Experimental study of a vortex flowmeter in pulsatile flow conditions

1992 ◽  
Vol 3 (3) ◽  
pp. 173-186 ◽  
Author(s):  
P. Hebrard ◽  
L. Malard ◽  
A. Strzelecki
1992 ◽  
Vol 25 (8) ◽  
pp. 115-122 ◽  
Author(s):  
G. S. Perrusquía

An experimental study of the transport of sediment in a part-full pipe was carried out in a concrete pipe. The experiments were confined to bedload transport. The purpose of this study was to analyze the flow conditions that characterize the stream traction in pipe channels and their relationship to flow resistance and sediment transport rate. Three procedures used in this kind of experimental study were tested and found valid: 1) the vertical velocity distribution near the sediment bed can be described by the velocity-defect law, 2) the side wall elimination procedure can be used to compute the hydraulic radius of the sediment bed, and 3) the critical shear stress of the sediment particles can be obtained by using Shields' diagram. A relationship to estimate bedload transport, based on dimensional analysis, was proposed. This was expressed in terms of both flow and particle parameters as well as geometric factors. Further experimental work is recommended before this relationship can be fully incorporated in a simulation model for the analysis of storm sewers.


Author(s):  
S C M Yu ◽  
J B Zhao

Flow characteristics in straight tubes with an asymmetric bulge have been investigated using particle image velocimetry (PIV) over a range of Reynolds numbers from 600 to 1200 and at a Womersley number of 22. A mixture of glycerine and water (approximately 40:60 by volume) was used as the working fluid. The study was carried out because of their relevance in some aspects of physiological flows, such as arterial flow through a sidewall aneurysm. Results for both steady and pulsatile flow conditions were obtained. It was found that at a steady flow condition, a weak recirculating vortex formed inside the bulge. The recirculation became stronger at higher Reynolds numbers but weaker at larger bulge sizes. The centre of the vortex was located close to the distal neck. At pulsatile flow conditions, the vortex appeared and disappeared at different phases of the cycle, and the sequence was only punctuated by strong forward flow behaviour (near the peak flow condition). In particular, strong flow interactions between the parent tube and the bulge were observed during the deceleration phase. Stents and springs were used to dampen the flow movement inside the bulge. It was found that the recirculation vortex could be eliminated completely in steady flow conditions using both devices. However, under pulsatile flow conditions, flow velocities inside the bulge could not be suppressed completely by both devices, but could be reduced by more than 80 per cent.


Author(s):  
M. Yu. Khanova ◽  
E. A. Velikanova ◽  
V. G. Matveeva ◽  
E. O. Krivkina ◽  
T. V. Glushkova ◽  
...  

Objective: to create a cell-populated small-diameter vascular graft (SDVG) using autologous endothelial cells and extracellular matrix proteins, and to evaluate the efficiency of endothelial cell monolayer formation during shear stress preconditioning in a SDVG.Materials and methods. PHBV/PCL tubular scaffolds of vascular grafts were made by electrospinning from a mixture of polyhydroxybutyrate-valerate (PHBV) copolymer and polycaprolactone (PCL) and modified with fibrin. To populate the graft, an endothelial cell culture was isolated from the blood of patients with coronary heart disease. Phenotyping of endothelial colony-forming cell (ECFC) culture was performed by flow cytometry and immunofluorescence microscopy. Cell proliferative and angiogenic activity were also studied. Cell-populated vascular scaffolds were cultured in a pulsatile flow setup with a final shear stress of 2.85 dyne/cm2. The effect of pulsatile flow on monolayer formation was assessed by immunofluorescence, scanning electron microscopy, atomic force microscopy, and whole-transcriptome RNA sequencing.Results. Under the influence of pulsatile flow, endothelial cells that were seeded into the tubular scaffold showed an increase in the expression level of endothelial profile proteins, focal adhesion and cytoskeleton. In contrast to endothelial cell culture on a vascular graft surface under static conditions, when cultured under pulsatile flow with 2.85 dyne/ cm2 shear stress, endothelial lining cells have an increased ability to adhere and are oriented along the pulsatile flow path. Whole-transcriptome RNA sequencing showed that induced shear stress increased expression levels of differentially expressed genes encoding proteins that ensure vascular development, endothelial integrity, and endothelial metabolism. A protocol for fabrication of a personalized cell-populated biodegradable SDVG under pulsatile flow conditions was developed.Conclusion. The use of autologous fibrin and ECFC culture, as well as shear stress preconditioning, allow to obtain a personalized cell-populated SDVG with continuous functional endothelial monolayer adapted to the flow.


2021 ◽  
Author(s):  
Marco Testaguzza ◽  
Mehdi Benhassine ◽  
Haroun Frid ◽  
Laurence Gebhart ◽  
Karim Zouaoui Boudjeltia ◽  
...  

Abstract Ischemic Stroke is the most frequent type of stroke and is subject to many studies investigating prevention means. Avoiding the difficulties and ethical problems of experimental in-vivo research, in-vitro testing is a convenient way of studying in controlled conditions the morphological impact and mechanical aspects of emboli dynamics. This in-vitro study was performed with two realistic silicone aortic-arch phantoms submitted to physiological pulsatile flow conditions. In the in-vitro test bed, using automatic image tracking and analysis, it was made possible detecting and tracking artificial spherical emboli candidates circulating in the anatomic aortic-arch models under a realistic based-patient blood flow profile. The emboli trajectories as well as their repartition in the different supra-aortic branches are presented for the two aortic-arch geometries obtained from CT scans. Through a statistical analysis performed with several artificial emboli sizes, the experimental study shows that the repartition percentages of the emboli closely follow the flowrate repartition percentages for both aortic-arch models, suggesting that higher flowrates lead to higher concentrations of emboli in a given artery. Sets of human thrombi were also injected and the repartition percentages have been established, giving the same trend as for artificial emboli.


Mechanik ◽  
2020 ◽  
Vol 93 (7) ◽  
pp. 13-15
Author(s):  
Maciej Szudarek ◽  
Mateusz Turkowski

Oscillatory flowmeters are susceptible to pulsatile flow and mechanical oscillator flowmeters are no exception. The experimental study was conducted to determine possible measurement errors for specific pulsation amplitude thresholds. The study verified that no frequency lock-in takes place for pulsation frequencies which are subharmonics of the natural oscillation frequency, nor for harmonics higher than the 2nd.


1979 ◽  
Vol 12 (8) ◽  
pp. 626 ◽  
Author(s):  
K.B. Chandran ◽  
T.L. Yearwood

Sign in / Sign up

Export Citation Format

Share Document