Preparation of Ni-SiC composite coatings by magnetic field-enhanced jet electrodeposition

2018 ◽  
Vol 762 ◽  
pp. 115-124 ◽  
Author(s):  
Wei Jiang ◽  
Lida Shen ◽  
Mingbo Qiu ◽  
Xin Wang ◽  
Mingzhi Fan ◽  
...  
RSC Advances ◽  
2020 ◽  
Vol 10 (56) ◽  
pp. 34167-34176
Author(s):  
Xiuqing Fu ◽  
Feixiang Wang ◽  
Xinxin Chen ◽  
Jinran Lin ◽  
Hongbing Cao

We investigated the effect of magnetic field on Ni–P and Ni–P/SiC composite coatings prepared by jet electrodeposition.


Author(s):  
Wei Jiang ◽  
Lida Shen ◽  
Kai Wang ◽  
Zhanwen Wang ◽  
Zongjun Tian

The Ni-Co/SiC composite coatings were prepared via jet electrodeposition in the presence of magnetic field. The microstructure and texture orientation of the composite coatings were analyzed via field emission scanning electron microscopy, three-dimensional profiling, and X-ray diffraction. The microhardness and wear resistance were characterized by a microhardness tester and a friction–abrasion testing machine. The results indicated that nano-SiC particles improved the surface morphology of the Ni-Co/SiC composite coating. In jet electrodeposition, globular structure aggregation began to form protrusions in the Ni-Co/SiC composite coating due to nanoparticle agglomeration when 6 g/L of nano-SiC was added. The Ni-Co/SiC (6 g/L) composite coating became uniform and densification by jet electrodeposition in magnetic field, with higher microhardness and better wear resistance. The microhardness of the Ni-Co/SiC composite coating increased to 626 ± 14 HV, and the corresponding friction coefficient was as low as 0.317.


2020 ◽  
Vol 34 (27) ◽  
pp. 2050243
Author(s):  
Hui Fan ◽  
Jie Jiang ◽  
Yangpei Zhao ◽  
Shankui Wang ◽  
Zhijing Li

Ni–Al2O3 composite coatings were prepared with a modified Watt’s bath by using jet electrodeposition method. As the key process parameter, current density and the addition of Al2O3 nanoparticles in electrolyte were studied about the effect on the surface morphology and co-deposition of Al2O3 nanoparticles of composite coating. The mechanical and tribological properties of the composite coating were also tested. The results show that properly increasing the current density and Al2O3 addition can increase the co-deposition of nanoparticles in the coating and promote the formation of a dense and refined coating structure. Using the optimized process parameters of current density (300 A/dm2) and Al2O3 addition (30 g/L), the co-deposition of Al2O3 in the composite coating can reach a maximum of 13.1 at.%. The hardness of the coating reaches the peak at 623 HV. The wear rate of the composite coating is also greatly reduced with optimized parameters.


2014 ◽  
Vol 309 ◽  
pp. 278-284 ◽  
Author(s):  
Yunbo Zhong ◽  
Pengwei Zhou ◽  
Junfeng Zhou ◽  
Huai Wang ◽  
Lijun Fan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document