Efficient uptake of NH3 by dual active sites NH4SCN-imidazole deep eutectic solvents with low viscosity

2021 ◽  
pp. 116724
Author(s):  
Ke Li ◽  
Hao Fang ◽  
Xiuzhi Duan ◽  
Dongshun Deng
2020 ◽  
Vol 56 (16) ◽  
pp. 2399-2402 ◽  
Author(s):  
Wen-Jing Jiang ◽  
Fu-Yu Zhong ◽  
Lin-Sen Zhou ◽  
Hai-Long Peng ◽  
Jie-Ping Fan ◽  
...  

It is found that ethylamine hydrochloride (EaCl) and phenol (PhOH) can form a new type of deep eutectic solvent (DES) with quite low viscosity, and two active sites for chemical absorption of NH3.


ChemSusChem ◽  
2017 ◽  
Vol 10 (17) ◽  
pp. 3279-3279
Author(s):  
Yuhui Li ◽  
Mohammad Chand Ali ◽  
Qiwei Yang ◽  
Zhiguo Zhang ◽  
Zongbi Bao ◽  
...  

2019 ◽  
Vol 64 (7) ◽  
pp. 3068-3077 ◽  
Author(s):  
Luhong Zhang ◽  
Haopeng Ma ◽  
Guangsen Wei ◽  
Bin Jiang ◽  
Yongli Sun ◽  
...  

1960 ◽  
Vol 33 (3) ◽  
pp. 696-698
Author(s):  
S. E. Bresler ◽  
M. I. Mosevitskiĭ

Abstract For the study of the mechanism of polymerization by means of complexes of aluminum organic compounds with titanium chlorides, data on the kinetics of polymerization is of great interest. Up to the present time, the rate of polymerization of propylene has been studied but the interpretation of the kinetic data is difficult because the polymer, which is practically insoluble in the reaction medium, entraps the catalyst resulting in a rate of reaction which is dependent on the diffusion of monomer through the polymer to the active sites. In this work the polymerization of isoprene, which yields polymers soluble in the monomer, in saturated hydrocarbons and in benzene, was studied. The rate of the polymerization reaction was measured by the thermal effect in a calorimeter consisting of a 3.5 1. Dewar flask, with a lid, immersed in a thermostated air bath maintained at approximately the temperature of the reaction. Low viscosity spindle oil, heated to the temperature of the reaction (about 32°), served as the calorimeter fluid. The ampoule holder extended outside of the calorimeter and was connected to a shaking apparatus. The ampoule was divided by a thin partition into two sections each holding 45–50 cc. Into one section previously purified monomers and solvent were distilled. The other section was filled with catalyst components from a Shlenk container. The change in temperature of the calorimeter was determined with a Beckman thermometer with an accuracy of 0.01 °. When the temperature of the calorimeter containing the ampoule remained constant to within 0.01–0.02° for 30–40 minutes, the shaking apparatus was connected and the partition was broken with a striker. Intensive shaking was continued during the entire experiment resulting in mixing of the reaction mixture and of the calorimeter fluid. The rate of reaction was determined by the rate of heat evolution ; in other words, by the temperature rise in the calorimeter. For a rise of 0.1–0.5° the reaction conditions remained practically isothermal. This rise permits the kinetics of the reaction to be observed with sufficient accuracy. Adiabaticity of the calorimeter and the effect of mechanical heat were controlled in separate experiments.


Author(s):  
Ping Liu ◽  
Kaixing Cai ◽  
Tianxiang Zhao ◽  
Xiaomin Zhang

In view of the environmental hazards caused by SO2, the development of efficient SO2 capture technology has important practical significance. In this work, a low viscosity protic ionic liquids containing imidazole, ether linkage, and tertiary amine structure, was synthesized by acid-base neutralization of tris(3,6-dioxaheptyl)amine (TMEA) and imidazole (Im) for SO2 absorption. The results showed that the solubility of SO2 in [TMEA][Im] reached 12.754 mol·kg-1 at 298.2 K and 100 kPa and the ideal selectivity of SO2/CO2(1/1) and SO2/H2S(1/1) are 141.6 and 11.8 at 100 kPa, respectively. Furthermore, [TMEA][Im] can be reused and the SO2 absorption performance was not significantly reduced after five cycles. In addition, the absorption of low-concentration SO2 (2000 ppm) in [TMEA][Im] was also tested. Further spectroscopic research and thermodynamic analysis suggested that the high SO2 uptake by [TMEA][Im] was caused by the synergistic effect of physical and chemical absorption.


Author(s):  
Yanning Cao ◽  
Jiayin Zhang ◽  
Yongde Ma ◽  
Wenquan Wu ◽  
Kuan Huang ◽  
...  

ChemSusChem ◽  
2017 ◽  
Vol 10 (17) ◽  
pp. 3368-3377 ◽  
Author(s):  
Yuhui Li ◽  
Mohammad Chand Ali ◽  
Qiwei Yang ◽  
Zhiguo Zhang ◽  
Zongbi Bao ◽  
...  

2021 ◽  
pp. 103512
Author(s):  
Chen Fan ◽  
Lijiao Wen ◽  
Yuhang Shan ◽  
Yuwei Shan ◽  
Xueli Cao

Catalysts ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 853
Author(s):  
Laura V. Hoyos ◽  
Laura Ramírez ◽  
Cristhian J. Yarce ◽  
Carlos Alvarez-Vasco ◽  
Nelson H. Caicedo Ortega

Glycolipids have become an ecofriendly alternative to chemically obtained surfactants, mainly for the cosmetic, pharmaceutical, and food industries. However, the sustainable production of these compounds is still challenging, because: (i) water is a recognized inhibitor, (ii) multiphases make the use of cosolvent reaction medium necessary, and (iii) there are difficulties in finding a source for both starting materials. This study used sugars and lipids from peach palm fruit shells or model compounds as substrates to synthesize glycolipids on five different renewable deep eutectic solvents (Re-DES) alone or with a cosolvent system. Substrate conversions up to 24.84% (so far, the highest reported for this reaction on DES), showing (1) the non-precipitation of glucose in the solvent, (2) emulsification and (3) low viscosity (e.g., more favorable mass transfer) as the main limiting factors for these heterogeneous enzymatic processes. The resulting conversion was reached using a cosolvent system Re-DES:DMSO:t-butanol that was robust enough to allow conversions in the range 19–25%, using either model compounds or sugar and fatty acid extracts, with free or immobilized enzymes. Finally, the characterization of the in-house synthesized glycolipids by surface tension demonstrated their potential as biosurfactants, for instance, as an alternative to alcohol ethoxylates, industrially produced using less sustainable methods.


Sign in / Sign up

Export Citation Format

Share Document