This work presents a numerical study that was done to investigate the heat transfer characteristics of a transonic turbine blade with a scalloped shroud operating at realistic engine conditions typical of those found in a large scale, land-based gas turbine. The geometry under investigation was an infinite, linear cascade composed of the same blade and shroud design used in an experimental test rig by the research sponsor. This simulation was run for varying nominal tip clearances of 20, 80, and 5.08 mm. For each of these clearances, the simulation was run with and without the scrubbing effects of the outer casing, resulting in a total of six cases that could be used to determine the influence of tip clearance and relative casing motion on heat transfer. A high quality grid (ranging from approximately 10–12 million finite volumes depending on tip clearance) with y+ for first layer cells at or below 1.0 everywhere was used to resolve the flow down to the viscous sublayer. The “realizable” k-ε turbulence model was used for all cases. A constant wall heat flux was imposed on all the surrounding surfaces to obtain heat transfer data. Results produced include a full map of heat transfer coefficients for the suction and pressure surfaces of the blade as well as the tip, shroud, and outer casing for every case. Physical mechanisms responsible for the final heat transfer outcome for all six cases are documented.
