Surface-initiated ATRP to modify ZnO nanoparticles with poly(N-isopropylacrylamide): Temperature-controlled switching of photocatalysis

2017 ◽  
Vol 691 ◽  
pp. 185-194 ◽  
Author(s):  
Qian Feng ◽  
Dongyan Tang ◽  
Haitao Lv ◽  
Weile Zhang ◽  
Wenbo Li
2007 ◽  
Vol 360 (3) ◽  
pp. 876-884 ◽  
Author(s):  
Jianhua Wang ◽  
Elaine A. Medlycott ◽  
Garry S. Hanan ◽  
Frédérique Loiseau ◽  
Sebastiano Campagna

2018 ◽  
Vol 30 (1) ◽  
pp. 015702
Author(s):  
Shu-Li Wang ◽  
Kai-Kai Liu ◽  
Chong-Xin Shan ◽  
En-Shan Liu ◽  
De-Zhen Shen

1992 ◽  
Vol 2 (5) ◽  
pp. 503-510 ◽  
Author(s):  
F. Carmona ◽  
E. Valot ◽  
L. Servant ◽  
M. Ricci

MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3153-3161
Author(s):  
Marco Antonio Juárez Sánchez ◽  
Miguel Ángel Meléndez Lira ◽  
Celestino Odín Rodríguez Nava

AbstractDrug contamination in water is one of the current fields of study. Since 1990, the presence of drugs in drinking water has been a concern to scientists and public. In Mexico, these organic compounds are not efficiently removed in wastewater treatment plants; therefore, alternative methodologies have been studied that allow these compounds to have a high percentage of degradation or be completely degraded. One example of these techniques is heterogeneous photocatalysis which has obtained positive results in the degradation of drugs using ZnO nanoparticles. These are commonly selected for their electrical characteristics, even though they disperse in water and an additional unit operation is required to separate them from the liquid medium. To eliminate drugs with nano particles in a single stage, polycaprolactone-based membranes with adhered ZnO nanoparticles, by means of electrospinning, were prepared to degrade drugs such as diclofenac. The technique used has shown to efficiently break down diclofenac in 4 hours according to the capillary electrophoresis readings.


Author(s):  
Erick Kim ◽  
Kamjou Mansour ◽  
Gil Garteiz ◽  
Javeck Verdugo ◽  
Ryan Ross ◽  
...  

Abstract This paper presents the failure analysis on a 1.5m flex harness for a space flight instrument that exhibited two failure modes: global isolation resistances between all adjacent traces measured tens of milliohm and lower resistance on the order of 1 kiloohm was observed on several pins. It shows a novel method using a temperature controlled air stream while monitoring isolation resistance to identify a general area of interest of a low isolation resistance failure. The paper explains how isolation resistance measurements were taken and details the steps taken in both destructive and non-destructive analyses. In theory, infrared hotspot could have been completed along the length of the flex harness to locate the failure site. However, with a field of view of approximately 5 x 5 cm, this technique would have been time prohibitive.


Sign in / Sign up

Export Citation Format

Share Document