Electrochemical corrosion evaluation of pure, carbon-coated and anodized Al foams

In the present work, samples of a binary intermetallic alloy (Fe3Al) with 26at.%Al were submitted to electrochemical corrosion evaluation in a 0.5M H2SO4 solution containing naturally dissolved oxygen. The corrosion resistance was evaluated by applying linear polarization, electrochemical impedance spectroscopy and potentiodynamic polarization at 22 and 35°C. The results obtained revealed that in both conditions the material exhibits active-passive behavior. Heating to 35°C did not alter the passivity characteristics of the alloy (passivation range and passive current density), but elevated the corrosion current density and the critical current density. The polarization resistance of the samples was also decreased with temperature, following the trend observed for the corrosion current density.

Download Full-text

Corrosion Evaluation of Pure Mg Coated by Fluorination in 0.1 M Fluoride Electrolyte

Scanning ◽

10.1155/2021/5574946 ◽

2021 ◽

Vol 2021 ◽

pp. 1-11

Author(s):

Chun Yu Dai ◽

Xinzhe Gao ◽

ChuanYao Zhai ◽

Qi Jia ◽

Bing Cheng Zhao ◽

...

Keyword(s):

Corrosion Resistance ◽

Low Voltage ◽

Electrochemical Corrosion ◽

Ongoing Research ◽

Voltage Range ◽

Surface Corrosion ◽

Corrosion Evaluation ◽

Immersion Corrosion ◽

Degradation Rates ◽

Coating Characteristics

In the ongoing research on the application of biodegradable materials, surface treatment of is considered to be a relatively effective solution to the excessive degradation rates of Mg alloys. In this study, to further optimize the proven effective surface coatings of fluoride, a low-voltage preparation fluorination method was used to achieve coating effectiveness under safer conditions. Optical observation, scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive spectroscopy (EDS), and potential dynamic polarization (PDP) experiments were used for the analysis and evaluation. The coating characteristics of the MgF2 coatings treated in the 10–90 V voltage range, including the structure, chemical conformation, and electrochemical corrosion assessment, were fully defined. The anodic fluoridation results showed that a pore structure of 1–14 μm thickness was formed on the Mg alloy substrate, and the coating was composed of Mg fluoride. The results of immersion corrosion and electrochemical corrosion experiments showed that compared with pure Mg, anodic fluorinated samples below 40 V exhibited better corrosion resistance, the prepared MgF2 coating was more uniform, and the surface mostly exhibited point corrosion. When the voltage reached or exceeded 60 V, the prepared coating exhibited poor corrosion resistance, fracture, and protrusions. After corrosion, it mostly exhibited surface corrosion. The results indicate that idealized coatings can be obtained at relatively low and safe voltage ranges. This finding may enable more economical, environmentally friendly, and safe preparation of coatings.

Download Full-text

High-temperature electrochemical corrosion evaluation of 2.25Cr–1Mo alloy in eutectic LiCl–KCl molten salt

Corrosion Engineering Science and Technology ◽

10.1080/1478422x.2021.1987376 ◽

2021 ◽

pp. 1-8

Author(s):

Ch. Jagadeeswara Rao ◽

S. Ningshen

Keyword(s):

High Temperature ◽

Molten Salt ◽

Electrochemical Corrosion ◽

Corrosion Evaluation

Download Full-text

Biophysical Measurement of Molecular Weight of Foot-and-Mouth Disease RNA Fragments

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100051323 ◽

1974 ◽

Vol 32 ◽

pp. 262-263

Author(s):

Sydney S. Breese ◽

Howard L. Bachrach

Keyword(s):

Chemical Properties ◽

Foot And Mouth Disease ◽

Mouth Disease ◽

Distilled Water ◽

Bovine Plasma ◽

Mouth Disease Virus ◽

Foot And Mouth ◽

Carbon Coated ◽

Rna Fragments ◽

Physical And Chemical

Continuing studies on the physical and chemical properties of foot-and-mouth disease virus (FMDV) have included electron microscopy of RNA strands released when highly purified virus (1) was dialyzed against demlneralized distilled water. The RNA strands were dried on formvar-carbon coated electron microscope screens pretreated with 0.1% bovine plasma albumin in distilled water. At this low salt concentration the RNA strands were extended and were stained with 1% phosphotungstic acid. Random dispersions of strands were recorded on electron micrographs, enlarged to 30,000 or 40,000 X and the lengths measured with a map-measuring wheel. Figure 1 is a typical micrograph and Fig. 2 shows the distributions of strand lengths for the three major types of FMDV (A119 of 6/9/72; C3-Rezende of 1/5/73; and O1-Brugge of 8/24/73.

Download Full-text

The Application of Ultracryotomy to Immunocytochemistry

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100073969 ◽

1973 ◽

Vol 31 ◽

pp. 704-709

Author(s):

R. G. Painter ◽

K. T. Tokuyasu ◽

S. J. Singer

Keyword(s):

Frozen Sections ◽

Protein Antigens ◽

Carbon Coated ◽

Antibody Conjugates ◽

Ultrathin Frozen Sections

A technique for localizing intracellular antigens with immunoferritin conjugates directly on ultrathin frozen sections of glutaraldehyde-fixed tissues has been developed. This method overcomes some of the limitations of previously described procedures, since it avoids drastic fixation, dehydration and embedding procedures which could denature many protein antigens.Briefly cells or tissues were fixed with glutaraldehyde (0.5 to 2% for 1 hr), and ultrathin frozen sections were cut and mounted on grids covered with carbon-coated Formvar film by the procedure described previously. Such sections were stained with ferritin-antibody conjugates by methods described elsewhere.

Download Full-text

Ultrastructural Alterations in Hela Cells Induced by Spider Venom

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100060118 ◽

1967 ◽

Vol 25 ◽

pp. 20-21

Author(s):

Dale E. McClendon ◽

Paul N. Morgan ◽

Bernard L. Soloff

Keyword(s):

Growth Medium ◽

Mammalian Cells ◽

Carcinoma Cells ◽

Venom Protein ◽

Sterile Saline ◽

Carbon Coated ◽

Available Information ◽

Loxosceles Reclusa ◽

Essential Growth ◽

Solution Cultures

It has been observed that minute amounts of venom from the brown recluse spider, Loxosceles reclusa, are capable of producing cytotoxic changes in cultures of certain mammalian cells (Morgan and Felton, 1965). Since there is little available information concerning the effect of venoms on susceptible cells, we have attempted to characterize, at the electron microscope level, the cytotoxic changes produced by the venom of this spider.Cultures of human epithelial carcinoma cells, strain HeLa, were initiated on sterile, carbon coated coverslips contained in Leighton tubes. Each culture was seeded with approximately 1x105 cells contained in 1.5 ml of a modified Eagle's minimum essential growth medium prepared in Hank's balanced salt solution. Cultures were incubated at 36° C. for three days prior to the addition of venom. The venom was collected from female brown recluse spiders and diluted in sterile saline. Protein determinations on the venom-were made according to the spectrophotometric method of Waddell (1956). Approximately 10 μg venom protein per ml of fresh medium was added to each culture after discarding the old growth medium. Control cultures were treated similarly, except that no venom was added. All cultures were reincubated at 36° C.

Download Full-text