AbstractOptical measurement systems are an important part of the portfolio of 3D topography sensors. By precise, contactless and rapid measurements these sensors constitute an alternative to tactile instruments. In this contribution the principle of a laser interferometric distance sensor is presented, which in combination with lateral scan axes acts as a topography sensor and also as distance sensor for the compensation of vibrations in a coherence scanning Linnik interferometer. An advantage of this distance sensor is its high acquisition rate of height values, which in case of working as a topography sensor enables high scan velocities as it is demonstrated at a chirp standard measured with a scan velocity of 80 mm/s. This is much higher than the scan velocity of tactile instruments, which are typically limited up to 1 mm/s. In addition, the compensation of vibration disturbances demonstrates the capability of the fast distance measurement.In contrast to other existing high-speed point sensors the relevant components are mass products. This keeps the costs of the sensor setup in a limited range. Furthermore, the sensor shows potential of much higher measurement rates than 116 kHz provided by the sensor used here.
Nanofabrication on 2D and 3D Topography via Positive‐Tone Direct‐Write Laser Lithography
