Comminution and liberation response of iron ore types in a low-grade deposit

2020 ◽  
Vol 158 ◽  
pp. 106590
Author(s):  
José R.O. França ◽  
Gabriel K.P. Barrios ◽  
Henrique D.G. Turrer ◽  
Luís Marcelo Tavares
Keyword(s):  
Iron Ore ◽  
Low Grade ◽  
Ore Types

Mineralogical studies of low grade iron ore from Bellary-Hospet region, India

2019 ◽  
Author(s):  
Mohanraj G. T. ◽  
Krishneindu P. ◽  
R. P. Choudhary ◽  
Sher Singh Meena ◽  
S. M. Yusuf ◽  
...  
Keyword(s):  
Iron Ore ◽  
Low Grade

scholarly journals Critical importance of pH and collector type on the flotation of sphalerite and galena from a low-grade lead–zinc ore

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Abdolrahim Foroutan ◽  
Majid Abbas Zadeh Haji Abadi ◽  
Yaser Kianinia ◽  
Mahdi Ghadiri
Keyword(s):  
Iron Ore ◽  
Low Grade ◽  
Zinc Recovery ◽  
Flotation Process ◽  
Ph Values ◽  
Lead And Zinc ◽  
Optimum Ph ◽  
Iron And Zinc ◽  
Lead Zinc ◽  
Zinc Concentrate

AbstractCollector type and pulp pH play an important role in the lead–zinc ore flotation process. In the current study, the effect of pulp pH and the collector type parameters on the galena and sphalerite flotation from a complex lead–zinc–iron ore was investigated. The ethyl xanthate and Aero 3418 collectors were used for lead flotation and Aero 3477 and amyl xanthate for zinc flotation. It was found that maximum lead grade could be achieved by using Aero 3418 as collector at pH 8. Also, iron and zinc recoveries and grades were increased in the lead concentrate at lower pH which caused zinc recovery reduction in the zinc concentrate and decrease the lead grade concentrate. Furthermore, the results showed that the maximum zinc grade and recovery of 42.9% and 76.7% were achieved at pH 6 in the presence of Aero 3477 as collector. For both collectors at pH 5, Zinc recovery was increased around 2–3%; however, the iron recovery was also increased at this pH which reduced the zinc concentrate quality. Finally, pH 8 and pH 6 were selected as optimum pH values for lead and zinc flotation circuits, respectively.

scholarly journals Beneficiation of low-grade, goethite-rich iron ore using microwave-assisted magnetizing roasting

2021 ◽  
Vol 166 ◽  
pp. 106826
Author(s):  
V. Nunna ◽  
S. Hapugoda ◽  
M.I. Pownceby ◽  
G.J. Sparrow
Keyword(s):  
Iron Ore ◽  
Low Grade ◽  
Microwave Assisted ◽  
Magnetizing Roasting

Carbon Doped Iron Ore Using Palm Kernel Shell

2013 ◽  
Vol 701 ◽  
pp. 28-31 ◽  
Author(s):  
Rusila Zamani Abd Rashid ◽  
Hadi Purwanto ◽  
Hamzah Mohd Salleh ◽  
Mohd Hanafi Ani ◽  
Nurul Azhani Yunus ◽  
...  
Keyword(s):  
Iron Ore ◽  
Palm Kernel ◽  
Reduction Process ◽  
Attractive Alternative ◽  
Low Grade ◽  
Iron Ores ◽  
Solid Carbon ◽  
Green Composite ◽  
Biomass Waste ◽  
Palm Kernel Shell

This paper pertains to the reduction process of local low grade iron ore using palm kernel shell (PKS). It is well known that low grade iron ores contain high amount of gangue minerals and combined water. Biomass waste (aka agro-residues) from the palm oil industry is an attractive alternative fuel to replace coal as the source of energy in mineral processing, including for the treatment and processing of low grade iron ores. Both iron ore and PKS were mixed with minute addition of distilled water and then fabricated with average spherical diameter of 10-12mm. The green composite pellets were subjected to reduction test using an electric tube furnace. The rate of reduction increased as temperature increases up to 900 °C. The Fe content in the original ore increased almost 12% when 40 mass% of PKS was used. The reduction of 60:40 mass ratios of iron ore to PKS composite pellet produced almost 11.97 mass% of solid carbon which was dispersed uniformly on the surface of iron oxide. The aim of this work is to study carbon deposition of PKS in iron ore through reduction process. Utilization of carbon deposited in low grade iron ore is an interesting method for iron making process as this solid carbon can act as energy source in the reduction process.

Research on Exploration of Mineral Processing for a Iron Ore

2015 ◽  
Vol 1094 ◽  
pp. 397-400
Author(s):  
Xian Xie ◽  
Zi Xuan Yang ◽  
Xiong Tong ◽  
Ji Yong Li
Keyword(s):  
Magnetic Separation ◽  
Calcium Oxide ◽  
Iron Ore ◽  
Mineral Processing ◽  
Low Grade ◽  
Iron Minerals ◽  
Iron Mineral ◽  
Ore Minerals ◽  
Separation Test

Iron ore minerals are mainly silicate-type iron minerals in raw ore, and its distribution rate was 51.93%; followed by magnetic iron, and its distribution rate was 36.81%; content and distribution rate of other minerals was very low; element grade of iron, phosphorus, sulfur, silica were 11.90%, 0.043%, 0.013% and 45.23%, the main gangue were silica and calcium oxide, recyclable iron minerals mainly is magnetic iron mineral. Due to the grade of iron of raw ore and the amounts of optional magnetite was relatively little, in order to investigate the optional of low-grade ore, weak magnetic separation test and weak magnetic separation tailings-strong magnetic separation test were put into effect.

Induration of Indian Low Grade Iron Ore Pellets in a Pilot Heat Hardening System

2021 ◽  
pp. 1-8
Author(s):  
G. M. Chowdhury ◽  
S. Sudhir ◽  
R. K. Ram ◽  
S. Dhara ◽  
A. Mallick
Keyword(s):  
Iron Ore ◽  
Low Grade ◽  
Iron Ore Pellets ◽  
Ore Pellets ◽  
Heat Hardening ◽  
Hardening System
Sign in / Sign up

Export Citation Format

Share Document