Equivalent material modelling of sandwich beams, evanescent solutions and damping investigations

2016 ◽  
Vol 382 ◽  
pp. 291-309 ◽  
Author(s):  
Sophie de Rijk ◽  
Eugene Nijman
Keyword(s):  
Equivalent Material ◽  
Sandwich Beams ◽  
Material Modelling

Analysis of Interface Deformation of Steel-Concrete-Steel Sandwich Beam

2012 ◽  
Vol 525-526 ◽  
pp. 357-360
Author(s):  
Pei Xiu Xia ◽  
Guang Ping Zou ◽  
Zhong Liang Chang
Keyword(s):  
Sandwich Beam ◽  
Analytical Models ◽  
Sandwich Beams ◽  
Interface Deformation ◽  
Simply Supported ◽  
Interface Slip ◽  
Steel Panels ◽  
Uniformly Distributed Loads ◽  
Relationship Of ◽  
The Relationship

The effect of the interface slip is neglected in most studies on calculating deflection of sandwich beams. By taking a simply supported sandwich beams under uniformly distributed loads as an example, simplified analytical models of the interface slip are established, and corresponding clculation formulas of interface slip between steel panels and concrete and section curvatures are derived. The formula for deflection of sandwich beams are then presented. This formula reflects the relationship of influence each other between the interface slip and deflection.

Static and dynamic response of sandwich beams with lattice and pantographic cores

2021 ◽  
pp. 109963622110338
Author(s):  
Yury Solyaev ◽  
Arseniy Babaytsev ◽  
Anastasia Ustenko ◽  
Andrey Ripetskiy ◽  
Alexander Volkov
Keyword(s):  
Mechanical Performance ◽  
Lattice Structure ◽  
Unit Length ◽  
Experimental Tests ◽  
Plane Geometry ◽  
Sandwich Beams ◽  
Static Tests ◽  
Three Point Bending ◽  
The Core ◽  
The Impact

Mechanical performance of 3d-printed polyamide sandwich beams with different type of the lattice cores is investigated. Four variants of the beams are considered, which differ in the type of connections between the elements in the lattice structure of the core. We consider the pantographic-type lattices formed by the two families of inclined beams placed with small offset and connected by stiff joints (variant 1), by hinges (variant 2) and made without joints (variant 3). The fourth type of the core has the standard plane geometry formed by the intersected beams lying in the same plane (variant 4). Experimental tests were performed for the localized indentation loading according to the three-point bending scheme with small span-to-thickness ratio. From the experiments we found that the plane geometry of variant 4 has the highest rigidity and the highest load bearing capacity in the static tests. However, other three variants of the pantographic-type cores (1–3) demonstrate the better performance under the impact loading. The impact strength of such structures are in 3.5–5 times higher than those one of variant 4 with almost the same mass per unit length. This result is validated by using numerical simulations and explained by the decrease of the stress concentration and the stress state triaxiality and also by the delocalization effects that arise in the pantographic-type cores.

Sign in / Sign up

Export Citation Format

Share Document