Determination of Coordination Form of Tungsten Ion in Molten Alkali Chloride by Electrochemical Method

2021 ◽  
pp. 117062
Author(s):  
Ming Feng ◽  
Li-wen Zhang ◽  
Xiao-li Xi ◽  
Zuo-ren Nie
Keyword(s):  
Electrochemical Method ◽  
Alkali Chloride

Development of a microchip-pulsed electrochemical method for rapid determination of L-DOPA and tyrosine inMucuna pruriens

2013 ◽  
Vol 36 (9-10) ◽  
pp. 1590-1596 ◽  
Author(s):  
Xinchun Li ◽  
Zuanguang Chen ◽  
Fan Yang ◽  
Jianbin Pan ◽  
Yinbao Li
Keyword(s):  
Electrochemical Method ◽  
Rapid Determination

scholarly journals First Electrochemical Method of Nitrothal-Isopropyl Determination in Water Samples

2016 ◽  
Vol 2016 ◽  
pp. 1-6 ◽  
Author(s):  
Dariusz Guziejewski ◽  
Agnieszka Nosal-Wiercińska ◽  
Sławomira Skrzypek ◽  
Witold Ciesielski ◽  
Sylwia Smarzewska
Keyword(s):  
Environmental Samples ◽  
Electrochemical Method ◽  
Concentration Level ◽  
Stripping Voltammetry ◽  
Adsorptive Stripping Voltammetry ◽  
Hanging Mercury Drop Electrode ◽  
Optimal Conditions ◽  
Step Potential ◽  
Accumulation Time

The aim of the research was the use of square wave adsorptive stripping voltammetry (SWAdSV) in conjunction with a hanging mercury drop electrode (HMDE) for the determination of nitrothal-isopropyl. It was found that optimal SW technique parameters were frequency, 200 Hz; amplitude, 50 mV; and step potential, 5 mV. Accumulation time and potential were studied to select the optimal conditions in adsorptive stripping voltammetry: 45 s at 0.0 V, respectively. The calibration curve (SWSV) was linear in the nitrothal-isopropyl concentration range from 2.0 × 10−7 to 2.0 × 10−6 mol L−1 with detection limit of 3.46 × 10−8 mol L−1. The repeatability of the method was determined at a nitrothal-isopropyl concentration level equal to 6.0 × 10−7 mol L−1 and expressed as RSD = 5.5% (n=6). The proposed method was successfully validated by studying the recovery of nitrothal-isopropyl in spiked environmental samples.

scholarly journals Corrosion Resistance of Fiber-reinforced Geopolymer Structural Concrete in a Simulated Marine Environment

2021 ◽  
Author(s):  
Khaled Sobhan ◽  
Francisco Martinez ◽  
D.V. Reddy
Keyword(s):  
Corrosion Resistance ◽  
Marine Environment ◽  
Electrochemical Method ◽  
Ordinary Portland Cement ◽  
Load Capacity ◽  
Fiber Reinforced ◽  
Structural Concrete ◽  
Accelerated Corrosion ◽  
Damaged Beams

The corrosion resistance of fly ash-based geopolymer structural concrete (GPC), with or without fibers, was investigated in a simulated marine environment, and compared with that of ordinary Portland cement structural concrete. The corrosion behavior is studied through an electrochemical method for inducing accelerated corrosion. The fiber-reinforced specimens contained polyolefin fibers in the amounts of 0.1%, 0.3%, and 0.5% by volume. Several artificial corrosion conduits were introduced into the specimens reaching up to the rebars. This process enhanced the rate of laboratory corrosion in GPC. The corrosion-damaged beams were then analyzed through a method of crack scoring, and determination of steel mass loss and residual flexural load capacity. The fiber-reinforced corroded GPC beams showed a 24% reduction in crack scores, and a 109% increase in residual flexural load capacity, compared to unreinforced corroded GPC beams. This shows promise of fiber-reinforced GPC as a sustainable structural material in the marine environment.

scholarly journals Linear sweep polarographic determination of nucleic acids using acridine orange as a bioprobe

2007 ◽  
Vol 72 (11) ◽  
pp. 1085-1094 ◽  
Author(s):  
Wei Sun ◽  
Na Zhao ◽  
Xianlong Yuan ◽  
Kui Jiao
Keyword(s):  
Aqueous Solution ◽  
Acridine Orange ◽  
Electrochemical Method ◽  
Electrochemical Determination ◽  
Determination Method ◽  
Linear Regression Equation ◽  
Peak Potential ◽  
Linear Sweep ◽  
Buffer Solution

The interaction of acridine orange (AO) with double-stranded (ds) DNA in aqueous solution was investigated by linear sweep polarography (LSP) on a dropping mercury working electrode (DME). In pH 2.5 Britton-Robinson (B-R) buffer solution, AO had a sensitive linear sweep polarographic reductive peak at -0.89 V (vs. SCE), which could be greatly inhibited by the addition of dsDNA, with a positive shift of the peak potential. Based on the decrease of the reductive peak current, a new quantitative electrochemical determination method for dsDNA was developed with a linear range of 2.0?20.0 mg l-1 and the linear regression equation: ?Ip" (nA) = 111.90 C (mg l-1)+125.32 (n = 9, ? = 0.997). The influences of commonly co-existing substances, such as metal ions, amino acid, etc., on the determination were also investigated. The method is sensitive, rapid and simple with good selectivity. The new proposed method was further applied to the detection of RNA and three synthetic samples containing dsDNA with satisfactory results. The binding number and the equilibrium constant between dsDNA and AO were calculated by an electrochemical method.

scholarly journals A FAST, ROBUST ELECTROCHEMICAL METHOD FOR THE AUTOMATED DETERMINATION OF HYDROGEN PEROXIDE

2009 ◽  
Vol 54 (4) ◽  
Author(s):  
IVANILDO LUIZ DE MATTOS ◽  
MARCOS CAROLI ◽  
MADALENA AREIAS ◽  
MARCELO NAVARRO
Keyword(s):  
Hydrogen Peroxide ◽  
Electrochemical Method ◽  
Automated Determination

A sensitive electrochemical method for the determination of 5-hydroxytryptophan in rats' brain tissue based on a carbon nanosheets-modified electrode

2015 ◽  
Vol 7 (5) ◽  
pp. 1971-1976 ◽  
Author(s):  
Yahong Chen ◽  
Gongke Li ◽  
Yufei Hu
Keyword(s):  
Brain Tissue ◽  
Modified Electrode ◽  
Electrochemical Method ◽  
Carbon Nanosheets

In this paper, a novel electrochemical method is proposed for the determination of 5-hydroxytryptophan (5-HTP) based on a carbon nanosheets (CNSs)-modified electrode.

Sign in / Sign up

Export Citation Format

Share Document