Visible light dye degradation over fluorinated mesoporous TiO2−WO3−Bi2O3/SiO2 nanocomposite photocatalyst-adsorbent using immersion well reactor

2022 ◽  
pp. 113790
Author(s):  
Parham Haghighi ◽  
Somayeh Alijani ◽  
Amin Bazyari ◽  
Levi T. Thompson
Keyword(s):  
Visible Light ◽  
Dye Degradation ◽  
Mesoporous Tio2

Photo-catalytic Study of Malachite Green Dye Degradation Using Rice Straw Extracted Activated Carbon Supported ZnO Nano-particles

2020 ◽  
Vol 10 (6) ◽  
pp. 849-859
Author(s):  
Radwa A. El-Salamony ◽  
Abeer A. Emam ◽  
Nagwa A. Badawy ◽  
Sara F. El-Morsi
Keyword(s):  
Activated Carbon ◽  
Visible Light ◽  
Rice Straw ◽  
Malachite Green ◽  
Dye Degradation ◽  
Nano Particles ◽  
Oh Radicals ◽  
Impregnation Method ◽  
Photo Degradation ◽  
Malachite Green Dye

Objective: ZnO nanoparticles were synthesized using wet impregnation method, and activated carbon from rice straw (RS) prepared through chemical route. Methods: The nano-composites ZnO-AC series were prepared with different ZnO:AC ratio of 10, 20, 50, and 70% to optimize the zinc oxide nanoparticles used. The obtained composites were characterized by FE-SEM, XRD, SBET, and optical techniques then used for the photo-degradation of Malachite green dye (MG) under visible light. Results: It was found that 10ZnO-AC exhibited excellent visible light photo-catalytic performance. The ·OH radicals’ formation is matching with photo-activity of the prepared composites. The photo-degradation efficiency of MG increased from 63% to 93%, when the 10ZnO-AC photocatalyst amount was increased from 0.5 to 6 g/L. Conclusion: The GC-MS technique was used to analyze the intermediates formed; up to 15 kinds of chemicals were identified as the degradation products.

scholarly journals Enhanced Visible-Light Photocatalytic Performance of SAPO-5-Based g-C3N4 Composite for Rhodamine B (RhB) Degradation

Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3948
Author(s):  
Lingfang Qiu ◽  
Zhiwei Zhou ◽  
Mengfan Ma ◽  
Ping Li ◽  
Jinyong Lu ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Visible Light ◽  
Redox Reactions ◽  
Photocatalytic Performance ◽  
Dye Degradation ◽  
Thermal Polymerization ◽  
Light Illumination ◽  
Electron Hole ◽  
Visible Light Illumination ◽  
Visible Light Photocatalytic

Novel visible-light responded aluminosilicophosphate-5 (SAPO-5)/g-C3N4 composite has been easily constructed by thermal polymerization for the mixture of SAPO-5, NH4Cl, and dicyandiamide. The photocatalytic activity of SAPO-5/g-C3N4 is evaluated by degrading RhB (30 mg/L) under visible light illumination (λ > 420 nm). The effects of SAPO-5 incorporation proportion and initial RhB concentration on the photocatalytic performance have been discussed in detail. The optimized SAPO-5/g-C3N4 composite shows promising degradation efficiency which is 40.6% higher than that of pure g-C3N4. The degradation rate improves from 0.007 min−1 to 0.022 min−1, which is a comparable photocatalytic performance compared with other g-C3N4-based heterojunctions for dye degradation. The migration of photo-induced electrons from g-C3N4 to the Al site of SAPO-5 should promote the photo-induced electron-hole pairs separation rate of g-C3N4 efficiently. Furthermore, the redox reactions for RhB degradation occur on the photo-induced holes in the g-C3N4 and Al sites in SAPO-5, respectively. This achievement not only improves the photocatalytic activity of g-C3N4 efficiently, but also broadens the application of SAPOs in the photocatalytic field.

Efficient photocatalytic dye degradation by flowerlike MoS2/SrFe12O19 heterojunction under visible light

2021 ◽  
pp. 149855
Author(s):  
Sijing Chen ◽  
Yongjiang Di ◽  
Hang Li ◽  
Mengyu Wang ◽  
Bi Jia ◽  
...  
Keyword(s):  
Visible Light ◽  
Dye Degradation ◽  
Photocatalytic Dye Degradation
Sign in / Sign up

Export Citation Format

Share Document