Effect of Ar bombardment on the electrical and optical properties of low-density polyethylene films

Pramana ◽  
2016 ◽  
Vol 87 (5) ◽  
Author(s):  
M F ZAKI ◽  
M M EL TABAY ◽  
R M RADWAN
Keyword(s):  
Optical Properties ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Electrical And Optical Properties ◽  
Polyethylene Films

scholarly journals Low-Density Polyethylene Films Carrying ferula asafoetida Extract for Active Food Packaging: Thermal, Mechanical, Optical, Barrier, and Antifungal Properties

2020 ◽  
Vol 2020 ◽  
pp. 1-15
Author(s):  
Razieh Niazmand ◽  
Bibi Marzieh Razavizadeh ◽  
Farzaneh Sabbagh
Keyword(s):  
Polymer Matrix ◽  
Food Packaging ◽  
Barrier Properties ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Optical Barrier ◽  
Leaf Extracts ◽  
Polyethylene Films ◽  
Active Food Packaging ◽  
Ferula Asafoetida

The physical, thermal, mechanical, optical, microstructural, and barrier properties of low-density polyethylene films (LDPE) containing ferula asafoetida leaf and gum extracts were investigated. Results showed a reduction in elasticity and tensile strength with increasing extract concentration in the polymer matrix. The melting temperature and enthalpy increased with increasing concentration of extracts. The films containing extracts had lower L∗ and a∗ and higher b∗ indices. The films containing leaf extract had more barrier potential to UV than the gum extracts. The oxygen permeability in films containing 5% of leaf and gum extracts increased by 2.3 and 2.1 times, respectively. The morphology of the active films was similar to bubble swollen islands, which was more pronounced at higher concentrations of gum and leaf extracts. FTIR results confirmed some chemical interactions of ferula extracts with the polymer matrix. At the end of day 14th, the growth rate of Aspergillus niger and Saccharomyces cerevisea in the presence of the PE-Gum-5 reduced more than PE-Leaf-5 (3.7 and 2.4 logarithmic cycles, respectively) compared to the first day. Our findings showed that active LDPE films have desire thermo-mechanical and barrier properties for food packaging.

The use of recycled low‐density polyethylene films from protective prepreg for the development of nanocomposites with bentonite clay

2021 ◽  
pp. 50559
Author(s):  
Pamela Rodrigues Passos Severino ◽  
Natália Ferreira Braga ◽  
Guilherme Ferreira Morgado ◽  
Juliano Marini ◽  
Orestes Ferro ◽  
...  
Keyword(s):  
Bentonite Clay ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Polyethylene Films ◽  
Recycled Low Density Polyethylene

Physicomechanical, optical, barrier, and WAXS studies of filled linear low-density polyethylene films

2003 ◽  
Vol 90 (11) ◽  
pp. 2938-2944 ◽  
Author(s):  
Siddaramaiah ◽  
T. Jeevananda ◽  
K. S. Jagadeesh ◽  
H. Somashekarappa ◽  
R. Somashekar
Keyword(s):  
Low Density Polyethylene ◽  
Low Density ◽  
Linear Low Density Polyethylene ◽  
Optical Barrier ◽  
Polyethylene Films

Effect of UV Treatment on Optical Properties of Low-Density Polyethylene Films Doped with Eu(TTA)3phen Complex

2014 ◽  
Vol 895 ◽  
pp. 155-161
Author(s):  
M.I. Khairuldin ◽  
N.M.A. Aziz ◽  
N.M. Nashaain ◽  
S. Wedianti ◽  
I. Farehah ◽  
...  
Keyword(s):  
Optical Properties ◽  
Emission Spectra ◽  
Low Density Polyethylene ◽  
Rare Earth Complex ◽  
Low Density ◽  
Uv Treatment ◽  
Uv Spectrum ◽  
Light Manipulation ◽  
Emission Transition ◽  
Ft Ir

Low-Density Polyethylene (LDPE) films doped with Eu (TTA)3phen complex (TTA=2-thenoyltrifluoroacetone, phen=1,10-phenanthroline) were fabricated by hot-blowing technique for thickness of 100 μm. The films were doped with 0.1 % of Eu (TTA)3phen to the total weight of LDPE and exposed to UV irradiation from deuterium lamp for 5, 10, 20, 40 and 60 hours to investigate the effect of its optical properties. The films were characterized by Spectrofluorometer, UV/VIS Spectrophotometer and FT-IR Spectrometer to measure their emission spectra, lifetimes, transmission transparency and chemical bonding. Photoluminescence of the room-temperature Eu (TTA)3phen doped films consist of typical Eu3+emission transition lines with hypersensitive5D07F2emission band at 610 nm. After 20 hours UV treatment, the peak intensity dropped by 90 % and shortened the luminescent lifetimes from 0.654 ms to 0.305 ms. Longer UV treatment also has accelerated degradation in doped LDPE films shown by significant reducing in absorption peak of FTIR at 3395, 3186 and 1645 cm-1. The results would provide a mechanism to improve the lifetime of the LDPE by utilizing the light-manipulation property of Eu (TTA)3phen complex to absorb UV spectrum and covert into red emission.Keywords: LDPE, rare-earth complex, photoluminescence

Temperature Dependence of Degradation of Colored Oxo-Biodegradable Low-Density Polyethylene Films under Accelerated Thermal Aging

2017 ◽  
Vol 890 ◽  
pp. 82-85 ◽  
Author(s):  
Reymark D. Maalihan ◽  
Bryan B. Pajarito
Keyword(s):  
Thermal Aging ◽  
Degradation Products ◽  
Low Density Polyethylene ◽  
Effect Of Temperature ◽  
Low Density ◽  
Polyethylene Films ◽  
Hot Air ◽  
Taguchi Design Of Experiments ◽  
Oxidant Concentration ◽  
The Stability

This work reports the effect of temperature on degradation of colored low-density polyethylene (PE) films during thermal aging. Film samples were formulated according to Taguchi design of experiments where colorant, thickness, and pro-oxidant concentration were varied accordingly. Tensile properties of films were monitored with time during heat aging in a hot air oven at 50, 70, and 90 °C. Likewise, surfaces of aged films were analyzed to evaluate the degree of oxidation of PE during thermal aging. The Arrhenius equation was then used to predict the lifetime of PE at an in-use temperature of 30 °C. Results indicate that increasing the temperature reduces the tensile strength and modulus of films. Formation of carbonyl groups as degradation products is also observed at higher temperatures. Consequently, thermal aging at 90 °C offers the highest extent of degradation of exposed films. Regression analysis reveals that white films degrade at a higher rate than yellow and non-colored films. The presence of TiO2 in white films shortens the lifetime of PE while amine stabilizer in yellow films enhances the stability of PE during thermal aging.

Effect of Blending on Electrical Conduction and Breakdown of Low-Density Polyethylene Films with Different Densities

2001 ◽  
Vol 40 (Part 1, No. 1) ◽  
pp. 206-212 ◽  
Author(s):  
Don-Chan Cho ◽  
Tatsuo Mori ◽  
Teruyoshi Mizutani ◽  
Mitsugu Ishioka
Keyword(s):  
Electrical Conduction ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Polyethylene Films

scholarly journals EFFECTIVENESS OF CERTAIN STABILIZERS ON THE AGEING OF POLYETHYLENE FILMS

1998 ◽  
Vol 6 (6) ◽  
pp. 71-76
Author(s):  
S. JIPA ◽  
R. SETNESCU ◽  
T. SETNESCU ◽  
C. PODINA ◽  
J. MIHALCEA
Keyword(s):  
High Density Polyethylene ◽  
High Density ◽  
Low Density Polyethylene ◽  
Phenolic Antioxidants ◽  
Low Density ◽  
Chemiluminescence Method ◽  
Antioxidant Efficiency ◽  
Polyethylene Films

The effectiveness of different phenolic antioxidants on high-density polyethylene (HDPE) and low-density polyethylene (LDPE) has been studied by the Isothermal chemiluminescence method. The decreasing order of the antioxidant efficiency for these polymers Is as follows: lrganox 1010 >> Etanox 330 > lrganox 1076 (Hostanox 016) > Topanol OC

Sign in / Sign up

Export Citation Format

Share Document