Reaction kinetic and thermodynamics studies for in-situ transesterification of wet microalgae paste to biodiesel

Author(s):  
Thanh Tien Nguyen ◽  
Man Kee Lam ◽  
Yoke Wang Cheng ◽  
Yoshimitsu Uemura ◽  
Nurlidia Mansor ◽  
...  
Fuel ◽  
2020 ◽  
Vol 272 ◽  
pp. 117718 ◽  
Author(s):  
Thanh Tien Nguyen ◽  
Man Kee Lam ◽  
Yoshimitsu Uemura ◽  
Nurlidia Mansor ◽  
Jun Wei Lim ◽  
...  

2016 ◽  
Vol 10 (2) ◽  
pp. 119-126
Author(s):  
Mahlinda Mahlinda ◽  
Fitriana Djafar

The main purpose of this research was to observer effect co-solvent type (n-Hexane, chloroform and without co-solvent)  toward yield and quality of biodiesel via in situ transesterification process using microwave irradiation. The process was studied at microwave power 450 watt, reaction time 4 minutes, methanol to seed ratio 25:1 and catalyst concentration 5%. The physicochemical parameters of the biodiesel produced such as viscosity, density and acid value were analysed and compared with the SNI 7182-2012 standard. The experimental result showed the maximum yield biodiesel 78,32% obtained by using co-solvent chloroform.Test result of physicochemical properties (viscosity, density and acid value) of biodiesel products using co solvent n-Hexane, chloroform and without co solvent showed that these products conform to the SNI 7182-2012 standars. The type of co-solvent only affectedon biodiesel yield dan not affected on biodiesel quality (viscosity, density and acid value).  ABSTRAKTujuan penelitian ini adalah untuk mempelajari pengaruh jenis co-solvent (n-Hexane, chloroform dan tanpa co-solvent) terhadap rendemen dan mutu biodiesel secara trasesterifikasi in situ menggunakan radiasi gelombang mikro. Proses dilakukan pada daya gelombang mikro 450 watt, waktu reaksi 4 menit, perbandingan berat metanol terhadap bahan baku 25:1 dan jumlah katalis 5%. Parameter fisiko kimia dari produk biodiesel seperti viskositas, densitas dan angka asam di analisa dan dibandingkan dengan standar SNI 7182-2012 tentang biodiesel. Hasil penelitian menunjukkan rendemen maksimum biodiesel sebesar 78,32% diperoleh dengan menggunakan co-solvent chloroform. Hasil pengujian  karakteristik fisiko kimia (viskositas, densitas dan angka asam) dari produk biodiesel menggunakan co-solvent n-Hexane, chloroform dan tanpa co-solvent menunjukkan bahwa semua parameter ini masih memenuhi standar SNI 1782-2012 tentang biodiesel. Jenis co-solvent hanya berpengaruh pada rendemen biodiesel dan tidak berpengaruh terhadap mutu biodiesel (viskositas, densitas dan bilangan asam).Kata kunci: co-solvent, in situ transesterifikasi, microwave, rendemen, mutu   


RSC Advances ◽  
2016 ◽  
Vol 6 (61) ◽  
pp. 56009-56017 ◽  
Author(s):  
Magdouli Sara ◽  
Satinder Kaur Brar ◽  
Jean François Blais

Recent trends have focused on the development of a rapid method to convert microbial lipids to biodiesel.


2014 ◽  
Vol 625 ◽  
pp. 267-270 ◽  
Author(s):  
Sintayehu Mekuria Hailegiorgis ◽  
Mahadzir Shuhaimi ◽  
Duvvuri Subbarao

In the present work, microwave heat pretreatment of jatropha curcas seed particles and use of phase transfer catalyst (PTC) to enhance in-situ transesterification were utilized together. It was observed that use of alkaline BTMAOH as a PTC and microwave heat pretreatment of jatropha curcas seed particles had substantially increased the reaction rate of in-situ transesterification as compared to the reaction conducted with microwave untreated seeds in the absence of BTMAOH as a PTC. Statistical model equation was developed to investigate the interaction effect of reaction variables and establish optimum reaction condition. At optimum condition, experimentally obtained FAME yield (93.7±1.53% w/w) was in close agreement with statistical model predicted FAME yield (96.75%) at 38°C and 37 minutes of reaction time.


2016 ◽  
Vol 49 ◽  
pp. 212-220 ◽  
Author(s):  
Juanjuan Qi ◽  
Fenfen Zhu ◽  
Xiang Wei ◽  
Luyao Zhao ◽  
Yiqun Xiong ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document