scholarly journals Partial replacement of cement with granular marble residue: effects on the properties of cement pastes and reduction of CO2 emission

2020 ◽  
Vol 2 (9) ◽  
Author(s):  
Tatiane Santos ◽  
Jardel P. Gonçalves ◽  
Heloysa M. C. Andrade
2018 ◽  
Vol 12 (SE) ◽  
pp. 87-94
Author(s):  
Zbigniew ŁUKASIK ◽  
Jacek KOZYRA ◽  
Aldona KUŚMIŃSKA-FIJAŁKOWSKA

2019 ◽  
Vol 967 ◽  
pp. 205-213
Author(s):  
Faiz U.A. Shaikh ◽  
Anwar Hosan

This paper presents the effect of nanosilica (NS) on compressive strength and microstructure of cement paste containing high volume slag and high volume slag-fly ash blend as partial replacement of ordinary Portland cement (OPC). Results show that high volume slag (HVS) cement paste containing 60% slag exhibited about 4% higher compressive strength than control cement paste, while the HVS cement paste containing 70% slag maintained the similar compressive strength to control cement paste. However, about 9% and 37% reduction in compressive strength in HVS cement pastes is observed due to use of 80% and 90% slag, respectively. The high volume slag-fly ash (HVSFA) cement pastes containing total slag and fly ash content of 60% exhibited about 5%-16% higher compressive strength than control cement paste. However, significant reduction in compressive strength is observed in higher slag-fly ash blends with increasing in fly ash contents. Results also show that the addition of 1-4% NS improves the compressive strength of HVS cement paste containing 70% slag by about 9-24%. However, at higher slag contents of 80% and 90% this improvement is even higher e.g. 11-29% and 17-41%, respectively. The NS addition also improves the compressive strength by about 1-59% and 5-21% in high volume slag-fly ash cement pastes containing 21% fly ash+49%slag and 24% fly ash+56%slag, respectively. The thermogravimetric analysis (TGA) results confirm the reduction of calcium hydroxide (CH) in HVS/HVSFA pastes containing NS indicating the formation of additional calcium silicate hydrate (CSH) gels in the system. By combining slag, fly ash and NS in high volumes e.g. 70-80%, the carbon footprint of cement paste is reduced by 66-76% while maintains the similar compressive strength of control cement paste. Keywords: high volume slag, nanosilica, compressive strength, TGA, high volume slag-fly ash blend, CO2 emission.


2019 ◽  
Vol 50 (1) ◽  
pp. 30-34 ◽  
Author(s):  
Elżbieta Horszczaruk ◽  
Piotr Brzozowski

The utilization of solid waste materials or industrial waste as partial substitution of cement is growing in construction industry all around world. Less cement consumption causes consequently reduction in CO2 emission into the atmosphere and reduction in energy consumption. This paper examines the possibility of using finely ground waste glass as a partial replacement for cement and as a sealing admixture. Glass powder used in the research was prepared from the glass waste obtained from a local recycling company. Glass cullet made of brown glass, which after rinsing to remove sugars and other impurities, was dried and ground to a fraction below 125 μm.This paper is the revised version of the paper that has been published in the Proceedings of the Creative Construction Conference 2018 (Horszczaruk and Brzozowski, 2018).


2018 ◽  
Vol 765 ◽  
pp. 324-328
Author(s):  
Tiago Assunção Santos ◽  
José da Silva Andrade Neto ◽  
Vitor Souza Santos ◽  
Daniel Véras Ribeiro

Due to the concern with the environmental impacts caused by the gases emitted by the cement industry and by the inadequate disposal of wastes generated in the sugar-alcohol industry, such as sugarcane bagasse ash (SCBA), a search for the development of new technologies, which are less aggressive to the environment and that propose feasible alternatives, began in order to reuse these wastes properly. Among these alternatives is the reuse of SCBA as partial replacement to cement or as addition to cementitious matrices. In this way, the present research has the objective of analyzing the influence of SCBA obtained by the calcination of sugarcane bagasse (SCB), at 600°C, in the process of Portland cement hydration. Initially, the SCBA was characterized physically, chemically and mineralogically, and then cement pastes with 20% and 35% substitution contents were elaborated, besides the reference paste, which were analyzed through X-ray diffraction (XRD) and thermogravimetric (TG) techniques. The results obtained show that there is a consumption of portlandite as a consequence of the use of SCBA, evidencing the pozolanicity of these ashes. In the pastes with 35% substitution content, there was an intense consumption of the portlandite, indicating, in this proportion, the pozzolanic reaction was more intense.


Sign in / Sign up

Export Citation Format

Share Document