Dye removal using waste beads: Efficient utilization of surface-modified chitosan beads generated after lead adsorption process

2019 ◽  
Vol 31 ◽  
pp. 100882 ◽  
Author(s):  
Preeti Pal ◽  
Anjali Pal
2012 ◽  
Vol 65 (4) ◽  
pp. 618-623 ◽  
Author(s):  
Reyna G. Sánchez-Duarte ◽  
Dalia I. Sánchez-Machado ◽  
Jaime López-Cervantes ◽  
Ma. A. Correa-Murrieta

The present study was designed to evaluate the chitosan, which has been obtained by deacetylation of chitin, as a biosorbent. The chitin was isolated from fermented shrimp waste by an important local industrial food biopolymer. The aim of this work was the characterization of chitosan and preparation of cross-linked chitosan- tripolyphosphate (chitosan-TPP) beads for the removal of allura red food dye from aqueous solutions. Conditions of batch adsorption such as pH, time and adsorbent dose were examined. The effectiveness of cross-linked chitosan beads for dye removal was found to be higher for pH 2 (98%, percentage of dye removal) and tends to decrease at pHs of 3 to 11 (up to 49%). The values of percentage removal show that the adsorption capacity increases with time of contact and dosage of chitosan-TPP, but red dye adsorption is mainly influenced by pH level. The cross-linked chitosan-TPP beads can significantly adsorb allura red monoazo dye from aqueous solutions even at acidic pHs unlike raw chitosan beads that tend to dissolve in acidic solutions. Consequently, this modified chitosan has characteristics that allow minimization of environmental pollution and widening the valorization of shrimp waste.


2020 ◽  
Vol 14 (1) ◽  
Author(s):  
'Aini Rahmadhaniar ◽  
Ratri Ariatmi Nugrahani ◽  
Nurul Fithriyah ◽  
Titik Lestariningsih

Lubricant waste is one of the hazardous refuses which are regulated on the limit of lead content according to Government Regulations (Kep-51/MenLH/10/1995). Therefore, it is necessary to research for reducing the lead content. The purpose of this study is to understand the effect of adding adsorbents to decrease lead content in waste of lubricants taken from ships. The waste lubricant was recycled by adsorption using zeolite. Lubricant waste samples of 200 mL each were physically and chemically identified subjected to adsorption process using zeolite adsorbent whose concentrations (%w/w) were varied as follows: 7.5%, 13.25%, 14.25%, 15.75% and 17.5% with stirring speed of 150 rpm and contact time for 60 minutes. The best results were obtained at the adsorbent amount of 26.5 grams (concentration of 13.25%), for which lead content reduction reached 83%. The ANOVA F was obtained to be 13.42, and hence the study concluded that the amount of the adsorbent was related to the decrease in lead content.A B S T R A KPelumas bekas adalah salah satu limbah berbahaya yang dibatasi kadar timbalnya dalam Peraturan Pemerintah, sehingga perlu penelitian untuk menurunkan kadar timbal. Tujuan penelitian ini adalah untuk memahami pengaruh penambahan adsorben untuk menurunkan kadar timbal dalam pelumas bekas yang berasal dari mesin kapal. Pelumas bekas didaur ulang dengan adsorpsi menggunakan zeolit. Setiap sampel berisi 200 mL pelumas bekas yang telah diidentifikasi sifat fisika dan kimia-nya diadsorpsi menggunakan adsorben zeolit. Variasi konsentrasi zeolit (%w/w) yang digunakan yaitu: 7,5%; 13,25%; 14,25%; 15,75% dan 17,5% dengan kecepatan pengadukan 150 rpm dan waktu kontak 60 menit. Hasil terbaik diperoleh pada jumlah adsorben 26,5 g (konsentrasi 13,25%) dengan penurunan kadar timbal mencapai 83%. Faktor F pada hasil ANOVA adalah 13,42. Dengan demikian dapat disimpulkan bahwa terdapat korelasi antara konsentrasi adsorben dan penurunan kadar timbal.


2016 ◽  
Vol 86 ◽  
pp. 562-569 ◽  
Author(s):  
Bingjie Liu ◽  
Wei Chen ◽  
Xiaoning Peng ◽  
Qiqi Cao ◽  
Qianrui Wang ◽  
...  

2008 ◽  
Vol 47 (22) ◽  
pp. 8796-8800 ◽  
Author(s):  
Dan Xu ◽  
San Hein ◽  
Sunsun Leslie Loo ◽  
Kean Wang
Keyword(s):  

Author(s):  
Bruna Assis Paim dos Santos ◽  
Aline Silva Cossolin ◽  
Hélen Cristina Oliveira dos Reis ◽  
Ketinny Camargo de Castro ◽  
Evanleide Rodrigues da Silva ◽  
...  

In this study, baker’s yeast-MnO2 composites, produced by direct oxidation of yeast with KMnO4 under acidic conditions, were used as biosorbent to remove the triphenylmethane dye Malachite green (MG) from an aqueous solution. Parameters that influence the adsorption process, such as pH, contact time, temperature, initial dye concentration and biosorbent dosage, were evaluated in batch experiments. The optimum removal of MG was found to be  86.7 mg g-1 at pH 10, 1.0 g L-1 of biomass dosage and 45°C. The kinetic data of dye removal was better described by the pseudo-second-order model. The adsorption process followed the Langmuir isotherm model and the maximum biosorption capacity was estimated to be  243.9 mg g-1 (at 25°C). The negative values of ∆G° and the positive value of ∆H° indicated that the MG biosorption onto yeast-MnO2 composites is spontaneous and endothermic. Fourier transform infrared spectroscopy (FTIR) indicated that the nano-MnO2 particles deposited on yeast-MnO2 composites surface facilitated the MG adsorption. It was concluded that baker’s yeast-MnO2 composites have potential for application as adsorbent for removal of MG from aqueous solution.


2014 ◽  
Vol 131 (23) ◽  
pp. n/a-n/a ◽  
Author(s):  
Yikai Yan ◽  
Bo Xiang ◽  
Xiaowei Yi ◽  
Yijiu Li ◽  
Qian Jia

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Mashael Alshabanat ◽  
Ghadah Alsenani ◽  
Rasmiah Almufarij

The adsorption of crystal violet (CV) onto date palm fibers (DPFs) was examined in aqueous solution at 25°C. The experimental maximum adsorption capacity value was0.66×10−6. Langmuir, Freundlich, Elovich and Temkin models were applied to describe the equilibrium isotherms. The influence of pH and temperature on dye removal was evaluated. The percentage removal of CV dye by adsorption onto DPF at different pH and temperatures showed that these factors play a role in the adsorption process. Thermodynamic analysis was performed, and the Gibbs free energyΔGο, enthalpy changeΔHο, and entropyΔSοwere calculated. The negative values ofΔGοindicate spontaneous adsorption. The negative value ofΔHοindicates that the interaction between CV and DPF is exothermic, and the positive value ofΔSοindicates good affinity between DPF and CV. The kinetic data were fitted to a pseudo-second-order model.


2011 ◽  
Vol 83 (3) ◽  
pp. 1082-1087 ◽  
Author(s):  
Muniyappan Rajiv Gandhi ◽  
G.N. Kousalya ◽  
Natrayasamy Viswanathan ◽  
S. Meenakshi

Sign in / Sign up

Export Citation Format

Share Document