Einstein-like approximation for homogenization with small concentration. II—Navier-Stoke equation

1985 ◽  
Vol 9 (11) ◽  
pp. 1255-1268 ◽  
Author(s):  
T. Lévy ◽  
E. Sanchez-Palencia
2000 ◽  
Vol 42 (3-4) ◽  
pp. 423-428
Author(s):  
W.J. Ng ◽  
S.L. Ong ◽  
N. Sarada ◽  
J.Y. Hu ◽  
X.J. Fan ◽  
...  

The factors influencing foam index were identified and their effects on foam index were investigated. It was noted that increasing the diameter of the flotation cell led to an increase in foam index. The maximum foam index was found to occur at a constant air/solids ratio when MLSS was varied with time of aeration or airflow. A good degree of correlation was also obtained between filament count and foam index. A small concentration of Surfactants was sufficient to induce foaming. However, further increase in surfactants showed relatively little influence on Foam Index.


Optik ◽  
2021 ◽  
Vol 231 ◽  
pp. 166429
Author(s):  
Agus Supriyanto ◽  
Diani Galih Saputri ◽  
Mohd Khairul Bin Ahmad ◽  
Ari Handono Ramelan ◽  
Febrina Ramadhani

1994 ◽  
Vol 278 ◽  
pp. 63-81 ◽  
Author(s):  
G. K. Batchelor ◽  
J. M. Nitsche

It is a significant feature of most gas-fluidized beds that they contain rising ‘bubbles’ of almost clear gas. The purpose of this paper is to account plausibly for this remarkable property first by supposing that primary and secondary instabilities of the fluidized bed generate compact regions of above-average or below-average particle concentration, and second by invoking a mechanism for the expulsion of particles from a buoyant compact blob of smaller particle concentration. We postulate that the rising of such an incipient bubble generates a toroidal circulation of the gas in the bubble, roughly like that in a drop of liquid rising through a second liquid of larger density, and that particles in the blob carried round by the fluid move on trajectories which ultimately cross the bubble boundary. Numerical calculations of particle trajectories for practical values of the relevant parameters show that a large percentage of particles, of such small concentration that they move independently, are expelled from a bubble in the time taken by it to rise through a distance of several bubble diameters.Similar calculations for a liquid-fluidized bed show that the expulsion mechanism is much weaker, as a consequence of the larger density and viscosity of a liquid, which is consistent with the absence of observations of relatively empty bubbles in liquid-fluidized beds.It is found to be possible, with the help of the Richardson-Zaki correlation, to adjust the results of these calculations so as to allow approximately for the effect of interaction of particles in a bubble in either a gas- or a liquid-fluidized bed. The interaction of particles at volume fractions of 20 or 30 % lengthens the expulsion times, although without changing the qualitative conclusions.


1967 ◽  
Vol 45 (1) ◽  
pp. 149-159 ◽  
Author(s):  
E. E. Daniel

The effects of furosemide, ethacrynic acid, triamterene, and an aldosterone antagonist (Su-11927) were studied on recovery of electrolyte gradients by Na-rich pieces from rabbit uteri and aortas. In sufficient concentration furosemide and ethacrynic acid appeared to inhibit Na extrusion. Only furosemide inhibited K uptake as well. A small concentration of ethacrynic acid (0.1 μg/ml) increased Na extrusion from Na-rich uterine pieces but did not increase K uptake. Thus K gain and Na extrusion were not always reciprocally related. Triamterene and Su-11927 altered recovery of electrolyte gradients, but convincing evidence for inhibition of Na active transport was not obtained. Whether inhibition of Na extrusion without inhibition of K uptake, as by ethacrynic acid, could be considered convincing evidence of inhibition of active transport was discussed.


2021 ◽  
Vol 1 (3) ◽  
Author(s):  
Ramana Murthy RVV

Previously we prepared fracturing linear gel with fossil diesel, bio-diesel and also used suspending, anti-settling agents and emulsifiers. But through this research, a novel and efficient method for the preparation of linear gel directly mixed with water, guar gum and sodium acetate together instantly. In this instead of diesel, we used water and no need to mix anti-settling agents, suspending agents, emulsifiers that resulted in 30 viscosity linear gel. Ammonium persulphate or Ammonium peroxidisulphate and enzyme-G are used for oxidation purposes to break the gel gradually at a particular static temperature. The degradation pattern observed from the breaker test showed that a reduction in gel viscosity depends on time, temperature & breaker concentration. Observations from experiments revealed that a small concentration of breakers provides rapid break compared to oxidative breakers. This article, designing of fracturing fluids describes how to use the fluid's viscosity generated by the gelling agents like guar gum for CBM operations.


Author(s):  
J. D. Denton ◽  
S. Usui

A method of using a flame ionization detector to study the movement of air containing a small concentration of ethylene is described. Ethylene is chosen because it has almost the same density as air so buoyancy effects are negligible. The technique is applied to flow in a bent duct and in a low speed air turbine. In both cases large scale migrations of the end wall boundary layers onto the suction surfaces are observed. However, in the turbine the span wise movement and mixing of the flow at mid-span is remarkably small.


2008 ◽  
Vol 45 (1) ◽  
pp. 63-70
Author(s):  
B. Martuzans ◽  
Yu. Skryl

Abnormal Influence of Ions on Shock-Induced Polarization in Binary ElectrolytesThe study is aimed at modeling the shock-induced polarization of liquid superdiluted binary (KF) electrolytes at low (<10-4mole fraction) concentration of K+and F-ions (i.e. not making direct contribution to the polarization current). It is supposed that at such a small concentration of electrolyte only the dipole polarization of water occurs, while the indirect influence of ions is expressed in its reduced conductivity in the compressed region at increasing concentration of the dissolved ions. In the authors' opinion, this influence is connected with suppression of the transition of water into high-conductivity phase by the ions of electrolyte.


2010 ◽  
Vol 18 (3) ◽  
pp. 303-311 ◽  
Author(s):  
G. Andrievsky ◽  
D. Shakhnin ◽  
A. Tronza ◽  
D. Zhernosekov ◽  
A. Tykhomyrov

1975 ◽  
Vol 152 (2) ◽  
pp. 255-265 ◽  
Author(s):  
Anthony K. Campbell ◽  
Robert L. Dormer

1. Obelin, the Ca2+-activated luminescent protein from the hydroid Obelia geniculata, was sealed inside pigeon erythrocyte ‘ghosts’ in order to investigate effects on their permeability of different methods of preparation and of the bivalent cation ionophore A23187. 2. Changes in free Ca2+ within the ‘ghosts’ were studied by following the rate of luminescence of obelin. The possibility that the obelin might have been released from the ‘ghosts’ during an experiment was investigated by studying the release of inulin and pyruvate kinase from the ‘ghosts’. Less than 10% of the inulin or pyruvate kinase sealed within the ‘ghosts’ was released under any of the experimental conditions. 3. Triton X-100 (0.1–10%, v/v) made the ‘ghosts’ highly permeable to Ca2+. In the presence of 1mm-Ca2+ and Triton, 95–100% of the obelin was utilized within 10–20s. 4. A time-course of resealing ‘ghosts’ at 37°C showed that over a period of 90min, the ‘ghosts’ became gradually less permeable to Ca2+. ‘Ghosts’ which remained at 0°C retained only a small concentration of obelin and ATP, and were highly permeable to Ca2+. 5. Erythrocyte ‘ghosts’ resealed for 30min at 20°C rather than 37°C were more permeable to Ca2+, as shown by the fact that 92% of the obelin in the ‘ghosts’ was utilized during the first 60s after the addition of 1mm-Ca2+, as opposed to 44% for ‘ghosts’ resealed at 37°C. 6. Haemolysis at pH6.0 rather than 7.0 resulted in ‘ghosts’ which were highly permeable to Ca2+ after resealing for 60min at 37°C. Of the obelin in the ‘ghosts’, produced by haemolysis at pH6.0, 90% was utilized in the first 60s after the addition of 1mm-Ca2+ compared with 23% for ‘ghosts’ produced at pH7.0. 7. The bivalent cation ionophore A23187 increased the permeability of the ‘ghosts’ to Ca2+. Maximum effects of the ionophore (16μg/ml) were obtained by preincubating the ‘ghosts’ with the ionophore A23187 (16μg/ml) in the presence of a low concentration of Mg2+ and in the absence of Ca2+.


Sign in / Sign up

Export Citation Format

Share Document