Deformation behavior and slip systems of quenched β-CuZn single crystals

1979 ◽  
Vol 27 (7) ◽  
pp. 1219-1230 ◽  
Author(s):  
S. Hanada ◽  
H. Yamamoto ◽  
O. Izumi
1996 ◽  
Vol 460 ◽  
Author(s):  
M. Moriwaki ◽  
K. Ito ◽  
H. Inui ◽  
M. Yamaguchi

ABSTRACTThe deformation behavior of single crystals of Mo(Si,Al)2 with the C40 structure has been studied as a function of crystal orientation and Al content in the temperature range from room temperature to 1500°C in compression. Plastic flow is possible only above 1100°C for orientations where slip along <1120> on (0001) is operative and no other slip systems are observed over whole temperature range investigated. The critical resolved shear stress for basal slip decreases rapidly with increasing temperature and the Schmid law is valid. Basal slip appears to occur through a synchroshear mechanism, in which a-dislocations (b=1/3<1120>) dissociate into two synchro-partial dislocations with the identical Burgers vector(b*1/6<1120>) and each synchro-partial further dissociates into two partials on two adjacent planes.


1998 ◽  
Vol 552 ◽  
Author(s):  
R. Srinivasan ◽  
M. F. Savage ◽  
R. D. Noebe ◽  
M. J. Mills

ABSTRACTNi-44A1, Ni-50Al and NiAl-0.3 at.% Hf single crystals have been studied in compression to understand the effects that alloying additions and deviation from stoichiometry can have on the mechanical response of NiAl-based single crystals. While all three single crystals deform through a<111> slip at lower temperatures, the active slip systems differ at higher temperatures. Climb of a<010> dislocations contributes to deformation in Ni-50AI single crystals beyond the slip transition temperature, while Ni-44Al and NiAl-0.3Hf crystals deform through a<101> glide. But several microstructural differences have been observed in the mode of deformation between Ni-44Al and NiAl-0.3Hf crystals. In addition, significant strengthening is exhibited in the Hf-doped crystals at higher temperatures. The post-deformation microstructure is also observed to be sensitive to both strain and strain rate. A possible explanation is offered for some of the observed differences in deformation behavior between the three alloys.


1994 ◽  
Vol 364 ◽  
Author(s):  
K. Ito ◽  
T. Yano ◽  
H. Inui ◽  
M. Yamaguchi

AbstractThe deformation behavior of MoSi2 single crystals has been studied in the temperature range of -196<1500°C. While [001]-oriented crystals can be plastically deformed only above 1300°C, plastic flow is possible from temperatures as low as room temperature for single crystals with orientations other than [001]. Five slip systems, {110)<111], {011)<100], {010)<100], {023)<100] and {013)<331], are identified to be operative, depending on crystal orientation. An anomalous increase in CRSS is observed in the intermediate temperature range for the former three slip systems. Schmid’s law is generally valid for the soft modes, {110)<111], {011)<100] and {023)<100]. In contrast, the CRSS for the hard mode, {013)<331], strongly depends on crystal orientation with the higher values for orientations closer to [001].


2012 ◽  
Vol 706-709 ◽  
pp. 1122-1127 ◽  
Author(s):  
Shinji Ando ◽  
Masayuki Tsushida ◽  
Hiromoto Kitahara

Zn and Al are major alloying elements of Mg alloys. Main slip system of Mg is a basal slip and the CRSS increases with Zn or Al content. According to von-Mises criterion, five kinds of independent slip systems are required for uniform deformation, so it is necessary to activate non-basal slip systems to show good ductility. However, it has not become clear the effect of Zn or Al for non-basal slip systems yet. To investigate deformation behavior of magnesium crystal by non-basal slip, Mg-Zn and Mg-Al single crystals were stretched in the [110] direction and Mg-Zn single crystals were compressed in the [0001] direction. {112}<23> second order pyramidal slip was activated in Mg-0.1at%Zn and Mg-0.5at%Al. On the other hand, {101} twin was mainly activated in Mg-1.0at%Al alloy. Yield stress due to the pyramidal slip of magnesium decreased by 0.1at%Zn addition, however they increased with addition of aluminum..


1992 ◽  
Vol 114 (1) ◽  
pp. 19-26 ◽  
Author(s):  
E. H. Jordan ◽  
K. P. Walker

A viscoplastic constitutive model is described in which deformation behavior is postulated on representative slip systems and the behavior of the entire crystal is determined by summing the slip on the active slip systems. By building in the slip geometry known from the metallurgical literature, it is possible to predict the anisotropic deformation behavior and to model in a straightforward manner other phenomena which have been described by metallurgists in crystallographic terms. Elevated temperature tension-torsion tests were run and used to verify the model’s predictive abilities. Ratchetting behavior under thermomechanical loading conditions is specifically addressed.


Author(s):  
J. R. Fekete ◽  
R. Gibala

The deformation behavior of metallic materials is modified by the presence of grain boundaries. When polycrystalline materials are deformed, additional stresses over and above those externally imposed on the material are induced. These stresses result from the constraint of the grain boundaries on the deformation of incompatible grains. This incompatibility can be elastic or plastic in nature. One of the mechanisms by which these stresses can be relieved is the activation of secondary slip systems. Secondary slip systems have been shown to relieve elastic and plastic compatibility stresses. The deformation of tungsten bicrystals is interesting, due to the elastic isotropy of the material, which implies that the entire compatibility stress field will exist due to plastic incompatibility. The work described here shows TEM observations of the activation of secondary slip in tungsten bicrystals with a [110] twist boundary oriented with the plane normal parallel to the stress axis.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Zhenghao Chen ◽  
Bhaskar Paul ◽  
Sanjib Majumdar ◽  
Norihiko L. Okamoto ◽  
Kyosuke Kishida ◽  
...  

AbstractThe plastic deformation behavior of single crystals of two transition-metal diborides, ZrB2 and TiB2 with the AlB2 structure has been investigated at room temperature as a function of crystal orientation and specimen size by micropillar compression tests. Although plastic flow is not observed at all for their bulk single crystals at room temperature, plastic flow is successfully observed at room temperature by the operation of slip on {1$${\bar{1}}$$ 1 ¯ 00}<11$${\bar{2}}$$ 2 ¯ 3> in ZrB2 and by the operation of slip on {1$${\bar{1}}$$ 1 ¯ 00}<0001> and {1$${\bar{1}}$$ 1 ¯ 00}<11$${\bar{2}}$$ 2 ¯ 0> in TiB2. Critical resolve shear stress values at room temperature are very high, exceeding 1 GPa for all observed slip systems; 3.01 GPa for {1$${\bar{1}}$$ 1 ¯ 00}<11$${\bar{2}}$$ 2 ¯ 3> slip in ZrB2 and 1.72 GPa and 5.17 GPa, respectively for {1$${\bar{1}}$$ 1 ¯ 00}<0001> and {1$${\bar{1}}$$ 1 ¯ 00}<11$${\bar{2}}$$ 2 ¯ 0> slip in TiB2. The identified operative slip systems and their CRSS values are discussed in comparison with those identified in the corresponding bulk single crystals at high temperatures and those inferred from micro-hardness anisotropy in the early studies.


Sign in / Sign up

Export Citation Format

Share Document