Automatic variogram model fitting of a variogram map based on the Fourier integral method

2021 ◽  
pp. 104891
Author(s):  
Paulo Roberto Moura de Carvalho ◽  
João Felipe Coimbra Leite da Costa
1965 ◽  
Vol 32 (3) ◽  
pp. 637-642 ◽  
Author(s):  
C. C. Mow

The transient response of a rigid spherical inclusion of arbitrary density embedded in an elastic medium owing to an incident pulse is examined in this paper. The Fourier-integral method is used, and an exact solution of the response is obtained. It is found that the acceleration and velocity of the inclusion are substantially different from those of the medium. A slight difference in the time history of the displacement between the inclusion and the medium is also noted.


2021 ◽  
Vol 55 (2) ◽  
pp. 293-304
Author(s):  
Jing Zhang ◽  
Yi-min Wu ◽  
Xu Ma ◽  
Bao-Yu Huang ◽  
Song Lv ◽  
...  

The isothermal curing kinetics of polymethacrylimide/nano-SiO2 composites were investigated using a dynamic thermomechanical analysis. The relative conversion was defined with the storage modulus. The Avrami model-fitting method, Friedman method and integral method were applied to analyze the curing kinetics. The storage modulus and loss modulus increased appreciably, spanning three orders of magnitude throughout the curing. The frequency correlation of the relative conversion was noticeable at 180 °C because the glass transition took place when the curing degree was not high enough. The Avrami model-fitting analysis gave good fits for the experimental data. The activation energy calculated with the Avrami equation changed from 65.46 kJ/mol to 25.28 kJ/mol at 180–190 °C, while at 190–200 °C, the activation energy changed from 107.14 kJ/mol to 63.82 kJ/mol. The model-free analysis revealed the dependence of the activation energy on the relative conversion. The activation energy increased from 104.3 kJ/mol to 130.6 kJ/mol with the use of the Friedman method when the relative conversion ranged between 0.4–0.8. Similarly, the activation energy calculated with the integral method increased from 71.5 kJ/mol to 103.4 kJ/mol. When the relative conversion exceeded 0.8, the activation energy decreased gradually. The mobility of the reactive groups was hindered and the crosslinking density of the composite was much higher. The curing kinetics became diffusion controlled. The activation energy of the PMI/SiO2 composite was greater than that of PMI, which could be attributed to the hindrance effect caused by nano-SiO2.


1954 ◽  
Vol 21 (2) ◽  
pp. 151-159
Author(s):  
Ning-Gau Wu ◽  
C. W. Nelson

Abstract The Fourier integral method is applied to plane-stress problems of a curved bar bounded by two concentric circles and loaded by concentrated tangential boundary loads. The solutions presented may be combined with results given in previous papers (1, 2) dealing with radial boundary loads so as to obtain the stresses in a curved bar loaded by any combination of concentrated boundary loads inclined at any angle to the radial direction.


The only problem relating to two electrified circular discs, placed parallel to each other, for which an exact solution has been obtained hitherto, is the classical one of Nobili’s rings. This was solved by Riemann,* by an application of the Bessel-Fourier integral method. In this problem the discs are circular electrodes fixed to two infinite conducting planes, which are themselves connected together by the earth or by a wire at infinity. If the axis of z is that of the two co-axial discs, and perpendicular to the infinite plane conducting sheets, the electrical potential V satisfies Laplace’s equation at all points between the plates, and the further conditions (1) ∂V/∂ z = 0, z = ± a , p > p 1 (2) ∂v/∂ z = A/√(r 1 2 —r 2 ), z = ± a , p < p 1 where A is a constant, 2 a is the distance between the plates, bisected by the origin, p 1 is the radius of either disc, and p is the distance of any point from the axis of z . In fact ( z , p ) are the two cylindrical polar co-ordinates on which V can alone depend.


1953 ◽  
Vol 20 (1) ◽  
pp. 82-86
Author(s):  
H. D. Conway

Abstract Using a Fourier integral method, the solution is obtained to an isotropic half plane subjected to a concentrated load acting at some distance from the straight edge. This problem was discussed previously by Melan, using a complex variable method of solution. The Fourier integral method is then extended to solve the corresponding problems of the orthotropic half plane.


Sign in / Sign up

Export Citation Format

Share Document