A petrologic and ion microprobe study of a Vigarano Type B refractory inclusion: Evolution by multiple stages of alteration and melting

Yumoto and Dmochowski (Cancer Res.27, 2098 (1967)) reported the presence of mature and immature type C leukemia virus particles in leukemic organs and tissues such as lymph nodes, spleen, thymus, liver, and kidneys of SJL/J strain mice with Hodgki's-like disease or reticulum cell neoplasm (type B). In an attempt to ascertain the possibility that this neoplasia may be of viral origin, experiments with induction and transmission of this neoplasm were carried out using cell-free extracts of leukemic organs from an SJL/J strain mouse with spontaneous disease.It has been possible to induce the disease in low-leukemia BALB/c and C3HZB strain mice and serially transfer the neoplasia by cell-free extracts of leukemic organs of these mice. Histological examination revealed the neoplasia to be of either reticulum cell-type A or type B. Serial transfer is now in its fifth passage. In addition leukemic spleen from another SJL/J strain mouse with spontaneous reticulum cell neoplasm (type A) was set up in tissue culture and is now in its 141st serial passage in vitro. Preliminary results indicate that cell-free material of 39th tissue culture passage can reproduce neoplasia in BALB/c mice.

Download Full-text

Microchemistry of ZnO Varistors

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100133102 ◽

1992 ◽

Vol 50 (2) ◽

pp. 1694-1695

Author(s):

K. K. Soni ◽

J. Hwang ◽

V. P. Dravid ◽

T. O. Mason ◽

R. Levi-Setti

Keyword(s):

Grain Boundaries ◽

Multiple Roles ◽

Grain Boundary Engineering ◽

Ion Microprobe ◽

Dopant Distribution ◽

Important Ingredient ◽

Zno Varistor ◽

Zno Varistors ◽

Zno Powder ◽

The University

ZnO varistors are made by mixing semiconducting ZnO powder with powders of other metal oxides e.g. Bi2O3, Sb2O3, CoO, MnO2, NiO, Cr2O3, SiO2 etc., followed by conventional pressing and sintering. The non-linear I-V characteristics of ZnO varistors result from the unique properties that the grain boundaries acquire as a result of dopant distribution. Each dopant plays important and sometimes multiple roles in improving the properties. However, the chemical nature of interfaces in this material is formidable mainly because often trace amounts of dopants are involved. A knowledge of the interface microchemistry is an essential component in the ‘grain boundary engineering’ of materials. The most important ingredient in this varistor is Bi2O3 which envelopes the ZnO grains and imparts high resistance to the grain boundaries. The solubility of Bi in ZnO is very small but has not been experimentally determined as a function of temperature.In this study, the dopant distribution in a commercial ZnO varistor was characterized by a scanning ion microprobe (SIM) developed at The University of Chicago (UC) which offers adequate sensitivity and spatial resolution.

Download Full-text

Aspects of high-resolution imaging with a scanning ion microprobe

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010014511x ◽

1986 ◽

Vol 44 ◽

pp. 750-751

Author(s):

R. Levi-Setti ◽

J. M. Chabala ◽

Y. L. Wang

Keyword(s):

Metal Ion ◽

Secondary Ion Mass Spectrometry ◽

Chromatic Aberration ◽

Ion Source ◽

Ion Microprobe ◽

Emission Pattern ◽

Intrinsic Resolution ◽

Resolution Imaging ◽

20 Nm ◽

Secondary Ion

We have shown the feasibility of 20 nm lateral resolution in both topographic and elemental imaging using probes of this size from a liquid metal ion source (LMIS) scanning ion microprobe (SIM). This performance, which approaches the intrinsic resolution limits of secondary ion mass spectrometry (SIMS), was attained by limiting the size of the beam defining aperture (5μm) to subtend a semiangle at the source of 0.16 mr. The ensuing probe current, in our chromatic-aberration limited optical system, was 1.6 pA with Ga+ or In+ sources. Although unique applications of such low current probes have been demonstrated,) the stringent alignment requirements which they imposed made their routine use impractical. For instance, the occasional tendency of the LMIS to shift its emission pattern caused severe misalignment problems.

Download Full-text

Cryo-electron microscopy of two-dimensional crystals of reduced type B botulinum neurotoxin

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100123052 ◽

1992 ◽

Vol 50 (1) ◽

pp. 530-531

Author(s):

P. F. Flicker ◽

V.S. Kulkarni ◽

J. P. Robinson ◽

G. Stubbs ◽

B. R. DasGupta

Keyword(s):

Disulfide Bonds ◽

Clostridium Botulinum ◽

Structural Changes ◽

Two Dimensional ◽

Type B ◽

Single Chain ◽

Muscle Paralysis ◽

Cryo Electron Microscopy ◽

Disulfide Linkages ◽

Intracellular Action

Botulinum toxin is a potent neurotoxin produced by Clostridium botulinum. The toxin inhibits release of neurotransmitter, causing muscle paralysis. There are several serotypes, A to G, all of molecular weight about 150,000. The protein exists as a single chain or or as two chains, with two disulfide linkages. In a recent investigation on intracellular action of neurotoxins it was reported that type B neurotoxin can inhibit the release of Ca++-activated [3H] norepinephrine only if the disulfide bonds are reduced. In order to investigate possible structural changes in the toxin upon reduction of the disulfide bonds, we have prepared two-dimensional crystals of reduced type B neurotoxin. These two-dimensional crystals will be compared with those of the native (unreduced) type B toxin.

Download Full-text

Imaging of Al-Li-Cu alloys with a Scanning Ion Microprobe

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100135174 ◽

1990 ◽

Vol 48 (2) ◽

pp. 314-315

Author(s):

K.K. Soni ◽

D.B. Williams ◽

J.M. Chabala ◽

R. Levi-Setti ◽

D.E. Newbury

Keyword(s):

Mass Spectrometry ◽

Secondary Ion Mass Spectrometry ◽

Equilibrium Phase ◽

Icosahedral Symmetry ◽

Ion Microprobe ◽

X Ray ◽

Cu Alloys ◽

Two Phases ◽

The University ◽

Secondary Ion

In contrast to the inability of x-ray microanalysis to detect Li, secondary ion mass spectrometry (SIMS) generates a very strong Li+ signal. The latter’s potential was recently exploited by Williams et al. in the study of binary Al-Li alloys. The present study of Al-Li-Cu was done using the high resolution scanning ion microprobe (SIM) at the University of Chicago (UC). The UC SIM employs a 40 keV, ∼70 nm diameter Ga+ probe extracted from a liquid Ga source, which is scanned over areas smaller than 160×160 μm2 using a 512×512 raster. During this experiment, the sample was held at 2 × 10-8 torr.In the Al-Li-Cu system, two phases of major importance are T1 and T2, with nominal compositions of Al2LiCu and Al6Li3Cu respectively. In commercial alloys, T1 develops a plate-like structure with a thickness <∼2 nm and is therefore inaccessible to conventional microanalytical techniques. T2 is the equilibrium phase with apparent icosahedral symmetry and its presence is undesirable in industrial alloys.

Download Full-text

Fluidized Catalytic Cracking Catalyst Microstructure as Determined by A Scanning Ion Microprobe

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100135113 ◽

1990 ◽

Vol 48 (2) ◽

pp. 302-303

Author(s):

J.K. Lampert ◽

G.S. Koermer ◽

J.M. Macaoy ◽

J.M. Chabala ◽

R. Levi-Setti

Keyword(s):

Catalytic Cracking ◽

Secondary Ion Mass Spectrometry ◽

Fuel Oil ◽

Ion Microprobe ◽

Fluidized Catalytic Cracking ◽

Ion Probe ◽

Silica Alumina ◽

Resolution Imaging ◽

The University ◽

High Spatial Resolution Imaging

We have used high spatial resolution imaging secondary ion mass spectrometry (SIMS) to differentiate mineralogical phases and to investigate chemical segregations in fluidized catalytic cracking (FCC) catalyst particles. The oil industry relies on heterogeneous catalysis using these catalysts to convert heavy hydrocarbon fractions into high quality gasoline and fuel oil components. Catalyst performance is strongly influenced by catalyst microstructure and composition, with different chemical reactions occurring at specific types of sites within the particle. The zeolitic portions of the particle, where the majority of the oil conversion occurs, can be clearly distinguished from the surrounding silica-alumina matrix in analytical SIMS images.The University of Chicago scanning ion microprobe (SIM) employed in this study has been described previously. For these analyses, the instrument was operated with a 40 keV, 10 pA Ga+ primary ion probe focused to a 30 nm FWHM spot. Elemental SIMS maps were obtained from 10×10 μm2 areas in times not exceeding 524s.

Download Full-text