Anion exclusion and sorption effect for compacted bentonite: the dependency of diffusion coefficients and capacity of HTO and Se(IV)

Author(s):  
Jie Kong ◽  
Chuan-Pin Lee ◽  
Yuzhen Sun ◽  
Rong Hua ◽  
Weigang Liu ◽  
...  
1992 ◽  
Vol 294 ◽  
Author(s):  
J. L. Conca ◽  
M.J. Apted ◽  
R.C. Arthur

ABSTRACTA new flow technology has been developed that significantly decreases the time required to obtain transport data on saturated and unsaturated porous/fractured media. This technique is based on open-flow centrifugation and was developed to measure steady-state transport properties in most geologic materials within a matter of hours. Centripetal acceleration does not induce artificial effects in samples i.e., fracturing, collapse of interlayer structures, structural dewatering, compaction, chemical changes, etc., that occur with high-pressure methods. Using this technique, hydraulic conductivities (K) and diffusion coefficients (D) for compacted bentonite and four host rocks have been measured and re-interpreted. Based on these new data, K for compacted bentonite is less than 10−14 m/s, a factor of 1000 lower than previous pressure-gradient measurements, providing further assurance that radionuclide transport through bentonite backfill will be diffusion limited. Measured K for mudstone (1.8 × 10−12 m/s) indicates diffusion-limited far-field transport, while advective transport should occur for granite, basalt, and tuff, with expected matrix diffusion coefficients (correlated to measured D values) of 8.3 × 10−13 and 2.5 × 10−12 m2/s for fractured granite and basalt, respectively.


1999 ◽  
Vol 556 ◽  
Author(s):  
Akiko Okamoto ◽  
Kazuya Idemitsu ◽  
Hirotaka Furuya ◽  
Yaohiro Inagaki ◽  
Tatsumi Arima

AbstractDistribution coefficients and apparent diffusion coefficients of cesium in some compacted bentonites were determined by the penetration profile method. Cylindrical compacted bentonites with the dry density of 0.8 to 1.6 Mg/m3 were contacted with tracer solutions containing 1000, 100 or 10 ppm of cesium. The apparent diffusion coefficients were obtained from the concentration profiles of cesium in compacted bentonites. The distribution coefficients were obtained concurrently by dividing the intercepts of the profiles by the concentration of the tracer solution. The apparent diffusion coefficients of cesium in compacted bentonite were obtained in the range of 0.42 to 9.6· 10−12 m2/s. The apparent diffusion coefficients in the compacted bentonite contacted with three different concentrations of cesium tended to decrease with increasing dry density of the specimen; but, they had no dependence on cesium concentration within a factor of 3 at the same dry density. The distribution coefficient of cesium for the specimens contacted with three different concentrations of cesium were obtained in the range of 0.3 to 90 L/kg and had little dependence on dry density. The distribution coefficients obtained in the compacted bentonites were dependent on pH of the solution rather than concentration of cesium. These distribution coefficients obtained in the compacted bentonites were 10 to 1000 times smaller than those obtained by batch experiments. The data suggest that not all sorption sites for cesium are available in highly compacted bentonite. It is necessary to consider surface diffusion as a significant migration mechanism of cesium through the compacted bentonites at very high pH condition such as 12.


2006 ◽  
Vol 932 ◽  
Author(s):  
Dušan Vopálka ◽  
Helena Filipská ◽  
Antonín Vokál

ABSTRACTThe results of 3H, 36Cl and 137Cs diffusion experiments through compacted bentonite using a new design of diffusion cell and a new methodology of diffusion coefficients evaluation are presented. The diffusion cell was made from the stainless steel and enables to connect it directly to the input and/or output reservoirs without any tubing. The evaluation of diffusion coefficients utilizes a compartmental model developed in the environment of the GoldSim transport code. It enables to determine diffusion coefficients for various types of boundary conditions, including also input and output filters. The influence of the diffusion through filters on the determined values of both effective (De) and apparent (Da) diffusion coefficients was numerically demonstrated for the through diffusion method. This effect is most important for Da, the value of which would be underestimated using standard ways of evaluation for neutral and positively charged species, mainly in the case of high effective porosity.The comparison of standard and the newly developed method of evaluation of diffusion coefficients showed a significant influence of diffusion in filters for HTO. Contrary to the standard method of evaluation, the evaluation taking into account filters showed here no difference between total and effective porosity. The effect of filter resistance was negligible for Cl-, especially at high dry density of compacted bentonite, due to the anion exclusion effect. The numerical model developed enabled to determine Da values of Cs+ from the concentration change in the inlet reservoir.


1997 ◽  
Vol 506 ◽  
Author(s):  
Mamoru Nakajima ◽  
Tamotsu Kozaki ◽  
Hiroyasu Kato ◽  
Seichi Sato ◽  
Hiroshi Ohashi

ABSTRACTCompacted bentonite is a candidate buffer material in geological disposal of high-level radioactive waste. The transport of radionuclides in compacted bentonite is dominated by diffusion, because of its very low permeability. In this study, we focused on the grain size of clay mineral, which is considered to be closely related to the formation factor in the pore water diffusion model[1,2]. The apparent diffusion coefficients (Da) of HTO and cesium ions in compacted clays were determined using montmorillonite samples with different grain size and dry density, and the effect of the grain size on diffusion behavior was discussed.


1989 ◽  
Vol 16 (4) ◽  
pp. 434-443 ◽  
Author(s):  
S. C. H. Cheung

The methods used to determine apparent diffusion coefficients and the appropriate parameters for modelling diffusion through compacted bentonite–water systems are assessed and discussed. The measured apparent diffusion coefficient can vary between methods. The discrepancies are shown to be due to heterogeneous diffusivities arising from the proximity of the surface of clay particles. Two different diffusivity pathways are identified and the diffusive flux is shown to be dictated by the charge of diffusing species, diffusion time, and soil fabric. Key words: apparent diffusion coefficient, methods, compacted bentonite, heterogeneous diffusion, parameters, pathways.


MRS Advances ◽  
2016 ◽  
Vol 1 (61) ◽  
pp. 4011-4017
Author(s):  
Ryo Hamada ◽  
Noriyuki Maeda ◽  
Kazuya Idemitsu ◽  
Yaohiro Inagaki ◽  
Tatsumi Arima ◽  
...  

ABSTRACTIn disposing of high-level radioactive waste, the drop in pH in the repository as the iron overpack corrodes must be considered. Plutonium migration behavior may be affected by the pH of pore water in compacted bentonite barriers in high-level waste repositories. To examine the effect of pH on migration behavior, H-bentonite was prepared by treating Japanese Na-bentonite, Kunipia-F, with hydrochloric acid. Diffusion experiments were performed with mixtures of Na- and H-bentonites. The pH value in the pore water of the water-saturated bentonite mixtures decreased from 8 to 3 as the mixing ratio of H-bentonite increased. Diffusion experiments were carried out by using238Pu then apparent diffusion coefficients were determined from the plutonium distribution in the specimens. The apparent diffusion coefficients were on the order of 10-13to 10-12m2/s at pH values lower than 4, whereas they were less than 10-14m2/s at pH values higher than 6.5. These results indicate that plutonium diffused faster as Pu3+or PuO22+due to disproportionation at lower pH while plutonium could be retarded as Pu(OH)40by sorption on bentonite at higher pH.


2003 ◽  
Vol 61 (1-4) ◽  
pp. 63-72 ◽  
Author(s):  
José Luis Cormenzana ◽  
Miguel Garcı́a-Gutiérrez ◽  
Tiziana Missana ◽  
Álvaro Junghanns

1994 ◽  
Vol 353 ◽  
Author(s):  
T. Kozaki ◽  
Y. Imamura ◽  
J. Takada ◽  
S. Sato ◽  
H. Ohashi

AbstractFor safety assessment of the geological disposal of the high level radioactive waste, it is necessary to study corrosion of the overpack materials and migration of the corrosion products in the compacted bentonite. In the present study, average corrosion rates of iron foil and apparent diffusion coefficients of the corrosion products were determined using a neutron- activated iron foil. The average corrosion rates were on the order of 10-6m/y, while apparent diffusion coefficients were in the range from 10-12 to 10-14m2/s. No tendency to decrease in the corrosion rates with increasing corrosion time was observed. This suggests that the iron foil corrodes under reducing condition. Asymmetric concentration profiles of iron corrosion products were obtained in some experiments. It can be considered that either cathodic or anodic reaction would dominantly occur on one side of the iron foil surfaces and that each reaction would change the pH in pore water of bentonite specimens adjacent to the iron foil surfaces.


Sign in / Sign up

Export Citation Format

Share Document