Models for predicting carbonaceous disinfection by-products formation in drinking water treatment plants: a case study of South Korea

2019 ◽  
Vol 27 (20) ◽  
pp. 24594-24603 ◽  
Author(s):  
Nirmal Kumar Shahi ◽  
Minsoo Maeng ◽  
Seok Dockko
2012 ◽  
Vol 48 (1-3) ◽  
pp. 221-231 ◽  
Author(s):  
Qiang Zhang ◽  
Yan Liu ◽  
Yuanyuan Wei ◽  
Zhexue Quan ◽  
Yun Zhang ◽  
...  

2013 ◽  
Vol 777 ◽  
pp. 337-340
Author(s):  
Qiang Zhang ◽  
Bin Liu

The variation of disinfection by-products (DBPs) at several stages of drinking water treatment plants was investigated in two drinking water plants. The results clearly indicate that the low molecular weight total organic carbon (TOC) which has been identified as primary precursor for chlorinated DBPs was difficult to remove by coagulation. Plant A which used conventional coagulation/sedimentation could not decrease the species of trihalomethanes (THMs) and haloacetic acids (HAAs) formation potential. Biological activated carbon (BAC) was applied in Plant B which removed the maximum amount of TOC, while more kinds of microbial products were produced in BAC unit which could be the potential precursors of DBPs. Therefore, the species of DBPs formation potential still increased in the treatment processes of Plant B. Because different components of organic precursors produced different DBPs species, the processes of Plant B could decrease TOC efficiently but the species of THMs and HAAs formation potential.


2000 ◽  
Vol 41 (7) ◽  
pp. 135-142
Author(s):  
P. Lipp ◽  
G. Baldauf

Measurements of parasites in surface waters in Germany showed that their presence is widely spread. Concentrations may reach values up to a maximum of 50 cysts per 100 l. Normally raw waters used for drinking water production show much lower values. In order to ensure sufficient parasite removal in drinking water treatment plants an enhancement of particle removal is required. For filtration processes parameters influencing particle removal are filter media, filtration velocity, flocculant dosage, preozonationand filter back wash. Moderate filtration conditions show best results. Three case studies show that preozonation, optimized energy input and use of flocculants improve particle removal. One case study shows results of the first ultrafiltration plant in Germany treating reservoir and spring water for drinking water production.


2021 ◽  
Vol 13 (8) ◽  
pp. 4327
Author(s):  
Tomáš Brabenec ◽  
Anna Maroušková ◽  
Tomáš Zoubek ◽  
Martin Filip

From the moment it was first indicated that use of aluminum chloride during purification of drinking water might be one of the triggers of Alzheimer’s disease, it took only a few years to almost abandon this practice worldwide. Now, two years after the initial evidence was presented that the cheapest possible replacement for aluminum chloride (ferric hydroxide, better known as ferrous sludge) significantly threatens soil fertility, there is almost no action. A robust case study was conducted among European drinking water treatment plants. First, it is reported that some samples of ferrous sludge can reduce phosphorus availability by more than 70%. This creates a precondition for a significant reduction in fertility over a decade. Because the legislation usually responds to similar findings with great delay, the extent to which managers of drinking water treatment plants are willing to change process settings by themselves has also been assessed. The findings obtained allow us to expect that a long continuation of this hazardous practice can be expected, since managers of drinking water treatment plants show little willingness to switch from the ongoing questionable technology (harmful to nutrient cycles in soil) to environmentally favorable (though slightly more costly) solutions.


2019 ◽  
Vol 149 ◽  
pp. 104008 ◽  
Author(s):  
Dávid Stefán ◽  
Norbert Erdélyi ◽  
Bálint Izsák ◽  
Gyula Záray ◽  
Márta Vargha

Sign in / Sign up

Export Citation Format

Share Document