Failure analysis method of concrete arch dam based on elastic strain energy criterion

2016 ◽  
Vol 60 ◽  
pp. 363-373 ◽  
Author(s):  
Bo Chen ◽  
Chongshi Gu ◽  
Tengfei Bao ◽  
Bangbin Wu ◽  
Huaizhi Su
Keyword(s):  
Failure Analysis ◽  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
Energy Criterion ◽  
Arch Dam ◽  
Analysis Method ◽  
Concrete Arch Dam

scholarly journals Energy Analysis and Verification of a Constant Pressure Elastic Strain Energy Accumulator Based on Exergy Method   

2021 ◽  
Author(s):  
Hongwang Du ◽  
Dongdong Yang ◽  
Wei Xiong
Keyword(s):  
Energy Storage ◽  
Elastic Strain ◽  
Strain Energy ◽  
Exergy Analysis ◽  
Constant Pressure ◽  
Elastic Strain Energy ◽  
Energy Output ◽  
Analysis Method ◽  
Storage Efficiency ◽  
Energy Storage Efficiency

Abstract Aiming at problems of low energy storage efficiency and unstable energy output of existing accumulators, this paper proposes a novel constant pressure elastic strain energy accumulator based on the rubber material hyperelastic effect, which can store and release energy with steady constant pressure. Based on exergy analysis method, constant pressure elastic strain energy accumulator charging/discharging energy storage efficiency is analyzed. Then Mullins effect on the rubber airbag multiple charging/discharging cycles is studied. Finally, a test platform is set up to verify the energy storage efficiency, expansion and contraction pressure stability of the rubber accumulator during charging/discharging cycles. Compared with enthalpy analysis method, experiment results show that energy storage efficiency calculation by the exergy analysis method is more accurate. In more than 200 cycle tests, rubber airbag energy storage efficiency is always higher than 76%, and expansion pressure and contraction pressure errors under steady state are less than 2.92e-3MPa and 1.79e-3MPa, respectively. The results show that the rubber airbag can be used as an effective energy storage component, which is very meaningful for energy recovery in pneumatic or hydraulic systems.

The elastic-strain energy criterion of phase formation for complex concentrated alloys

Materialia ◽  
2019 ◽  
Vol 5 ◽  
pp. 100222 ◽  
Author(s):  
Angelo F. Andreoli ◽  
Jiri Orava ◽  
Peter K. Liaw ◽  
Hans Weber ◽  
Marcelo F. de Oliveira ◽  
...  
Keyword(s):  
Phase Formation ◽  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
Energy Criterion

scholarly journals Experimental Investigation on Deformation and Strength Behavior of Marble with the Complex Loading-Unloading Stress Path

2020 ◽  
Vol 2020 ◽  
pp. 1-17
Author(s):  
Chen Chen ◽  
Lipeng Liu ◽  
Yu Cong
Keyword(s):  
Elastic Strain ◽  
Strain Energy ◽  
High Stress ◽  
Elastic Strain Energy ◽  
Complex Loading ◽  
Energy Criterion ◽  
Confining Pressure ◽  
Stress Path ◽  
Surrounding Rock ◽  
Strength Behavior

The excavation of deep tunnel in rock mass undergoes complex loading and unloading stress paths, resulting in rib spalling, flaking, and even severe rockburst disasters. Based on the variation law of the stress path of the surrounding rock, laboratory tests of rock mechanics are designed, and the deformation and strength behavior of marble with different initial confining pressure and unloading rates are systematically studied. By introducing strain increment, the characteristic stress, and the dilatancy index, the rock’s dilatancy and brittleness under different unloading conditions are quantitatively analyzed. During unloading, the energy transformation mechanism of rock is described, and the law of deformation and failure is discussed based on characteristic energy. The rock failure strength fitting formula is given by applying the Mogi–Coulomb criterion and elastic strain energy criterion. The advantages of the elastic strain energy criterion are theoretically explained. This study shows that comprehensive consideration of the complex stress paths, confining pressure levels, and the loading-unloading rates of surrounding rock is an effective way to accurately study unloading rock characteristics. The results can provide theoretical basis for stability analysis of high-stress underground engineering.

Do muscles function as adaptable locomotor springs?

2002 ◽  
Vol 205 (15) ◽  
pp. 2211-2216 ◽  
Author(s):  
Stan L. Lindstedt ◽  
Trude E. Reich ◽  
Paul Keim ◽  
Paul C. LaStayo
Keyword(s):  
Skeletal Muscle ◽  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
Normal Animal ◽  
Eccentric Contractions ◽  
Normal Muscle ◽  
Energetic Costs ◽  
Locomotor Muscles ◽  
Power Outputs

SUMMARYDuring normal animal movements, the forces produced by the locomotor muscles may be greater than, equal to or less than the forces acting on those muscles, the consequences of which significantly affect both the maximum force produced and the energy consumed by the muscles. Lengthening (eccentric)contractions result in the greatest muscle forces at the lowest relative energetic costs. Eccentric contractions play a key role in storing elastic strain energy which, when recovered in subsequent contractions, has been shown to result in enhanced force, work or power outputs. We present data that support the concept that this ability of muscle to store and recover elastic strain energy is an adaptable property of skeletal muscle. Further, we speculate that a crucial element in that muscle spring may be the protein titin. It too seems to adapt to muscle use, and its stiffness seems to be`tuned' to the frequency of normal muscle use.

The Elastostatic Axisymmetric Problem of a Cracked Sphere Embedded in a Dissimilar Matrix

1980 ◽  
Vol 47 (3) ◽  
pp. 545-550 ◽  
Author(s):  
R. Kant ◽  
D. B. Bogy
Keyword(s):  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
Companion Paper ◽  
Infinite Medium ◽  
Applied Mechanics ◽  
Axisymmetric Solution ◽  
Material Parameters ◽  
The Difference ◽  
Elastostatic Problem

The axisymmetric elastostatic problem of a cracked sphere embedded in a dissimilar matrix is solved by using the solution for a spherical cavity in an infinite medium together with the axisymmetric solution for a cracked sphere given in the companion paper in this issue of the Journal of Applied Mechanics, Pages 538-544. Numerical results are presented for (a) interface stress for various composites (b) dependence of the stress-intensity factor on the material parameters and ratios of crack to sphere radii, (c) the difference in the elastic strain energy for a cracked and uncracked composite.

scholarly journals Effect of Joint Density on Rockburst Proneness of the Elastic-Brittle-Plastic Rock Mass

2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Jiliang Pan ◽  
Fenhua Ren ◽  
Meifeng Cai
Keyword(s):  
Rock Mass ◽  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
Jointed Rock ◽  
Jointed Rock Mass ◽  
Joint Density ◽  
Dissipated Energy ◽  
Uniaxial Compression Test ◽  
Plastic Rock

The prediction of rockburst proneness is the basis of preventing and controlling rockburst disasters in rock engineering. Based on energy theory and damage mechanics, the quantitative functional relationship between joint density and energy density was derived. Then, the theoretical results were verified by numerical simulation and uniaxial compression test, and the effect of joint density on rockburst proneness of the elastic-brittle-plastic rock mass was discussed. The results show that the relationship between the joint density and the dissipated energy index of the jointed rock mass is a logarithmic function. With the same total input energy, the higher the joint density, the more the damage dissipation energy. Even in the case of high joint density, the rock mass still has limited resistance to external failure. Under the same joint density, the strength of parallel jointed rock mass is better than that of the cross-jointed rock mass, and the parallel jointed rock mass can accumulate more elastic strain energy and has higher rockburst proneness. The joint density is closely related to the ability of the rock mass to store high strain energy. The higher the joint density is, the weaker the ability to accumulate the elastic strain energy of rock mass is and the lower the rockburst proneness is. It is helpful to predict rockburst proneness by investigating and studying the properties of geological discontinuities. The research results have some theoretical and engineering guiding significance for the prediction of rockburst proneness of the jointed rock mass.

scholarly journals Dynamic Stability Critical State of Pin-Ended Arches under Sudden Central Concentrated Load

Mechanika ◽  
2020 ◽  
Vol 26 (5) ◽  
Author(s):  
Kai QIN ◽  
Jingyuan LI ◽  
Mengsha LIU ◽  
Jinsan JU
Keyword(s):  
Finite Element ◽  
Critical Load ◽  
Critical State ◽  
Elastic Strain ◽  
Strain Energy ◽  
Elastic Strain Energy ◽  
The State ◽  
Energy Principle ◽  
Concentrated Load ◽  
Elastic Plastic

The dynamic in-plane instability process of extreme point type for pin-ended arches when a central radial load applied suddenly with infinite duration is analyzed with finite element method in this study. The state of arch can be determined by the crown’s vertical displacement varied with time and the critical load can be obtained by repeating trial-calculation. When the arch structure reaches the dynamically stable critical state, the kinetic energy of the structure is very small or even zero. The dynamic critical load of elastic arch calculated with the theoretical analysis method which is based on energy principle is proved accuracy enough by comparing with the finite element calculation results and the percentage of the differences between them are no more than 4.5 %. The maximal elastic strain energy is certain for the elastic-plastic arch in certain geometry under both a sudden load and static load. The maximal elastic strain energy in static calculation can be used in determining the state of the elastic-plastic arch under dynamic sudden loads applied and this method is more accurate which errors won’t exceed 3.5 %. The accuracy of dynamic critical load calculation method for elastic arch is verified by numerical calculation in this study, and based on the characteristic of elastic strain energy in critical state, a method for determining the stability of elastic-plastic arch is presented.

scholarly journals Ut vis sic tensio

2018 ◽  
Vol 45 (1) ◽  
pp. 1-15 ◽  
Author(s):  
Giuseppe Saccomandi
Keyword(s):  
Experimental Data ◽  
Mechanical Properties ◽  
Elastic Strain ◽  
Strain Energy ◽  
Nonlinear Response ◽  
Solid Mechanics ◽  
Functional Form ◽  
Elastic Strain Energy ◽  
Strongly Nonlinear ◽  
Long Time

The mechanical properties of rubber-like materials have been offering an outstanding challenge to the solid mechanics community for a long time. The behaviour of such materials is quite difficult to predict because rubber self-organizes into mesoscopic physical structures that play a prominent role in determining their complex, history-dependent and strongly nonlinear response. In this framework one of the main problems is to find a functional form of the elastic strain-energy that best describes the experimental data in a mathematical feasible way. The aim of this paper is to give a survey of recent advances aimed at solving such a problem.

Sign in / Sign up

Export Citation Format

Share Document