Dynamic Elastic Modulus and Damping Ratio of Unsaturated Red Clay

2019 ◽  
Vol 38 (1) ◽  
pp. 873-881
Author(s):  
Chang-xi Huang ◽  
Xing-hua Wang ◽  
Hao Zhou ◽  
Da-chao Qin
2019 ◽  
Vol 11 (7) ◽  
pp. 1052-1058
Author(s):  
Delei Yang ◽  
Yonghui Shang ◽  
Ping Xiang

2014 ◽  
Vol 638-640 ◽  
pp. 1967-1970
Author(s):  
Xiao Hui Ni

The uniaxial cyclic fatigue tests on granite coming from the ChangJiang of Hainan nuclear power first-stage construction conventional island were done on the RMT-150B multi-function automatic rigid rock servo material testing machine. Stress amplitude of 10 MPa and sine wave cyclic loads with five different frequencies of 0.01, 0.02, 0.05, 0.1, 0.2, 0.5, and 1 Hz were adopted as dynamic disturbance. The law between cyclic frequency and dynamic stress-dynamic strain hysteretic curve, dynamic elastic modulus and damping ratio are researched. The results showed that the curves of strain and stress for loading and unloading are not superposition under cyclic loading, but hysteretic loops. When cyclic frequency changes between 0.01 and 1.0 Hz, the granite hysteretic loop area, dynamic elastic modulus and damping ratio are increased with frequency increasing. The research result offered great reference value to seismic response analysis and site safety evaluation of the changjiang nuclear power.


2013 ◽  
Vol 838-841 ◽  
pp. 1302-1308 ◽  
Author(s):  
Jia Ding Wang ◽  
Shu Jun Peng ◽  
Wan Li Xie

In this paper based on the foundation construction of Datong Xian high-speed railway, a large number of test samples have been taken. The order and contribution rate of every experiment factor like cement commingle ratio, depths, water dipping conditions, compacting factor and vibration frequency on the dynamic characteristics of cement-improved loess such as dynamic elastic modulus, dynamic deformation, damping ratio by dynamic triaxial test, which orthogonal test method has been applied to. The dynamic load was calculated according to the train vibration attenuation rule of different depth. The dynamic characteristics of cement-improved loess such as dynamic deformation, dynamic elastic modulus, damping ratio were got form the dynamic tests of long time and large number of cycles. The results showed that with the increase of cement ratio, the dynamic characteristics of cement-improved loess are more better, there is no optimal ratio of cement.


2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Jingjing Zhou ◽  
Fasuo Zhao ◽  
Yanbo Zhu ◽  
Wenqi Dong ◽  
Ziguang He

Sliding zone dynamics in the Qinling-Daba mountain area under different dynamic parameters have not been studied extensively. In this study, we investigated the dynamic behavior of the sliding zones of a high-steep rock landslide in the Qinling-Daba mountain area under the influence of dynamic stress amplitude and frequency and proposed an empirical model of the dynamic constitutive relationship. The dynamic behavior was studied based on a cyclic triaxial test system. The results indicated that an increase in the dynamic stress amplitude decreased the dynamic elastic modulus linearly, increased the damping ratio, and increased the axial strain exponentially. Among these properties, the elastic strain was found to be more sensitive to the increase in the dynamic stress amplitude than the plastic strain. As the loading frequency increased, the dynamic elastic modulus increased, whereas the damping ratio decreased. Furthermore, the proposed empirical model of the dynamic constitutive relationship between the vibration number and loading frequency based on the dynamic elastic modulus could satisfactorily describe the dynamic stress-strain relationships of the samples from test stability and failure zones. These findings are expected to make a significant contribution toward further revealing the sliding mechanism of such landslides.


2021 ◽  
Vol 9 (3) ◽  
pp. 523-540
Author(s):  
Qian Wang ◽  
Zhaozhao Liu ◽  
Xiumei Zhong ◽  
Zhongnan Gao ◽  
Fuqiang Liu

2019 ◽  
Vol 2019 ◽  
pp. 1-11 ◽  
Author(s):  
Huafeng Deng ◽  
Yinchai Zhang ◽  
Yongyan Zhi ◽  
Lingling Duan ◽  
Jianlin Li ◽  
...  

During the long-term reservoir operation, the seismic capability and dynamic response characteristics of the bank slope are of great importance to its safety evaluation content. Aimed at typical bank slopes, considering reservoir water level fluctuation and soaking-air drying cyclic interaction, an experiment has been designed and conducted. In addition, the cyclic loading test with different stress amplitudes was carried out in different water-rock cycles. The laboratory results indicate that (1) during the immersion-air dry circulation process, the damping ratio and damping coefficient of sandstone gradually increased while the dynamic elastic modulus decreased. It is obvious that the dynamic elastic modulus of sandstone decreases dramatically during the immersion-air dry circulation process, especially in the first six periods. Also, its variation curve fits with the logarithmic curve. (2) When the cyclic load stress amplitude increases from 10 MPa to 35 MPa, the damping ratio and coefficient of the rock sample gradually decreased while dynamic elastic modulus increased. each dynamic parameter shows a more obvious variation trend when the stress amplitude is lower than 25 MPa. (3) During the water-rock interaction process, the closely knit microstructure of rock gradually becomes loose and porous, which resulted in the degradation of macroscopic physical and mechanical properties of sandstone. (4) In the analysis of the seismic response of the bank slope, the actual water-rock interaction process and the seismic level of the bank slope should be more considered. To find out further accurate reflection in the earthquake resistance and dynamic response of the bank slope, it is necessary to select the reasonable dynamic parameter to carry out seismic research.


2012 ◽  
Vol 455-456 ◽  
pp. 781-785
Author(s):  
Ping Lu ◽  
Xin Mao Li ◽  
Xue Qiang Ma ◽  
Wei Bo Huang

. This paper mainly studied the properties of PAE polyurea coated concrete under coactions of salt fog and freeze-thaw. After exposed salt fog conditions for 200d, T3, B2, F2 and TM four coated concrete relative dynamic elastic modulus have small changes, but different coated concrete variation amplitude is different. T3 coated concrete after 100 times of freeze-thaw cycle the relative dynamic elastic modulus began to drop, 200 times freeze-thaw cycle ends, relative dynamic elastic modulus variation is the largest, decrease rate is 95%, TM concrete during 200 times freeze-thaw cycle, relative dynamic elastic modulus almost no change, B2 concrete and F2 concrete the extent of change between coating T3 and TM. After 300 times the freeze-thaw cycle coated concrete didn't appear freeze-thaw damage phenomenon. Four kinds of coating concrete relative dynamic elastic modulus variation by large to small order: T3 coated concrete > B2 coated concrete >F2 coated concrete > TM coated concrete, concrete with the same 200d rule. Frost resistance order, by contrast, TM coated concrete > B2 coated concrete > F2 coated concrete > T3 coated concrete.


2011 ◽  
Vol 374-377 ◽  
pp. 1391-1395
Author(s):  
Xue Song Lu ◽  
Wei Xiang

Based on the red clay of Wuhan reinforced by Ionic Soil Stabilizer, the red clay soil is treated by different matches of ISS at first, then is tested in the Atterberg limits test and dynamic triaxia test. The results show that the plastic index decreases, and the red clay were greatly improved under the dynamic condition, the maximum dynamic shear modulus ratio acquired an incensement of 27.72% on average after mixing the ISS into the red clay. In addition, It was concluded that the confining pressure influenced the dynamic shear modulus and damping ratio to a certain extent. Given the same strain conditions, with the incensement of confining pressure increases, the dynamic shear modulus increased and the damping ratio decreased. Moreover, when plotting the dynamic shear modulus versus the dynamic shear strain, the similar curve can be formed for both the natural soil and the modified one, the dynamic shear modulus monotonously decreased with the incensement of the dynamic shear strain. However, the value of dynamic shear modulus differed in the same shear strain between the natural soil and the soil modified by ISS.


Sign in / Sign up

Export Citation Format

Share Document