid (EDTA), Li-heparin or Na-heparin). We hypothesized that heparin, but not EDTA, would effectively protect plasma tocopherols, ascorbic acid, and vitamin E catabolites (α- and γ-CEHC) from oxidative damage. To test this hypothesis, one set of tubes was processed immediately and plasma samples were stored at −80°C, while the other set was stored at 4°C and processed the following morning (~30 hours) and analyzed, or the samples were analyzed after 6 months of storage. Plasma ascorbic acid, as measured using HPLC with electrochemical detection (LC-ECD) decreased by 75% with overnight storage using EDTA as an anticoagulant, but was unchanged when heparin was used. Neither time prior to processing, nor anticoagulant, had any significant effects upon plasma α- or γ-tocopherols or α- or γ-CEHC concentrations. α- and γ-tocopherol concentrations remained unchanged after 6 months of storage at −80°C, when measured using either LC-ECD or LC/mass spectrometry. Thus, refrigeration of whole blood at 4°C overnight does not change plasma α- or γ-tocopherol concentrations or their catabolites. Ascorbic acid is unstable in whole blood when EDTA is used as an anticoagulant, but when whole blood is collected with heparin, it can be stored overnight and subsequently processed.

A Simple Method for Estimation of Lipoxygenase and Cyclo-Oxygenase Pathways in Human Platelets - the Use of Thiobarbituric Acid Reaction

1980 ◽  
Vol 44 (02) ◽  
pp. 111-114 ◽  
Author(s):  
Hiroshi Takayama ◽  
Minoru Okuma ◽  
Haruto Uchino
Keyword(s):  
Time Course ◽  
Normal Values ◽  
Human Platelet ◽  
Thiobarbituric Acid ◽  
Human Platelets ◽  
Optimal Conditions ◽  
Experimental Conditions ◽  
Simple Method ◽  
Acid Reaction ◽  
Optimal Ph

SummaryTo develop a simple method for estimation of platelet lipoxygenase (PLO) and cyclo-oxygenase (PCO) pathways, the arachidonic acid (AA) metabolism of human platelet was investigated under various experimental conditions by the use of the thiobarbituric acid (TBA) reaction and a radioisotope technique. A TBA-reactive substance different from malondialdehyde (MDA) via PCO pathway was detected and shown to be derived from the PLO pathway. Since the optimal pH and time course of its formation were different from those of MDA formation via PCO pathway, PLO and PCO pathways were estimated by quantitating the TBA-reactive substances produced by the incubation of AA either with aspirin-treated platelets or with untreated ones, respectively, each under optimal conditions. Normal values expressed in terms of nmol MDA/108 platelets were 1.17±0.34 (M±SD, n = 31) and 0.79±0.15 (n = 31) for PLO and PCO pathways, respectively.

Crack divergence phenomena in tempered glass

2020 ◽  
Vol 13 (3) ◽  
pp. 115-129
Author(s):  
Shin’ichi Aratani
Keyword(s):  
Optimal Design ◽  
High Speed ◽  
Glass Plate ◽  
Acute Angle ◽  
Divergence Angle ◽  
High Speed Photography ◽  
Tempered Glass ◽  
Thick Glass

High speed photography using the Cranz-Schardin camera was performed to study the crack divergence and divergence angle in thermally tempered glass. A tempered 3.5 mm thick glass plate was used as a specimen. It was shown that two types of bifurcation and branching existed as the crack divergence. The divergence angle was smaller than the value calculated from the principle of optimal design and showed an acute angle.

G Optimal Design in Non linear Models to Increase Silicon Oxide Purity Levels and Electrical Conductivity

2018 ◽  
pp. 150-155
Author(s):  
Muklas Rivai
Keyword(s):  
Electrical Conductivity ◽  
Optimal Design ◽  
Linear Models ◽  
Silicon Oxide ◽  
Information Matrix ◽  
Relevant Information ◽  
Non Linear

Optimal design is a design which required in determining the points of variable factors that would be attempted to optimize the relevant information so that fulfilled the desired criteria. The optimal fulfillment criteria based on the information matrix of the selected model.

Sign in / Sign up

Export Citation Format

Share Document