Soil bulk density, penetration resistance, and hydraulic conductivity under controlled traffic conditions

1996 ◽  
Vol 37 (1) ◽  
pp. 67-75 ◽  
Author(s):  
P Unger
Soil Research ◽  
2003 ◽  
Vol 41 (6) ◽  
pp. 1063 ◽  
Author(s):  
G. J. Sheridan

Compaction of a silty clay loam forest soil was compared for 2 types of log-skidding equipment, a rubber-tyred skidder and a flexible-steel-tracked skidder. Experiments involved the loaded skidders traversing marked laneways at zero, 2, 4, and 10 passes. Compaction was quantified in terms of 3 parameters: (1) bulk density to 25 cm depth measured gravimetrically, (2) penetration resistance using a field penetrometer, and (3) saturated hydraulic conductivity using a field rainfall simulator. Results showed no substantial difference in soil bulk density between the experimental treatments, regardless of skidder type or number passes. Penetration resistance of the traversed laneways was significantly higher than the surrounding undisturbed areas; however, there was no difference between skidder type. Rainfall simulation showed that the saturated hydraulic conductivity of all treatments was strongly reduced by trafficking, although this did not differ with skidder type. The results from this study highlight the dangers in assuming that reduced machine static ground pressures will automatically lead to reduced soil impacts. It is important to note that while this study did not find differences between the 2 skidder types when operated in a similar manner, differences in the operation of the two skidders may also influence impacts on soil properties.


2013 ◽  
Vol 37 (4) ◽  
pp. 911-919 ◽  
Author(s):  
João Carlos Medeiros ◽  
Getulio Coutinho Figueiredo ◽  
Álvaro Luiz Mafra ◽  
Jaqueline Dalla Rosa ◽  
Sung Won Yoon

Soil management practices which increase the root depth penetration of citrus are important to the longevity and yield maintenance of this plant, especially in regions where long periods of drought are common, even in soil conventionally subsoiled to a depth of 30-40 cm, when the orchard was first established. The objective of this study was to evaluate the efficiency of subsoiling on the physical and hydric properties of a Typical Hapludult and fruit yield in a 14-year-old citrus orchard located in Piracicaba, SP. The treatments consisted of: no-subsoiling (with no tilling of the soil after the orchard was planted); subsoiling on one side of the plant lines (SUB. 1); and subsoiling on both sides of the plant lines (SUB. 2). The subsoiling treatments were carried out 1.5 m from the plant lines and to a depth of 0.8 m. Soil samples were taken 120 days after this operation, at four depths, in order to determine physical and hydric properties. Fruit yield was evaluated 150 days after subsoiling. Subsoiling between the plant lines of an old established citrus orchard alters the physical and hydric properties of the soil, which is reflected in increased soil macroporosity and unsaturated hydraulic conductivity, and reduced soil bulk density, critical degree-of-compactness and penetration resistance. The improvements in the physical and hydric properties of the soil were related to an increase in fruit number and orchard yield.


2011 ◽  
Vol 91 (6) ◽  
pp. 957-964 ◽  
Author(s):  
C. Halde ◽  
A. M. Hammermeister ◽  
N. L. Mclean ◽  
K. T. Webb ◽  
R. C. Martin

Halde, C., Hammermeister, A. M., McLean, N. L., Webb, K. T. and Martin, R. C. 2011. Soil compaction under varying rest periods and levels of mechanical disturbance in a rotational grazing system. Can. J. Soil Sci. 91: 957–964. In Atlantic Canada, data are limited regarding the effect of grazing systems on soil compaction. The objective of the study was to determine the effect of intensive and extensive rotational pasture management treatments on soil bulk density, soil penetration resistance, forage productivity and litter accumulation. The study was conducted on a fine sandy loam pasture in Truro, Nova Scotia. Each of the eight paddocks was divided into three rotational pasture management treatments: intensive, semi-intensive and extensive. Mowing and clipping were more frequent in the intensive than in the semi-intensive treatment. In the extensive treatment, by virtue of grazing in alternate rotations, the rest period was doubled than that of the intensive and semi-intensive treatments. Both soil bulk density (0–5 cm) and penetration resistance (0–25.5 cm) were significantly higher in the intensive treatment than in the extensive treatment, for all seasons. Over winter, bulk density decreased significantly by 6.8 and 3.8% at 0–5 and 5–10 cm, respectively. A decrease ranging between 40.5 and 4.0% was observed for soil penetration resistance over winter, at 0–1.5 cm and 24.0–25.5 cm, respectively. The intensive and semi-intensive treatments produced significantly more available forage for grazers annually than the extensive treatment. Forage yields in late May to early June were negatively correlated with spring bulk density.


Agronomy ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 1005 ◽  
Author(s):  
Lucia Toková ◽  
Dušan Igaz ◽  
Ján Horák ◽  
Elena Aydin

Due to climate change the productive agricultural sectors have started to face various challenges, such as soil drought. Biochar is studied as a promising soil amendment. We studied the effect of a former biochar application (in 2014) and re-application (in 2018) on bulk density, porosity, saturated hydraulic conductivity, soil water content and selected soil water constants at the experimental site in Dolná Malanta (Slovakia) in 2019. Biochar was applied and re-applied at the rates of 0, 10 and 20 t ha−1. Nitrogen fertilizer was applied annually at application levels N0, N1 and N2. In 2019, these levels were represented by the doses of 0, 108 and 162 kg N ha−1, respectively. We found that biochar applied at 20 t ha−1 without fertilizer significantly reduced bulk density by 12% and increased porosity by 12%. During the dry period, a relative increase in soil water content was observed at all biochar treatments—the largest after re-application of biochar at a dose of 20 t ha−1 at all fertilization levels. The biochar application also significantly increased plant available water. We suppose that change in the soil structure following a biochar amendment was one of the main reasons of our observations.


2016 ◽  
Vol 36 (3) ◽  
pp. 449-459 ◽  
Author(s):  
Wininton M. da Silva ◽  
Aloísio Bianchini ◽  
Cesar A. da Cunha

ABSTRACT This study aimed to describe the behavior of models for adjusting data of soil penetration resistance for variations in soil moisture and soil bulk density. The study was carried out in Lucas do Rio Verde, MT, Brazil in a typic dystrophic red-yellow Latosol (Oxisol) containing 0.366 kg kg−1 of clay. Soil penetration resistance measurements were conducted in the soil moistures of 0.33 kg kg−1, 0.28 kg kg−1, 0.25 kg kg−1 and 0.22 kg kg−1. Soil penetration resistance behavior due to variations in soil moisture and soil bulk density was assessed by estimating the soil resistance values by non-linear models. There was an increase of the soil penetration resistance values as soil was losing moisture. For the same edaphic condition studied, small differences in the data of soil bulk density affect differently the response of soil resistance as a function of moisture. Both soil bulk density and soil moisture are essential attributes to explain the variations in soil penetration resistance in the field. The good representation of the critical soil bulk density curve as a limiting compression indicator requires the proper choice of the restrictive soil resistance value for each crop.


Bragantia ◽  
2014 ◽  
Vol 73 (2) ◽  
pp. 171-177 ◽  
Author(s):  
Daniel Dias Valadão Junior ◽  
Aloísio Biachini ◽  
Franciele Caroline Assis Valadão ◽  
Rodrigo Pengo Rosa

This study aimed to evaluate the effect of penetration rate and the size of the cone base on the resistance to penetration under different soil moistures and soil bulk density. The experimental design was completely randomized in a 4x2x2x2 factorial arrangement, with the factors, soil bulk density of 1.0; 1.2; 1.4 and 1.6 Mg m-3, soil moisture at the evaluation of 0.16 and 0.22 kg kg-1, penetration rates of 0.166 and 30 mm s-1 and areas of the cone base of 10.98 and 129.28 mm² resulting in 32 treatments with 8 replicates. To ensure greater uniformity and similarity to field conditions, samples passed through cycles of wetting and drying. Only the interaction of the four factors was not significant. Resistance values varied with the density of the soil, regardless of moisture and penetration rate. Soil penetration resistance was influenced by the size of the cone base, with higher values for the smallest base independent of moisture and soil bulk density. The relationship between resistance to penetration and moisture is not always linear, once it is influenced by soil bulk density. Reduction in the area of the cone leads to an increase in the soil resistance to penetration.


2013 ◽  
Vol 59 (No. 7) ◽  
pp. 295-302 ◽  
Author(s):  
B. Ji ◽  
Y. Zhao ◽  
X. Mu ◽  
K. Liu ◽  
C. Li

Subsoil compaction can result in unfavourable soil physical conditions and hinder the root growth of maize. The effects of deep tillage and conventional tillage on soil physical properties and root growth of maize were studied during 2010–2011 at two sites (loam at Hebi and clay at Luohe) in central China. The results showed that soil penetration resistance, bulk density, water content and root length density were significantly affected by tillage, soil depth and year. Deep tillage had lower penetration resistance and lower soil bulk density, but higher soil water content than conventional tillage across years and depths. Averaged over the whole soil profile, deep tillage not only significantly decreased penetration resistance and soil bulk density, but significantly increased soil water content and root length density on loam, while deep tillage only significantly increased the root length density on clay. We conclude that deep tillage on the loam is more suitable for the root growth of summer maize.


Sign in / Sign up

Export Citation Format

Share Document