Subjective Response to the Conditions of Audible Fire Alarm Signals Through a Jury Evaluation Test

2021 ◽  
Author(s):  
Minjoo Lee
2021 ◽  
pp. 118-123
Author(s):  
В.Н. Круглеевский ◽  
В.В. Вислогузов ◽  
A.A. Таранцев ◽  
С.Н. Турусов

В настоящей статье рассматриваются вопросы развития пожарных извещателей, контролирующих появление дыма, превышение заданного значения температуры и скорости ее роста, наличие угарного газа и использующих мультикритериальные алгоритмы для оценки обоснованности сигналов тревоги. Анализируются результаты проведенных отечественными организациями сравнительных испытаний мультикритериальных и традиционных «пороговых» пожарных извещателей и возможности их применения на судах в составе систем пожарной сигнализации. Определено, что при повторении одних и тех же модельных очагов пожаров зафиксированные значения контролируемых параметров отличались незначительно. При этом для каждого модельного очага можно было обнаружить свои характерные черты. Сделан вывод о том, что внедрение мультикритериальных алгоритмов обработки информации в судовые системы обнаружения пожаров не только сокращает время обнаружения пожара, но и позволяет расширить функциональные возможности системы. Используя мультикритериальные пожарные извещатели в системах пожарной сигнализации можно будет распознавать, что именно горит: дизельное топливо, ветошь, изоляция электрического кабеля или что-либо другое. Отмечается, что требования к судовым мультикритериальным системам сигнализации обнаружения пожара нашли свое отражение в Правилах классификации и постройки морских судов Российского морского регистра судоходства. This article discusses the development of fire detectors that control the appearance of smoke, the excess of a given temperature and the rate of its growth, the presence of carbon monoxide and use multicriteria algorithms to assess the validity of alarm signals. The results of comparative tests of multicriteria and traditional fire detectors conducted by domestic organizations and the possibility of their use on ships as part of fire alarm systems are analyzed. It was determined that when the same model fires were repeated, the recorded values of the controlled parameters differed slightly. At the same time, for each model focus, it was possible to detect its own characteristic features. It is concluded that the introduction of multicriteria algorithms for information processing in ship fire detection systems not only reduces the time of fire detection, but also allows you to expand the functionality of the system. Using multi-criteria fire detectors in fire alarm systems,it will be possible to recognize what exactly is burning: diesel fuel, rags, electrical cable insulation, or anything else. It is noted that the requirements for ship multicriteria fire detection alarm systems are reflected in the Rules for the Classification and Construction of Marine Vessels of the Russian Maritime Register of Shipping.


2019 ◽  
Vol 49 (1) ◽  
pp. 165-174
Author(s):  
Tomasz Klimczak ◽  
Jacek Paś

Abstract The article presents basic issues regarding the operation process and analysis of the reliability of the fire alarm and transmission system in the distributed fire alarm system. Signals of fire and fault alarms generated from the fire alarm system (SSP) send fire monitoring. Fire monitoring consists of sending, with the confirmation, an automatic fire alarm and a fault signal to the appropriate alarm receiving centers (ACO). The reliability structure of the fire and fault alarm transmission system is presented. An analysis of reliability of independent SSP system information transmission paths was performed.


Author(s):  
Wang Zheng-fang ◽  
Z.F. Wang

The main purpose of this study highlights on the evaluation of chloride SCC resistance of the material,duplex stainless steel,OOCr18Ni5Mo3Si2 (18-5Mo) and its welded coarse grained zone(CGZ).18-5Mo is a dual phases (A+F) stainless steel with yield strength:512N/mm2 .The proportion of secondary Phase(A phase) accounts for 30-35% of the total with fine grained and homogeneously distributed A and F phases(Fig.1).After being welded by a specific welding thermal cycle to the material,i.e. Tmax=1350°C and t8/5=20s,microstructure may change from fine grained morphology to coarse grained morphology and from homogeneously distributed of A phase to a concentration of A phase(Fig.2).Meanwhile,the proportion of A phase reduced from 35% to 5-10°o.For this reason it is known as welded coarse grained zone(CGZ).In association with difference of microstructure between base metal and welded CGZ,so chloride SCC resistance also differ from each other.Test procedures:Constant load tensile test(CLTT) were performed for recording Esce-t curve by which corrosion cracking growth can be described, tf,fractured time,can also be recorded by the test which is taken as a electrochemical behavior and mechanical property for SCC resistance evaluation. Test environment:143°C boiling 42%MgCl2 solution is used.Besides, micro analysis were conducted with light microscopy(LM),SEM,TEM,and Auger energy spectrum(AES) so as to reveal the correlation between the data generated by the CLTT results and micro analysis.


1911 ◽  
Vol 71 (1836supp) ◽  
pp. 148-150
Author(s):  
Frank C. Perkins
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document